sensor GENESIS G90 2023 Owner's Manual

5-31
05
Limitations of the System

[Fingerprint Authentication system
may not work when:
- Fingerprint authentication is
performed with an unregistered
fingerprint.
- The fingerprint is not placed on the
center of the fingerprint sensor.
- The fingerprint sensor or fingerprint
is wet or dirty.
- The film on the sensor is not
removed.
- The registered fingerprint is
wounded or swollen.
- The hand is overly dry.
- The sensor is touched shortly.

[If fingerprint authentication fails
repeatedly, fingerprint recognition is
temporarily restricted. You should try
it later or try other methods such as
inputting your password.

[All registered fingerprints may
be deleted during repair due to
a malfunction of the fingerprint
authentication system or related
parts. Have your smart key when you
visit an authorized retailer of Genesis
Branded products.

[You cannot use the fingerprint sensor
when the vehicle is discharged.

[Gently place your finger on the
fingerprint sensor. Fingerprint
authentication attempts with
excessive force may fail.
WARNING
Do not register children’s fingerprints in
the vehicle.
If you register children’s fingerprints
and leave them in the vehicle,
unexpected accidents may occur.
When purchasing a used vehicle
If you purchase a used vehicle, you
should confirm and delete all of the
registered fingerprints in Driver 1 and
Driver 2 profile.

5-34
Convenience Features
WARNING
Be careful not to get your fingers or
body caught between the door and
vehicle body when opening or closing
the door. It may lead to injury.
CAUTION

[The door might open again if not
properly closed.

[Do not leave the vehicle unlocked
for a long time. The battery may
discharge, and you will not be able
to open the other doors except the
driver’s door.

[Do not leave the mechanical key in
the vehicle. You will not be able to
open the doors in an emergency.
NOTICE

[The door handle may freeze during
winter. Tap the door handle lightly
or use other methods to warm the
KDQGOHDQGUHPRYHWKHLFH)RUPRUH
details, refer to “Removing Ice from
Door Handle” section in this chapter.

[Do not apply excessive force on the
door handle or use sharp tools to pop
out the door handle. It may damage
the door handle.
Information

[When the battery level is low, the
driver’s door will automatically shift to
emergency mode. If you pull the door
handle, you may hear a click noise.
This is a normal sound due to motor
operation.

[When the door handles do not operate
properly due to battery discharge or
other causes, you can manually pop
out the door handle by pressing the
front part of the door handle. When
it pops out, unlock the door with the
key and pull the handle to open the
door. For more details, refer to “Using
Mechanical Key” section in this
chapter.

[When you shift the gear to R (Reverse)
even when the doors are unlocked, the
outside door handle will return to its
original position.

[If you shift the gear to R (Reverse)
when using the automatic door lock
feature, the outside door handle returns
to its original position and the door will
be locked.

[When the vehicle speed is within 1.8
mph-9 mph (3 km/h-15 km/h) with the
doors unlocked, the doors will remain
unlocked, and only the door handle
will return to its original position. If
the vehicle is stopped in this condition,
the passenger will not have to unlock
the door. The door will be opened when
the door handle pops out by touching
the door lock/unlock sensor (engraved
part) on the outside door handle.

[When the outside door handle goes in
and pops out, a noise may sound from
inside the vehicle.

5-35
05
&DXWLRQVZKHQZDVKLQJWKHYHKLFOH
If touch sensors are equipped, an
unexpected warning may sound, and
the doors might lock or unlock when the
smart key is within the detectable range
and the outside door handle is wet.

[Conditions when using the automatic
car wash
- Prior to wash, keep the Engine
Start/Stop button in ACC or ON
position, stay in N (Neutral) and
enter the automatic car wash. For
details of staying in N (Neutral),
refer to “To Stay in N (Neutral)”
section in chapter 6.
- Enter the automatic car wash with
the doors locked and the outside
door handle in its original position.

