washer fluid FORD SIERRA 1993 2.G Braking System Workshop Manual

FORD SIERRA 1993 2.G Braking System Workshop Manual SIERRA 1993 2.G FORD FORD https://www.carmanualsonline.info/img/11/5452/w960_5452-0.png FORD SIERRA 1993 2.G Braking System Workshop Manual

Page 10 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual Note: Complete dismantling of the rear caliper
should not be attempted unless Ford spring
compressor (tool No 12-007) is available, or
unless the problems likely to arise in the
absence of the tool ar

Page 11 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual 15A long thin pair of circlip pliers will now be
required to release the key plate retaining
circlip from the caliper bore (see illustration).
With the circlip removed, the pushrod and key
plate can b

Page 12 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual Specifications. To do this, fix the measuring
equipment, and rotate the disc, noting the
variation in measurement as the disc is
rotated. The difference between the minimum
and maximum measurements re

Page 13 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual 3Remove the wheel cylinder.
4Remove the driveshaft but do not refit the
securing bolts to the backplate.
5Remove the backplate.
6If required, prise out the handbrake stop
button.
7Refitting is a rever

Page 14 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual 4Unscrew the two mounting nuts and spring
washers, and withdraw the master cylinder
from the servo. Cover the master cylinder with
rag or a plastic bag to prevent spillage of
hydraulic fluid on the ve

Page 16 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual 7Remove the clip from the hydraulic unit
pushrod on the brake pedal. 
8With an assistant supporting the hydraulic
unit, unscrew the four nuts which secure the
unit to the bulkhead (see illustration).

Page 17 of 22

FORD SIERRA 1993 2.G Braking System Workshop Manual Refitting
9Commence refitting by offering the pump to
the mounting spigot, then reconnecting the
low pressure fluid hose.
10Refit and tighten the pump mounting bolt.
11Reconnect the high pressure flui