FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide SIERRA 1988 2.G FORD FORD https://www.carmanualsonline.info/img/11/5461/w960_5461-0.png FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide
Trending: check engine, coolant level, check oil, cooling, wipers, oil capacities, transmission fluid

Page 11 of 22

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide 4Carefully check the condition of all coolant,
fuel, power steering and brake hoses. Renew
any hose which is cracked, swollen or
deteriorated. Cracks will show up better if the
hose is squeezed. Pay c

Page 12 of 22

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide Pierburg 2V carburettor
9Proceed as described for the Ford VV
carburettor.  For adjustment screw location
(see illustration).
Weber 2V TLD carburettor 
10Proceed as described for the Ford VV
carburett

Page 13 of 22

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide 25Start the engine and run it at 3000 rpm for
15 seconds, ensuring that all electrical loads
(headlamps, heater blower etc) are switched
off, then allow the engine to idle and check
the CO content. No

Page 14 of 22

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide 3Wipe clean around the filler/level plug.
Unscrew the plug and remove it(see
illustration).
4Using a suitably marked piece of bent wire
as a dipstick, check that the oil level is as
shown in the table

Page 15 of 22

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide 8Tighten the alternator mounting and
adjustment nuts and bolts in the order shown
(see illustration).
9Where applicable, refit and tension the air
conditioning compressor drivebelt.
10Reconnect the ba

Page 16 of 22

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide 5Numbering from the front (camshaft
sprocket) end of the engine, the exhaust
valves are 1, 3, 5 and 7, and the inlet valves
are 2, 4, 6 and 8. 
6Turn the engine clockwise using a suitable
socket on th

Page 17 of 22

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide system immediately if the charge is low and
do not use it again until it has been recharged.
4Inspect the refrigerant pipes, hoses and
unions for security and good condition. Refit
the radiator grille

Page 18 of 22

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide Steering and suspension
3Check for any abnormalities in the steering,
suspension, handling or road “feel”.
4Drive the vehicle, and check that there are
no unusual vibrations or noises.
5Check that

Page 19 of 22

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide CVH carburettor models
7To test the unit the engine must initially be
cold. Disconnect the hot air inlet hose from
the air cleaner spout and observe the position
of the flap which should be fully open

Page 20 of 22

FORD SIERRA 1988 2.G Routine Manintenance And Servicing User Guide 13Reconnect the battery negative lead.
2.0 litre DOHC models
14Disconnect the battery negative lead.
15Disconnect the wiring plug from the idle
speed control valve at the front of the plenum
chamber.
Page:   < prev 1-10 11-20 21-30 next >
Trending: coolant level, suspension, gearbox, brake, seat adjustment, ECO mode, steering wheel