display GENESIS G90 2023 Owners Manual

2-14
Vehicle Information, Consumer Information and Reporting Safety Defects
Recommended SAE Viscosity Number
CAUTION
Always be sure to clean the area around any filler cap, drain plug, or dipstick before
checking or draining any lubricant. This is especially important in dusty or sandy
areas and when the vehicle is used on unpaved roads. Cleaning the plug and dipstick
areas will prevent dirt and grit from entering the engine and other mechanisms that
could be damaged.
Engine oil viscosity (thickness) has an effect on fuel economy and cold weather
operating (engine start and engine oil flowability). Lower viscosity engine oils can
provide better fuel economy and cold weather performance, however, higher viscosity
engine oils are required for satisfactory lubrication in hot weather. Using oils of any
viscosity other than those recommended could result in engine damage.
When choosing an oil, consider the range of temperature your vehicle will be operated
in before the next oil change. Proceed to select the recommended oil viscosity from
the chart.
Temperature Range for SAE Viscosity Numbers
Temperature°C -30 -20 -10 0 10 20 30 40 50
(°F) -10 0 20 40 60 80 100 120
Engine Oil
0W-30 0W-30
An engine oil displaying this American Petroleum Institute(API)
Certification Mark conforms to the International Lubricant
Specification Advisory Committee (ILSAC). It is recommended
to only use engine oils that uphold this API Certification Mark.

3-15
03
Seat sliding, seatback angle and seat
cushion tilt adjustment (if equipped)
ORS031094
ORS032150N
Adjusting seat position and vertical height

[Control switch (Type A)
- Seat position adjustment: Slide the
switch M forward or backward to
adjust seat position.
- Seat height adjustment: Push down
or pull up the switch M to adjust
seat height.

[Armrest touchscreen (Type B)
1. Press
on the left side of
the menu from the armrest
touchscreen.
- Seat adjustment screen is
displayed.
2. Touch the lower part adjustment
button and adjust the seat position
and cushion angle.
Seatback angle

[Control Switch (Type A)
Slide the switch N forward or
backward to adjust seatback angle.

[Armrest touchscreen (Type B)
1. Press
on the left side of
the menu from the armrest
touchscreen.
- Seat adjustment screen is
displayed.
2. Touch the center part adjustment
button and adjust the seatback
angle.
Lumbar support adjustment (if
equipped)
ORS032021N
1. Press on the left side of the menu
from the armrest touchscreen.

[Seat adjustment screen is displayed.
2. Press the adjustment button on the
center of the rear seat to adjust, then
select lumbar support function from
the menu.
3. Touch the arrows to adjust the
position of the lumbar support.

3-16
Safety System
Adjusting seat bolster (if equipped)
ORS032022N
1. Press on the left side of the menu
from the armrest touchscreen.

[Seat adjustment screen is displayed.
2. Press the adjustment button on the
center of the rear seat to adjust, then
select seat bolster function from the
menu.
3. Touch the arrows to adjust the
position of the seat bolster.
Walk-in switch (if equipped)
ORS031104
Seating position, seatback angle and
cushion angle of the front passenger seat
can be adjusted by operating the rear
seat control switches.
1. Press the walk-in device switch on the
center armrest of rear seat.

[Indicator light on the walk-in device
switch illuminates.
2. Operate the rear seat control switch to
adjust the front passenger seat.

[ For more information refer to the
“Front Seats” section in this chapter.

[Press the switch again to turn off
the walk-in device.

[If you do not adjust the front
passenger seat within 15 seconds
after pressing the walk-in
switch, the front passenger seat
adjustment function automatically
turns off.
WARNING
Do not adjust the passenger seat when
a passenger is seated.

3-17
03
Easy access switch (for passenger’s
Seat) (if equipped)
ORS032109N
ORS032023N
9HKLFOHVHTXLSSHGZLWK,QWHJUDWHG
Memory System
The seats can automatically move
backward by opening the rear door with
the rear seats moved forward.
1. Press
on the left side of the menu
from the armrest touchscreen.

[Seat adjustment screen is displayed.
2. Touch either the right, or left seat
adjustment button M on the rear seat.
3. Press the DOOR button.

[The indicator light on the button
illuminates and easy access
function for entrance/exit is
enabled.
VIP seat (if equipped)
ORS032024N
The rear seat occupant can adjust the
VIP seat and front passenger seats for
VIP convenience. The front and rear
passenger seats are also adjustable
through the armrest touchscreen.
Information

[Convenience features of the rear left
seat is not available under the following
circumstances when:
-The driver’s seat is positioned back
too far.
-The driver’s seatback is reclined
back too much.

[Operating range of the convenience
features of the rear left seat may
vary depending on the position of the
driver’s seat.

3-18
Safety System
VIP seat mode switches (if
equipped)
ORS031025
ORS032154N
A : Control switch,
B : Armrest touchscreen,
L : Rear seat (Left),
R : Rear seat (Right)
You can automatically adjust the seat for
comfort or various in-vehicle activities.
1. Press
on the left side of the menu
from the armrest touchscreen.

[Seat adjustment screen is displayed.
2. Press and hold the appropriate mode
for your activity.

[Relax (REST) mode, Reading mode,
Return mode.
Relax (REST) Mode
The front and rear passenger seats are
automatically adjusted for comfort. Press
and hold button M on the rear door or
on the armrest touchscreen. Each seat is
adjusted automatically as below.

