check GENESIS G90 2023 Owner's Guide
[x] Cancel search | Manufacturer: GENESIS, Model Year: 2023, Model line: G90, Model: GENESIS G90 2023Pages: 676, PDF Size: 14.16 MB
Page 244 of 676
5-103
05
NOTICE
[ Observe the following restrictions
during the update.
-You cannot use the vehicle during
the update. Be sure to have
enough time for the update, and
safely park the vehicle before
starting the update process.
-You cannot use remote features,
including remote start.
-The Rear Occupant Alert feature
may not work. Check if there are
any occupants in the rear seat.
-If there is an update for the Genesis
Digital Key feature, the doors
cannot be locked or unlocked
using the digital key, or fingerprint
recognition. If the Genesis Digital
Key feature is being updated, use
the smart key to lock or unlock the
doors. [ The update will be automatically
canceled if any vehicle conditions
required for the update are changed
before starting the update.
[ Once the update has started, you
cannot cancel the update.
[ You cannot use the Over-The-Air
software update feature if you
modify or replace any vehicle
software.
[ Do not open the hood or replace
the battery in the vehicle during the
update. The update may fail.
[ If a diagnostic tool of any kind is
connected to the vehicle OBD (On-
board Diagnostic) terminal, the
vehicle cannot be updated. The
vehicle can be updated by removing
the diagnostic tool connected to the
OBD terminal and then restarting the
vehicle.
[ If the update is not completed
successfully, contact Genesis
Customer Care.
[ Vehicle reception must be identified
as Verizon to safely install any
downloaded software.
[ Vehicle signal strength, must be
strong (above -82 dbm) to safely
install any downloaded software.
Page 258 of 676
5-117
05
High Beam Assist Malfunction
and Limitations
High Beam Assist malfunction
OJWEV051094L
When High Beam Assist is not working
properly, the ‘Check High Beam Assist
system’ warning message will appear
and
warning light will illuminate on
the cluster. Have the vehicle inspected
by an authorized retailer of Genesis
Branded products.
Limitations of High Beam Assist
[ Light from an oncoming or front
vehicle is not detected because of
lamp damage, or because it is hidden
from sight, etc.
[ Headlight of an oncoming or front
vehicle is covered with dust, snow or
water.
[ An oncoming or front vehicle’s
headlights are off, but the fog lamps
are on, etc.
[ There is a lamp that has a similar
shape as a vehicle’s lamp.
[ Headlights have been damaged or not
repaired properly.
[ Headlights are not aimed properly.
[ Driving on a narrow-curved road,
curved road, rough road, uphill or
downhill. [ Vehicle in front is partially visible on a
crossroad or curved road.
[ There is a traffic light, reflecting sign,
flashing sign or mirror ahead.
[ There is a temporary reflector or flash
ahead (construction area).
[ The road conditions are bad such as
being wet, iced or covered with snow.
[ A vehicle suddenly appears from a
curve.
[ The vehicle is tilted from a flat tire or
is being towed.
[ Light from an oncoming or front
vehicle is not detected due to
obstacles in the air such as exhaust
fume, smoke, fog, snow, or water spay
or blizzard on the road, or fogging in
the lamp, etc.
Information
For more details on the limitations of the
) U R Q W 9 L H Z & D P H U D U H I H U W R
Page 259 of 676
5-118
Convenience Features
ORS051284
) U R Q W : L Q G V K L H O G : L S H U V
Operates as follows when the Engine
Start/Stop button is in the ON position.
MIST: For a single wiping cycle,
push the lever upward and
release. The wipers will operate
continuously if the lever is held in
this position.
OFF: Wiper is not in operation.
AUTO: The rain sensor located on the
upper end of the windshield
glass senses the amount of
rainfall and controls the wiping
cycle for the proper interval.
The more it rains, the faster the
wiper operates. When the rain
stops, the wiper stops. To vary
the speed setting, turn the speed
control knob.
LO: The wiper runs at a lower speed.
HI: The wiper runs at a higher speed.
Information
If there is heavy accumulation of snow
or ice on the windshield, defrost the
windshield for about 10 minutes, or until
the snow and/or ice is removed before
using the windshield wipers to ensure
proper operation.
If you do not remove the snow and/or ice
before using the wiper and washer, it may
damage the wiper and washer system.
AUTO (Automatic) control
ORS051085
The rain sensor located on the upper
end of the windshield glass senses
the amount of rainfall and controls the
wiping cycle for the proper interval.
The wiper operation time will be
automatically controlled depends on
rainfall.
When the rain stops, the wiper stops.
