brake rotor FORD SUPER DUTY 2013 3.G Diesel Supplement Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 2013, Model line: SUPER DUTY, Model: FORD SUPER DUTY 2013 3.GPages: 95, PDF Size: 2.42 MB
Page 77 of 95
Normal Scheduled Maintenance1
At every oil change
interval as indicated
by the information
displayChange engine oil and filter.2
Refill diesel exhaust fluid tank.
Rotate tires3, inspect tire wear and measure tread
depth.
Perform multi-point inspection (recommended).
Inspect air filter restriction gauge. Replace filter if
necessary.
Inspect automatic transmission fluid level.
Inspect brake pads, shoes, rotors, drums, brake
linings, hoses and parking brake.
Inspect engine and secondary coolant level and
hoses.
Inspect exhaust system and heat shields.
Inspect front axle and U-joints. Lubricate if equipped
with grease fittings (4WD vehicles).
Inspect steering linkage, ball joints, suspension,
tie-rod ends, driveshaft and U-joints. Lubricate if
equipped with grease fittings.
Inspect wheels and related components for abnormal
noise, wear, looseness or drag.
1Do not exceed one year or 10000 miles (16000 kilometers) between
service intervals.
2Reset your Intelligent Oil-Life Monitor® after each engine oil and filter
change. See theInformation Displaychapter of yourOwner’s Manual.
3Vehicles equipped with dual rear wheels should rotate the front wheels
when specified; rear wheels only if unusual wear is noted.
Additional Maintenance Items1
Every 15000 miles
(24000 km)Inspect engine and secondary cooling system
concentration (freeze-point protection), additive
(corrosion inhibitor) strength, coolant level and
hoses.
2
Every 22500 miles
(36000 km)Replace engine- and frame-mounted fuel filters.3
Scheduled Maintenance
76
2013 Diesel(67l)
Supplement, 1st Printing
USA(fus)
Page 87 of 95
Off-road Operation
As requiredExhaust Tips:Inspect functional holes in
each leg of the twin tip and the holes under
the shield just inboard of the right rear tire to
make sure they are kept clean/clear of debris
or foreign materials. Refer to theVehicle Care
chapter for more information.
Inspect steering and suspension ball joints and
tie rods. Lubricate if equipped with grease
fittings.
Every 7500 miles
(12000 km)Rotate tires
*, inspect tires for wear and
measure tread depth and inspect wheel ends
for endplay and noise.
Inspect brake system pads and rotors.
Inspect engine air filter restriction gauge.
Replace filter if necessary.
Every 7500 miles
(12000 km) or 300
engine hoursChange engine oil and filter.
**
Inspect and lubricate U-joints.
Every 15000 miles
(24000 km), six
months, 600 engine
hours or as indicated
by the information
displayReplace engine- and frame-mounted fuel
filters.
Every 30000 miles
(48000 km)Replace air inlet foam filter.
Replace wheel bearing grease and grease seals
if non-sealed bearings are used (2WD
vehicles).
Every 50000 miles
(80000 km)Change rear axle fluid (if equipped with a
Dana rear axle - some F-350s, all F-450/550s).
Change transfer case fluid (4WD vehicles).
Inspect front axle fluid (4WD vehicles).
*Vehicles equipped with dual rear wheels should rotate the front wheels
when specified; rear wheels only if unusual wear is noted.
**Reset your Intelligent Oil-Life Monitor® after each engine oil and filter
change. See theInformation Displaychapter of theOwner’s Manual.
Scheduled Maintenance
86
2013 Diesel(67l)
Supplement, 1st Printing
USA(fus)
Page 88 of 95
Operating in Dusty Conditions (i.e. Unpaved or Dusty Roads)
Every 7500 miles
(12000 km)Rotate tires*, inspect tires for wear and
measure tread depth and inspect wheel ends
for endplay and noise.
Inspect brake system pads and rotors.
Inspect engine air filter restriction gauge;
replace filter as indicated by gauge.
Inspect steering and suspension ball joints and
tie rods. Lubricate if equipped with grease
fittings.
Every 7500 miles
(12000 km), six
months or 300 engine
hoursChange engine oil and filter.
**
Inspect and lubricate U-joints.
Every 15000 miles
(24000 km), six
months, 600 engine
hours or as indicated
by the information
displayReplace engine- and frame-mounted fuel
filters.
Every 30000 miles
(48000 km)Replace air inlet foam filter.
Replace wheel bearing grease and grease seals
if non-sealed bearings are used (2WD
vehicles).
*Vehicles equipped with dual rear wheels should rotate the front wheels
when specified; rear wheels only if unusual wear is noted.
**Reset your Intelligent Oil-Life Monitor® after each engine oil and filter
change. See theInformation Displaychapter of theOwner’s Manual.
Scheduled Maintenance
87
2013 Diesel(67l)
Supplement, 1st Printing
USA(fus)