[Rear left seat
-6HDWEDFNWLOWVEDFNZDUG

3-21
03
Information
Return function switch for adjusting the
front passenger's seat do not operate in
the following situations when:

[The Engine Start/Stop button is in the
OFF position.

[A passenger occupies the front
passenger's seat.

[An item occupies the front passenger's
seat.

[The front passenger's door is open.

[The front passenger's seatbelt is
fastened.
Information

[The seat position changes to Return
mode while the button O is pressed.
The seat stops moving when the button
O is released.

[Operating the seat control switch while
the seat is being adjusted for Return
mode stops the seats from moving.
To adjust the seats again, use the
control switch and adjust manually.
Calf support adjustment (if equipped)
ORS031027
ORS032155N
Place your leg on the calf support and
adjust its angle to relax.

[Control switch (Type A)
Slide the calf support switch
diagonally upward or downward to
adjust the angle.

[Armrest touchscreen (Type B)
1. Press
from the left side menu
on the armrest touchscreen.
- Seat adjustment screen is
displayed.
2. Press the adjustment button on
the lower part of the rear seat to
be adjusted, and select the calf
support function.
3. Press the arrows of the desired
direction to adjust the angle of the
calf support.

3-23
03
ORS031137L
Setting the screen display
After pressing the massage button, you
can change the display method of each
massage mode from the armrest touch
screen. Follow the steps below.
1. Press 'Setup' from the home screen on
the armrest touchscreen, or press

from the left side menu.
2. Press 'Display'.
3. Select among 'Massage screen',
'Pop-up', or 'OFF' from the 'Massage
Notification/Status' menu.

[If Massage screen is selected,
pressing the Massage button will
move the armrest touchscreen
display to Massage mode tap.

[If 'Pop-up' is selected, pressing the
massage button will display the
massage mode pop-up screen on
the armrest touchscreen.
ORS031035L
Armrest touchscreen
1. Press from the left side menu on
the armrest touchscreen.

[Massage mode screen is displayed.
2. Select a desired mode.
M Whole-Body Energizing Mode
N Lumbar Therapy Mode
O Pelvis Balancing Mode
P Upper Body Refresh Mode
3. Select the desired duration.

[ Each time you press the button, the
intensity setting of the Massage it is
changed as follows:
+LJK

3-27
03
Rear seat head restraints
ORS031029
The rear seats are equipped with head
restraints in all the seating positions for
the passenger’s safety and comfort.
ORS031030
0DQXDODGMXVWPHQWLIHTXLSSHG

[To raise the head restraint:
1. Pull it up to the desired position M.

[To lower the head restraint:
1. Push and hold the release button
N on the head restraint support.
2. Lower the head restraint to the
desired position O.
3RZHUDGMXVWPHQWLIHTXLSSHG
ORS031031
ORS032032N

[Adjusting the head restraint forward
and rearward M
- Adjustment switch (Type A)
Slide the adjustment switch forward
or backward to adjust the head
restraint forward and rearward.
- Armrest touchscreen (Type B)
1. Press
from the left side menu
on the armrest touchscreen.
- Seat adjustment screen is
displayed.
2. Press the adjustment button on
the upper part of the seat you
want to adjust from the armrest
touchscreen, and then adjust
the head restraint forward and
rearward.

3-28
Safety System
WARNING
Do not remove the head restraint.
Removing the head restraint on your
own might damage the adjustment
motor connector. Have your vehicle
inspected by an authorized retailer
Genesis Branded products.

[Adjusting the height up and down N
- Adjustment switch (Type A)
Push down or pull up the head
restraint adjustment switch to
adjust the head restraint up and
down.
- Armrest touchscreen (Type B)
1. Press
from the left side menu
on the armrest touchscreen.
- Seat adjustment screen is
displayed.
2. Press the adjustment button on
the upper part of the seat you
want to adjust from the armrest
touchscreen, and then adjust the
head restraint up and down.
Wing-out head restraint adjustment
(if equipped)
ORS031036
While driving, the wing-out head
restraint supports the passenger’s head
from shaking. Hold both ends of the
wing-out head restraint with your hands,
and pull out or push in to adjust its
position.
Information
When the wing-out head restraint is not in
use, hold both ends of the head restraint
and pull out to return it to its original
position.

3-29
03
Armrest
ORS031037
The armrest is located in the center of
the rear seat.
Grab the handle on the upper end of the
arm rest. Then, pull down the handle to
use the arm rest.
NOTICE

[Do not put any items on the rear
center seat. Those items may get
damaged, when the arm rest is
pulled down.

[Do not attempt to fold back the
arm rest, when the cup holder is
extended out.
Using the armrest touchscreen
ORS031039L
Convenience features can be adjusted
using the rear armrest touchscreen.
Quickly touch the screen twice to start
the display. Climate, Seat, Massage,
Lights, and Shades are adjustable from
the armrest touchscreen.

[Pressing the LOCK button on the
upper part of the rear seat armrest
touchscreen will disable the armrest
touchscreen and other infotainment
switches from operating.
Press the LOCK button again to enable
the switches.

[For more information refer to the
“Armrest Touchscreen” section in
chapter 4.
CAUTION

[Keep the armrest cover closed while
driving. Sudden braking may lead to
injuries, by bumping into the armrest
cover.

[Do not forcefully pull the upper part
of the armrest. The Anchor holding
the armrest may be damaged.