light GMC CANYON 2009 Get To Know Guide

Getting to Know Your Canyon18
8. Turn the engine off.
9. Place the transmission shift
lever in Park (P), or First (1) for
vehicles equipped with a manual
transmission.
10.Turn the ignition to Lock.
11. Release the parking brake prior to
towing.
Shifting out of Neutral
1. Set the parking brake and press and
hold the regular brake pedal.
2. Shift the transmission to Neutral (N),
or press the clutch pedal for vehicles
with a manual transmission, and turn
the ignition to Run with the engine off.
3. Press the button for the desired
transfer case shift position (2HI,
4HI, or 4LO).
4. After the transfer case has shifted
out of Neutral, the indicator light will
go out.
5. Release the parking brake.
6. You may start the engine and shift
the transmission to the desired
position.
See Section 2 of your Owner Manual.
Shift the transfer case into or out of
Neutral
Shifting into Neutral
1. Set the parking brake.
2. Turn the ignition to Run but leave the
engine off.
3. Press the regular brake pedal and
shift the transmission in Neutral (N),
or depress the clutch for vehicles
with a manual transmission.
4. Shift the transfer case to two-wheel
high.
5. Press and hold the two-wheel high
and four-wheel low buttons at the
same time for 10 seconds. The
Neutral (N) light will come on when
the transfer case shift to Neutral (N)
is complete.
6. Start the engine.
7. Press and hold the regular brake
pedal and shift the transmission to
Reverse (R) for one second; then
shift the transmission to Drive (D) for
one second, or First (1) for vehicles
with manual transmissions and let
out the clutch, to ensure the transfer
case is in Neutral. If not, repeat this
procedure starting at the third step.
Note: Shifting the transfer case to
Neutral can cause your vehicle to roll
even if the transmission is in Park (P) or
in gear. You or someone else could be
seriously injured. Be sure to set the
parking brake before placing the trans-
fer case in Neutral.

19
StabiliTrak®– Stability Control
System (if equipped)
StabiliTrak is an advanced computer-
controlled vehicle stability and traction
enhancement system that assists with
directional control of the vehicle in diffi-
cult driving conditions. It turns on auto-
matically every time you start your vehi-
cle. To limit wheelspin and help maintain
directional control, you should always
leave the system
on. However, if
your vehicle
becomes stuck in
sand, mud or snow
and rocking the
vehicle is required,
the system should
be turned off.
To turn off the traction control part of
the system, press the (StabiliTrak)
button on the center of the instrument
panel. TRAC OFF will appear on the
Driver Information Center (DIC).
To turn off the traction control and stabil-
ity control systems, press and hold the
button for five seconds. STAB SYS
OFF will appear on the DIC.
The StabiliTrak warning light on the
instrument panel cluster will illuminate
when either part of the system is
turned off.
Press the button again to turn on
the system.
See Section 4 of your Owner Manual.
Tire Pressure Monitor
The Tire Pressure Monitor alerts you
when a significant reduction in pressure
occurs in one or more of your vehicle’s
tires by illuminating the (Low Tire
Pressure) warning light on the instru-
ment panel cluster. The low tire pres-
sure warning light will remain on until
you correct the tire pressure. A LOW
TIRE message may also appear on
the DIC.
Correcting the Tire Pressure
When the low tire pressure warning light
illuminates, you must inflate the tire to
the proper tire pressure (just as you
must refuel the vehicle when the low fuel
warning light illuminates). The Tire and
Loading Information label shows the
correct tire pressure for the tires when
they’re cold. “Cold” means your vehicle
has been sitting for at least three hours
or driven no more than one mile.
You can temporarily clear the DIC
message by acknowledging it with your
DIC controls. However, at the next
vehicle start-up, the DIC message will
reappear if the tire pressure has not
been corrected.
During cooler conditions, the low tire
pressure warning light may appear when
the vehicle is first started and then turn
off as you start to drive. This could be an
early indicator that your tire pressures
are getting low and the tires need to be
inflated to the proper pressure.
See Section 5 of your Owner Manual.
Note:The Tire Pressure Monitor can
alert you about low tire pressure, but it
doesn’t replace normal monthly tire
maintenance.