lumbar support GMC CANYON 2010 Owner's Manual

Reclining Seatbacks
Use the vertical control on the outboard side of the seat
to raise or recline the seatback by moving the control
forward or rearward.
Power Lumbar
Press and hold the front or rear of the control on the
outboard side of the seat until you have the desired
lumbar support.
For more information see:
•Manual Seats on page 2-2
•Power Seats on page 2-3
•Reclining Seatbacks on page 2-5
•Power Lumbar on page 2-4
1-8

Power Seats
If the vehicle has power
seats, the controls used to
operate them are located
on the outboard side of the
seats.
To adjust the seat:
•Move the seat forward or rearward by sliding the
horizontal control forward or rearward.
•Raise or lower the front part of the seat cushion
by moving the front of the horizontal control up
or down.
•Raise or lower the rear part of the seat cushion
by moving the rear of the horizontal control up
or down.
•Raise or lower the entire seat by moving the entire
horizontal control up or down.
•Use the vertical control to recline the seatback.
See “Power Reclining Seatbacks” underReclining
Seatbacks on page 2-5for more information.
Manual Lumbar
On vehicles with this
feature, the knob is
located on the outboard
side of the driver seat.
Turn the knob to increase or decrease lumbar support.
2-3

Power Lumbar
If the vehicle has this
feature, the control is
located on the outboard
side of the seat(s).
Press and hold the front of the control until you have
the desired lumbar support. To decrease lumbar
support, press and hold the rear of the control.
Heated Seats
If the vehicle has this
feature, the controls are
located on the outboard
side of the front seats.
This feature will heat the cushion and back of the seats.
Press HI to turn the heat to the high setting. Press
LO to turn the heat to the low setting. Put the switch in
the center position to turn the heat off.
The ignition must be on for the heated seat feature to
work. The seat will heat to the last setting if the ignition
has been turned off and then turned back on.
The passenger safety belt must be fastened for the
heated seat feature to work on the passenger seat.
2-4