sensor GMC SIERRA 2008 Get To Know Guide

Getting to Know Your Sierra16
Cruise Control (if equipped)
The following
cruise controlbuttons arelocated on thesteering wheel:
(On/Off):Press this button
to turn the cruisecontrol system on
or off.
– SET (Set):Press this button
to set a speed, orto decrease the speed if the system isactive. When the cruise control speed isset, the cruise control light will illuminate
on the instrument panel cluster.
+ RES (Resume):Press this button to
resume a set speed, or to increase thespeed if the system is active.
(Cancel):Press this button to can
cel the cruise control but retain the setspeed in memory.
See Section 3 of your Owner Manual.
The Rainsense II windshield wipers use
a moisture sensor to automatically oper
ate the wipers when needed, dependingon driving conditions and the sensitivitysetting. If the system is left on for longperiods, an occasional wipe may occurwithout any moisture on the windshieldto indicate the system is activated.
Rainsense™II Windshield Wipers
(if equipped)
The headlamps also will be turned on
automatically when the Rainsensewipers are active if the exterior lamp
control knob is in the AUTO position.
Windshield Wiper Controls
The controls for the windshield wipers
are located on the multifunction stalk
on the left side of the steering column.The wipers band can be rotated to thefollowing positions:
(Mist):Rotate the band down to this
position to turn the wipers on for onewipe.
(Off):Rotate the band to this posi
tion to turn off the wipers.
(Delay):Rotate the band up to one
of the delay settings to activate the
Rainsense function and adjust the sensitivity levels. The wipers activate more
often as the band is rotated upward.
(Low):Rotate the band up to this
position for steady, lowspeed wipes.
(High):Rotate the band up to
this position for highspeed wipes.
(Washer):Push the paddle on top
of the multifunction lever to spray wash
er fluid on the windshield.
See Section 3 of your Owner Manual.
Sierra 2008 A 5/16/07 7:49 AM Page 16

17
Heated Windshield Washer
Fluid (if equipped)
Press the (Heated Washer Fluid)
button, located below the climate controls on the instrument panel, to sprayheated washer fluid on the windshield.This will help to clear ice, tree sap or
bugs from the windshield. A light on theswitch will flash while the washer fluid is
heated, which may take up to 40 sec
onds. The wipers will automatically turnon for four heated wash cycles or untilthe button is pressed again.
See Section 3 of your Owner Manual.
Your vehicle is equipped with an
Automatic Headlamp System, which
turns on the Daytime Running Lamps
(DRL) during the day and the headlamps and other exterior lamps at nightor when necessary.
The system uses a light sensor, located
on top of the instrument panel, to determine light conditions. For proper systemoperation, avoid placing any objects on
or near the sensor.
The exterior and interior lamp controls
are located on the instrument panel tothe left of the steering wheel.
Automatic Headlamp System
and Interior Lamps
Exterior Lamp Controls
(On/Off):
Turn the knob to this posi
tion to turn off the Automatic Headlamp
System and DRL. Turn the knob to thisposition again to turn them on.
AUTO (Automatic):This position turns
on the Automatic Headlamp System
and DRL.
(Parking Lamps):This position
turns on the parking lamps and taillamps.
(Headlamps):This position turns
on the headlamps and other exteriorlamps.
(Fog Lamps)(if equipped): Press
this button to turn the fog lamps onoroff.
Interior Lamp Controls
(Instrument Panel Brightness):
Turn this popout knob to adjust the
brightness of the instrument panel lights.
(Dome Lamp Override):Press in
this button to turn the dome lamps
off when a door is open. Press the but
ton again to have the dome lamps turn
on automatically when a door is open.
See Section 3 of your Owner Manual.
Extended Cab
The power sunroof
switch, located onthe
overhead console,includes these features:
Vent:From the closed
position, press and holdthe rear of the switch tovent the sunroof.
Sunroof (if equipped)
Sierra 2008 A 5/16/07 7:50 AM Page 17

the rear window.
Press and hold thefront of the switchto close the rear
window.
See Section 1 of your
Owner Manual.
Getting to Know Your Sierra18
Open:From the vent position, press and
hold the rear of the switch to open thesunroof.
Close:Press and hold the front of the
switch to close the sunroof.
Crew Cab
The power
sunroof switches, located onthe overheadconsole,include these features:
Vent:From the closed position, press
the rear of the passengerside switch tovent the sunroof.
To close the sunroof, press and hold the
front of the passengerside switch.
ManualOpen/ManualClose:To partial
ly open the sunroof, press and hold therear of the driverside switch until thesunroof reaches the desired position.Press and hold the front of the driverside switch to close it.
ExpressOpen/ExpressClose:To
expressopen the sunroof, fully press
and release the rear of the driversideswitch. Fully press and release the frontof the driverside switch to expressclose the sunroof. Press the switchagain to stop it.
See Section 2 of your Owner Manual.
Power Sliding Rear Window
(if equipped)
The power sliding rear window switch is
located on the overhead console. Pressand hold the rear of the switch to open
This feature uses ultrasonic sensors
on the rear bumpers to help you avoidcolliding with objects when parking thevehicle. It operates only at speeds lessthan 5 mph.
The rear parking assist display is
located near the rear window on thepassenger side. The lights on the
display provide
distance information. Lowtonedbeeps play out ofthe speakers (forobjects near therear bumper).
To turn off the
system, press the (Rear Parking
Assist) disable button, located below the
climate controls on the instrument panel.The indicator light will illuminate when
the system is off.
See Section 3 of your Owner Manual.
Ultrasonic Rear Parking Assist
(if equipped)
Note: The Ultrasonic Rear Parking
Assist (URPA) system will not activate
if you have a trailer hitch and trailerattached to your vehicle, or a bicycle orother object was hanging out of your
vehicle, when you last turned off thevehicle. Removing the attached orhanging objects and driving the vehicleforward above 15 mph will restore the
URPA system to normal operation.
Sierra 2008 A 5/16/07 7:50 AM Page 18