FORD SIERRA 1986 1.G Body Electrical System Workshop Manual

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual SIERRA 1986 1.G FORD FORD https://www.carmanualsonline.info/img/11/5450/w960_5450-0.png FORD SIERRA 1986 1.G Body Electrical System Workshop Manual
Trending: bulb, fog light, headlamp, low beam, steering wheel, checking oil, brake fluid

Page 1 of 25

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual Chapter 13
Body electrical system
Anti-theft alarm - location, removal and refitting  . . . . . . . . . . . . . . . .51
Auxiliary warning system components - location, testing, removal and
refitting

Page 2 of 25

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual System type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12 volt, negative earth
BulbsFittingsWattage
Halogen headlamps . . . . . . . . . . . . . . . . . . . .

Page 3 of 25

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual 5To find the source of an intermittent wiring
fault (usually due to a poor or dirty
connection, or damaged wiring insulation), an
integrity test can be performed on the wiring,
which involves moving t

Page 4 of 25

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual Removal
1Disconnect the battery negative lead.
2For improved access, remove the securing
screws and unclip the lower and upper
steering column shrouds.
3Insert the ignition key and turn to position
�

Page 5 of 25

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual 13Refitting is a reversal of removal, but note
that the wiring plug can only be fitted in one
position, and ensure that the joystick
assembly locating lug engages in the
corresponding hole in the faci

Page 6 of 25

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual 7Unclip the switch from the lock assembly,
disconnect the wiring plug and remove the
switch.
8Refitting is a reversal of removal.
1Disconnect the battery negative lead.
2Working inside the vehicle, re

Page 7 of 25

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual Models up to 1992
1Disconnect the battery negative lead.
2Remove the securing screws and unclip the
lower and upper steering column shrouds.
3Where applicable, remove the instrument
panel illumination

Page 8 of 25

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual Speedometer
12Remove the panel lens (paras. 5 and 6).
13Remove the two screws securing the
speedometer to the rear of the instrument
panel, taking care not to lose the two brushes.
Withdraw the speedo

Page 9 of 25

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual Location
1The AWS control unit, and (when fitted) the
bulb failure monitor, are located behind the
glovebox on models up to 1987.
2On models from 1987, the control and bulb
failure modules are located

Page 10 of 25

FORD SIERRA 1986 1.G Body Electrical System Workshop Manual dipstick from its tube and disconnect the
wiring plug.
31Refitting is a reversal of removal.
1Remove the instrument panel.
2Unclip the direction indicator relay from the
steering column support bracke
Page:   1-10 11-20 21-30 next >
Trending: battery, lug pattern, coolant reservoir, roof rack, tow bar, fuel tank removal, instrument panel