key GMC YUKON 2006 Get To Know Guide

3
SeeSection3ofyourOwnerManual.
A
B
C
D
E
F
G
InstrumentPanelCluster
Yourvehicle’sinstrumentpanelis
equippedwiththisclusteroronevery
similartoit.
Theinstrumentpanelclusterincludes
thesekeyfeatures:
A.TransmissionTemperatureGauge
(ifequipped)
B.TachometerC.SpeedometerandTransmission
GearSelector
D.OilPressureGauge
E.FuelGauge
F.Voltmeter
G.EngineCoolantTemperature
Gauge
H.DriverInformationCenter(DIC)
andOdometer
NOTE:
SeeSection3ofyourOwner
Manualformoreinformationabout
whatthelights,gaugesandindica
torsonyourvehicle’sinstrument
paneltellyouaboutyourvehicle’s
operation.
H
YukonYukonDenali 06 Beta3 5/19/05 10:03 AM Page 3

Getting to Know YourYukon/Yukon Denali4
Heated Front Seats (if equipped)
This feature allows you to heat the front
seatbacks and seat cushions simultane
ously or just the seatbacks. The controls
are located on the driver and front pas
senger door panels.
Select a heat setting for both the
seatback and seat cushion
• Press and release the horizontal but
ton (“A” above) until the indicator light
shows the desired setting.
Select a heat setting for the seatback
only
•Press and release the vertical button
(“B” above) until the indicator light
shows the desired setting.
See Section 1 of your Owner Manual.
Adjust lumbar
support
• Press the front
or rear of the
control located
on the side of
the seat cush
ion near the door.Release at the pre
ferred setting.
See Section 1 of your Owner Manual.
Power Lumbar Front Seats
(if equipped)
A B
A chime will sound and the safety belt
light ( ) will be illuminated and flash
for several seconds when the ignition
key is turned to Run or Start, or at
any time the vehicle is running, and the
driver’s safety belt is not buckled.
If your vehicle is equipped with the
Passenger Sensing System, the chime
will sound and a message will be dis
played on the Driver Information Center
for several seconds if the passenger’s
safety belt is not buckled under the
same conditions.
See Section 3 of your Owner Manual.
Passenger Automatic Locking
Restraint (ALR)
Automatic Dimming Rearview
Mirror with OnStar®,Compass
and Temperature Display
(if equipped)
Controls for the dimming feature, as well
as OnStar®(if equipped) and the com
pass and temperature displays, are
located on the bottom of the mirror.
The safety belt is designed to lock dur
ing an accident, but it will also lock if it is
pulled out all the way during initial buck
ling, and you may be unaware that this
has happened. If the safety belt does
lock, unbuckle it and allow it to retract
fully; then pull it out and rebuckle the
belt.
See Section 1 of your Owner Manual.
Driver and Front Passenger
Safety Belt Reminder
(if equipped)
YukonYukonDenali 06 Beta3 5/19/05 10:03 AM Page 4

Activate the automatic headlamp
system
• Turn the exterior lamps knob to
AUTO. The automatic headlamp
system will turn on the front and
rear lamps.
Manually illuminate the parking
lamps, sidemarker lamps, taillamps,
instrument panel/radio lights, license
plate lamps and roof marker lamps
(if equipped)
• Turn the exterior lamps knob to the
parking lamp position ().
Manually activate the headlamps, all
exterior tail/sidemarker lamps and
the instrument panel/radio lights
• Turn the exterior lamps knob to this
position ( ).
Turn the fog lamps
(if equipped) on
or off
• Press the fog lamp
button located on
the left side of the
instrument panel.
An indicator lamp will illuminate when
the fog lamps are on.
See Section 3 of your Owner Manual.
Getting to Know YourYukon/Yukon Denali12
Automatic Headlamp Controls
Turn off Daytime Running Lamps
(DRL) and automatic headlamps
• Turn the exterior lamps knob (located
to the left of the steering wheel) to
Off ( ) and release.
Power Folding Mirrors
(if equipped)
Fold mirrors
• Move the
selector switch
located above
the mirror
control (“A”
right) to
the center
position.
• Press the right
side of the
fourway control pad (“B” above)
to fold in the mirrors.
• Press the left side of the fourway
control pad to fold out the mirrors.
If the mirrors have been folded manual
ly, they must be moved through the
power folding cycle three times to reset
them in their tracks.
See Section 2 of your Owner Manual.
A
B
Note:Your DRLs or automatic head
lamps will reengage at the next key
cycle.
YukonYukonDenali 06 Beta3 5/19/05 10:04 AM Page 12