[Conditions when self car washing
- Wash your car with the doors locked
and the outside door handle in its
original position.
- If any water or a rag is touching the
door handle lock/unlock sensor, the
door handle will pop out and the
door will be unlocked. To prevent
unintended operation of the door
handle sensor, keep the key over 6.5
ft. (2 m) away from the vehicle.
- Be careful to avoid theft of your
smart key during car wash.
- Make sure to keep your smart key
with you after car wash or keep
the key over 6.5 ft. (2 m) from the
vehicle.
- If an unexpected waring sounds
during car wash, keep the Engine
Start/Stop button in ACC or ON
position and leave the smart key
inside the vehicle.
Using mechanical key
ORS051019
ORS051260
A : Lock,
B : Unlock
Lock or unlock the door with the
mechanical key. Use the mechanical key
according to the following direction.
1. Pull the door handle while pressing
the front part of the outside door
handle M (front side of the vehicle).
Then remove the cover under the rear
part of the door handle.
2. Insert the key into the key hole N and
turn it to lock or unlock the door.
3. After unlocking with the mechanical
key, remove the key.
4. Release the door handle.
5. Press the front part of the door handle
again to manually pop out the handle,
then pull it out to open the door.

5-41
05
Easy Close (if equipped)
ORS051258L
Each door closes automatically with a
door switch.
Information
If the vehicle is equipped with easy close
feature, pressing the door open button
while the door is closed will automatically
open the door about 7.9 in. (20 cm)
Closing door with switch
ORS051266
ORS051267
A : Door handle,
B : Front center console,
C : Door trim,
D : Rear armrest console
Touch the lock/unlock sensor (engraved
part) of the door handle from the
outside, or press the open switch from
the inside, or press the close switch on
the console.

5-48
Convenience Features
ORS031142LA: Cluster,
B: Steering wheel
If you do not want to use Rear Occupant
Alert, press the OK button on the steering
wheel when the first alert is displayed on
the cluster. Doing so will deactivate the
second alert one time.

[If the vehicle is started remotely (if
equipped with Remote Start), inside
movement detection will stop.
System Precautions

[Make sure that all the windows are
closed. If the window is open, the
alert may operate by the sensor
detecting an unintended movement
(for example, wind or bugs).

[The alert may operate if movement
in the driver or passenger seat is
detected.

[If the doors are locked with a
passenger inside the vehicle, the alert
may operate.

[An alert can occur if there is an impact
on the vehicle.

[If boxes or objects are stacked in the
vehicle, the system may not detect
passengers. Or, the alert may operate
if the boxes or objects fall off.

[The alert may operate when the
vehicle is pushed or shaken, or while
washed, or by surrounding noise or
vibration after the vehicle is locked.

[The alert may operate when there
are metallic or liquid objects in the
vehicle.

5-49
05
WARNING
Even if your vehicle is equipped with
Rear Occupant Alert, always make sure
to check the rear seat before you leave
the vehicle.
Advanced Rear Occupant Alert may not
operate when:

[Movement does not continue for
a certain period of time or the
movement is small.

[A child is not seated in a child
restraint system.

[The detection signal is weak because
the signal is obscured by seat or CRS
(for example, child is restrained in
the forward-facing CRS).

[Movement is detected in areas other
than the rear seats.

[The rear passenger is covered with a
fabric containing metallic substance
such as a blanket.

[An object in the vehicle blocks the
sensor.

[The sensor is contaminated by
foreign material.

[An animal at the rear seat is not large
enough to be detected by the sensor
or there is hardly any movement.

[Attaching objects or modifying the
interior ceiling, or the interior ceiling
is deformed or damaged.

[There are electronic interference
around the vehicle.

[Other environmental reasons that
may affect the system.
Declaration of Conformity
The radio frequency components (ROA
Radar Sensor) complies:
- For USA
OANATEL323
- For Canada
OANATEL324

5-59
05
Steering Wheel Grip Sensor
While driving the vehicle with the Driver
Assistance system on, it detects whether
the driver is holding the steering wheel
and displays the Hands-off warning
when the driver is not holding the
steering wheel. See ‘Hands off warning’
from ‘Lane keeping assist (LKA)’, ‘Lane
following assist (LFA)’, ‘Highway driving
assist (HDA)’ section in chapter 7 for
details.
In the following situations, the sensor
may fail to detect the driver’s hands
although the driver is holding the
steering wheel.

[When the driver is wearing gloves.