To vary the sensitivity setting, turn the
sensitivity control knob.
If the wiper switch is set in AUTO mode
when the Engine Start/Stop button is in
the ON position, the wiper will operate
once to perform a self-check of the
system. Set the wiper to the OFF position
when the wiper is not in use.
WIPERS AND WASHERS
Page 279 of 676
5-138
Convenience Features
System Maintenance
Cabin air filter
OHI048581L
A : Outside air,
B : Recirculated air,
C : Climate control air filter,
D : Blower,
E : Evaporator core,
F : Heater core
The cabin air filter is installed behind
the glove box. It filters the dust or other
pollutants that enter the vehicle through
the heating and air conditioning system.
We recommend that the cabin air filter
be replaced by an authorized retailer of
Genesis Branded products according to
the maintenance schedule. If the vehicle
is being driven in severe conditions such
as dusty or rough roads, more frequent
cabin air filter inspections and changes
are required.
If the air flow rate suddenly decreases,
have the system inspected at an
authorized retailer of Genesis Branded
products.
Checking the amount of air
conditioner refrigerant and
compressor lubricant
When the amount of refrigerant is low,
the performance of the air conditioning
is reduced. Overfilling also reduces the
performance of the air conditioning
system.
Therefore, if abnormal operation is
found, have the system inspected by an
authorized retailer of Genesis Branded
products.
NOTICE
It is important that the correct type and
amount of oil and refrigerant is used.
Otherwise, damage to the compressor
and abnormal system operation may
occur. To prevent damage, the air
conditioning system in your vehicle
should only be serviced by trained and
certified technicians.
NOTICE
[ The refrigerant system should only
be serviced by trained and certified
technicians to insure proper and safe
operation.
[ The refrigerant system should be
serviced in a well-ventilated place.
[ The air conditioning evaporator
(cooling coil) shall never be repaired
or replaced with one removed from
a used or salvaged vehicle and new
replacement MAC evaporators shall
be certified (and labeled) as meeting
SAE Standard J2842.
Page 283 of 676
5-142
Convenience Features
WARNING
Windshield heating
Do not use the
position during
cooling operation in extremely humid
weather. The difference between the
temperature of the outside air and that
of the windshield could cause the outer
surface of the windshield to fog up,
causing loss of visibility could cause
an accident resulting in serious injury
or death. In this case, set the mode
selection button to the
position
and fan speed control knob to a lower
speed.
[ For maximum defrost performance,
set the temperature control to the
highest temperature setting and
the fan speed control to the highest
setting.
[ If warm air to the floor is desired while
defrosting or defogging, set the mode
to the floor-defrost position.
[ Before driving, clear all snow and ice
from the windshield, rear window,
side view mirrors and all side
windows.
[ Clear all snow and ice from the
hood and air inlet in the cowl grill
to improve heater and defroster
efficiency and to reduce the
probability of fogging up the inside of
the windshield.
NOTICE
If the engine temperature is still cold
after starting, then a brief engine warm
up period may be required for the
vented air flow to become warm or hot.
To Defog Inside Windshield
ORS051131L
1. Select the desired fan speed.
2. Select the desired temperature.
3. Press the defroster button (
).
4. Fresh mode will be selected
automatically.
Check to make sure the air intake control
is in Fresh mode. If the air intake control
indicator light is illuminated, press the
button once to enable Fresh mode
(indicator light OFF).
If the
position is selected, the fan
speed is automatically increased.
: , 1 ' 6 + , ( / ' ' ( ) 5 2 6 7 , 1 * $ 1 ' ' ( ) 2 * * , 1 *
Page 284 of 676
5-143
05
To Defrost Inside Windshield
ORS051130
1. Set the fan speed to the highest
(extreme right) position.
2. Set the temperature to the extreme
hot (HI) position.
3. Press the defroster button (
).
4. Fresh mode will be selected
automatically.
Check to make sure the air intake control
is in Fresh mode. If the air intake control
indicator light is illuminated, press the
button once to enable Fresh mode
(indicator light OFF).
If the
position is selected, lower fan
speed is adjusted to a higher fan speed.
Defogging Logic
To reduce the probability of fogging
up the inside of the windshield, the air
intake or air conditioning are controlled
automatically according to certain
conditions. To cancel or reset the
defogging logic, do the following.
1. Press the Engine Start/Stop button to
the ON position.
2. Press the defroster button (
) or
().
3. While pressing the air conditioning
button (A/C), press the air intake
control button at least 5 times within
3 seconds.
The air intake control button indicator
will blink 3 times to indicate that the
defogging logic has been disabled.
Repeat the steps again to re-enable the
defogging logic.
If the battery has been discharged or
disconnected, it resets to the defog logic
status.
Page 287 of 676
5-146
Convenience Features
Turning the Auto Defogging System
ON or OFF
& O L P D W H F R Q W U R O V \ V W H P
Press the front windshield defroster
button for 3 seconds when the Engine
Start/Stop button is in the ON to turn the
system on or off.
To check whether the system is on
or off, go to the settings menu in the
infotainment system and see if 'Auto
Defog' is selected or not.
Infotainment system
Auto Defogging System can be turned
R Q D Q G R I I E \ V H O H F W L Q J S 6 H W X S
Page 299 of 676
5-158
Convenience Features
Wireless Smart Phone Charging
System (if equipped)
ORS051201
ORS051202
A : Front seat,
B : Rear seat (if equipped),
M : Indicator light,
N : Charging pad
Charging smart phone
The wireless smart phone charging
system charges only the Qi-enabled
smart phones (
). Read the label on
the smart phone accessory cover or
visit your smart phone manufacturer’s
website to check whether your smart
phone supports the Qi technology.The wireless charging process starts
when you put a Qi-enabled smart phone
on the wireless charging unit.
1. The system is available when all doors
are closed, and when the Engine
Start/Stop button is in the ON (or
START) position.
2. You can turn on or off the wireless
charging function from the Settings
menu. Select:
- Front seat (infotainment system):
6 H W X S
Page 304 of 676
5-163
05
Using armrest touchscreen
ORS051206L
1. Press from the left side menu of
armrest touchscreen.
Rear side sunshade adjustment screen
is displayed.
2. Press 'Open' or 'Close’ to open or
close the rear side window sunshades.
Information
If the operating sunshade is blocked by an
R E M H F W W K H V X Q V K D G H V W R S V I U R P R S H Q L Q J
or closing. The sunshade is only able to
open (move downward) once stopped by
obstruction.
NOTICE
Do not apply excessive external force
on the rear side window sunshade while
operating. It may cause a malfunction.
Resetting the rear side window
sunshades
1. Start the engine.
2. Continue pulling up on the power
window switch for at least 10 seconds
when the window is closed.
If the sunshade is not operating
normally, it must be reset as follows:
If the rear side window sunshade does
not work properly after following the
above procedure, it is recommended that
the system be checked by an authorized
retailer of Genesis Branded products.
Information
If the temperature inside the vehicle is
E H O R Z
Page 312 of 676
6
Idle Stop and Go (ISG) ...................................................................................6-49ISG System Operation ............................................................................................... 6-49
ISG System Off............................................................................................................ 6-51
Forced to Restart Engine ...........................................................................................6-52
ISG Malfunction ..........................................................................................................6-52
Calibrating the Battery Sensor ..................................................................................6-53
Coasting .......................................................................................................... 6-54Coasting Setting ........................................................................................................ 6-54
Coasting Operating Conditions ................................................................................ 6-54
Coasting Release Conditions ....................................................................................6-55
Predictive Shift ................................................................................................ 6-56Predictive shift Operating Conditions ..................................................................... 6-56
Predictive shift off Conditions ................................................................................. 6-56
Limitations of the System ......................................................................................... 6-57
Checking Operation on the Instrument Cluster ....................................................... 6-57
How Predictive Shift Operates ................................................................................. 6-59
Drive Mode Integrated Control System ..........................................................6-61Selecting Drive Mode ................................................................................................. 6-61
ECO, COMFORT, SPORT Mode Features ................................................................. 6-62
CUSTOM Mode Features .......................................................................................... 6-63
Road Active Noise Control ............................................................................. 6-65System Malfunction .................................................................................................. 6-65
Active Sound Design....................................................................................... 6-65
Special Driving Conditions .............................................................................6-66
Hazardous Driving Conditions ................................................................................. 6-66
Rocking the Vehicle .................................................................................................. 6-66
Smooth Cornering ......................................................................................................6-67
Driving at Night ..........................................................................................................6-67
Driving in the Rain ..................................................................................................... 6-68
Driving in Flooded Areas ........................................................................................... 6-68
Highway Driving ........................................................................................................ 6-68
Winter Driving .................................................................................................6-69Snow or Icy Conditions ............................................................................................. 6-69
Winter Precautions ..................................................................................................... 6-73
Vehicle Load Limit .......................................................................................... 6-75The Loading Information Label ................................................................................. 6-75
Trailer Towing .................................................................................................. 6-79