[When accessories such as a cover is
attached on the steering wheel.

[When electronic device is touching
the steering wheel.

[When the steering wheel is wet.
CAUTION
The steering wheel sensor may not work
properly if the following precautions
are not followed.

[Do not modify the steering wheel
cover.

[Do not attach accessories on the rim
of the steering wheel.

[Do not touch the steering wheel with
electronic devices. (for example,
Laptop, tablet PC, etc)

[Do not touch the steering wheel with
metallic or conductive objects. (for
example, Tumbler, soda can, etc)

[Do not excessively wet the steering
wheel. (for example, spilled water,
wet tissue, vapor from steam wash)
Haptic Warning/Steering Wheel
Vibration Warning (if equipped)
If haptic steering wheel is equipped,
the Driver Assistance system vibrates
the steering wheel to warn the driver
when the system indicates hazardous
situations.
Setting haptic warning

[While the engine is on, select

6HWXS

5-104
Convenience Features
EXTERIOR LIGHTS
Lighting Control
To operate the lights, turn the knob at
the end of the control lever to one of the
following positions:
OJX1059057
M OFF
N AUTO headlight
O Parking lamp
P Headlight
Daytime Running Light (DRL)
The Daytime Running Lights (DRL) can
make it easier for others to see the front
of your vehicle during the day, especially
after dawn and before sunset.
The DRL system will turn the dedicated
lamp OFF when:

[The headlights are ON.

[The parking brake is applied.

[The vehicle is turned off.
$872KHDGOLJKW
ORS051076
The parking lamp and headlight will
be turned ON or OFF automatically
depending on the amount of daylight as
measured by the ambient light sensor M
at the upper end of the windshield glass.
Even with the AUTO headlight feature
in operation, it is recommended to
manually turn ON the headlights when
driving at night or in a fog, driving in the
rain, or when you enter dark areas, such
as tunnels and parking facilities.
NOTICE

[Do not cover or spill anything on the
sensor M located at the upper end of
the windshield glass.

[Do not clean the sensor using
a window cleaner, the cleanser
may leave a light film which could
interfere with sensor operation.

[If your vehicle window is tinted or
other types of metallic coating are
on the front windshield, the AUTO
headlight system may not work
properly.

5-113
05
Puddle Lamp
ORS051084L
Welcome light
When all doors (and trunk) are closed
and locked, the puddle lamp will turn
on for 15 seconds if any of the below is
performed.

[The doors are unlocked by the smart
key.

[The outside door handle touch sensor
is touched with the smart key in
possession.

[The vehicle is approached with the
smart key in possession. (if equipped)
The puddle lamp turns off if the Engine
Start/Stop button is in the ACC position
with a door open.
For more details, refer to “Welcome
System” in this chapter.
Escort light
When the Engine Start/Stop button is in
the OFF position and the driver’s door is
opened, the puddle lamp will turn on for
30 seconds. If the driver’s door is closed
within the 30 second period, the puddle
lamp will turn off after 15 seconds. If the
driver’s door is closed and locked, the
puddle lamp will turn off immediately.
The Puddle Lamp Escort Light will turn
on only the first time the driver’s door is
opened after the engine is turned off.
Welcome System
ORS051077L
Welcome system helps keep the driver
visible by turning on vehicle lights when
the driver approaches the vehicle.

5-115
05
ORS051272
High Beam Assist will automatically
switch between high beam and low
beam depending on the detected
brightness from the lamps of oncoming
vehicles or vehicles in front.
Detecting sensor
ORS071001L
M: Front view camera
The front view camera is used as a
detecting sensor to detect ambient light
and brightness while driving.
Refer to the picture above for the
detailed location of the detecting sensor.
NOTICE
Always keep the front view camera in
good condition to maintain optimal
performance of High Beam Assist.
)RUPRUHGHWDLOVRQWKHSUHFDXWLRQV
of the front view camera, refer to

U)RUZDUG&ROOLVLRQ$YRLGDQFH$VVLVW
)&$
VVHFWLRQLQFKDSWHU
High Beam Assist Setting
ORS051241L
With the Engine Start/Stop button in the
21SRVLWLRQVHOHFW
S/LJKWV