Arm the system
• Lock the doors
using the Remote
Keyless Entry
transmitter. The
alarm is activated
when the symbol
shown above illuminates in the instru
ment panel cluster (approximately 30
seconds).
If your vehicle is equipped with a Driver
Information Center, you can program the
alarm to the following:
• Both Horn/Headlamps
• Horn only
• Lamps only
•Off
See Section 2 of your Owner Manual.
13
Daytime Running Lamps (DRL)
Disable the DRL when idling
• Shift the vehicle into Park.
See Section 3 of your Owner Manual.
Content TheftDeterrent System
(if equipped)
Note:Your vehicle’s factory default
setting is Horn and Lamps. See the
Memory Settings for Your Vehicle sec
tion of this booklet for more information.
Tire Pressure Monitor
(if equipped)
The Tire Pressure Monitor alerts you
when a significant reduction in pressure
occurs in one or more of your vehicle’s
tires by illuminating the low tire pressure
warning light ( ) on the instrument
panel. The low tire pressure warning
light will remain on until you correct the
tire pressure.
You may also have a CHECK TIRE
PRESSURE message appear on the
DIC (if equipped).
Correcting the Tire Pressure
When the low tire pressure warning light
illuminates, you must fill the tire to the
proper tire inflation pressure. The Tire
and Loading Information label shows the
correct inflation pressure for the tires
when they’re cold. “Cold” means your
vehicle has been sitting for at least three
hours or driven no more than one mile.
You can temporarily remove the DIC
message by acknowledging it with your
DIC controls. However, at the next vehi
cle startup, the DIC message will reap
pear if the tire pressure has not been
corrected.
You may notice during cooler conditions
that the low tire pressure warning light
will appear when the vehicle is first start
ed and then turn off as you start to drive
the vehicle. This could be an early indi
cator that your tire pressures are getting
low and need to be inflated to the proper
pressure.
See Section 5 of your Owner Manual.
Note:The Tire Pressure Monitor can
alert you about low tire pressure, but it
doesn’t replace normal monthly tire
maintenance.
YukonYukonDenali 06 Beta3 5/19/05 10:04 AM Page 13

Getting to Know YourYukon/Yukon Denali14
Memory Positions for Driver’s
Seat, Mirrors and Power
Adjustable Pedals (if equipped)
Use the driver’s
door mounted
controls to:
• Adjust driver
seat, including
lumbar
adjustment
• Adjust gas and brake pedals
• Adjust the outside rearview mirrors
• With the vehicle in Park, press and
hold Memory 1 or 2 until two chimes
sound (about four seconds)
To set up for another driver:
• Repeat the process with the other
memory button
SeeSection 2 of your Owner Manual.
Memory Settings for Your Vehicle
(Driver Information Center)
(if equipped)
To scroll though the features that can be
customized using the Driver Information
Center:
1. Press the (Personalization) button
located on the steering wheel.
2. Press the (Select) button to
choose your desired setting. The first
setting is the default setting from the
factory.
3. Press to move to the next feature.
Lock Doors
(Automatically locks the doors.)
•Lock Doors: In Gear
•Lock Doors: With Speed
Unlock Doors
(Automatically unlocks the doors.)
•Unlock Doors: In Park
•Unlock Driver: In Park
•Unlock Doors: Key Out
•Unlock Doors: Manually
Door Lock Delay
(Delays locking the doors and tailgate
until five seconds after the last door is
closed.)
•Door Lock Delay: Off
•Door Lock Delay: On
Lock Feedback
(The feedback received when locking
the vehicle with the Remote Keyless
Entry transmitter.)
•Lock Feedback: Both
•Lock Feedback: Lamps
•Lock Feedback: Horn
•Lock Feedback: Off
Unlock Feedback
(The feedback received when unlocking
the vehicle with the Remote Keyless
Entry transmitter.)
•Unlock Feedback: Lamps
•Unlock Feedback: Horn
•Unlock Feedback: Both
•Unlock Feedback: Off
Headlamp Delay
(The amount of time the headlamps will
stay on after the vehicle is turned off.)
•Headlamp Delay: 10 Sec
•Headlamp Delay: 20 Sec
•Headlamp Delay: 40 Sec
•Headlamp Delay: 1 Min
•Headlamp Delay: 2 Min
YukonYukonDenali 06 Beta3 5/19/05 10:04 AM Page 14

15
•Headlamp Delay: 3 Min
•Headlamp Delay: Off
Perimeter Lights
(The headlamps and backup lamps will
come on for 40 seconds, if it is dark
enough, when unlocking the vehicle with
the Remote Keyless Entry transmitter.)
•Perimeter Lights: On
•Perimeter Lights: Off
Easy Exit Seat
(The driver’s seat moves to the exit
position when the key is removed from
the ignition.)
•Easy Exit Seat: Off
•Easy Exit Seat: On
Curb View
(The outside rearview mirror(s) tilt down
when the vehicle is shifted into
Reverse.)
•Curb View: Off
•Curb View: Passenger
•Curb View: Driver
•Curb View: Both
Alarm Warning
(The feedback received when the alarm
is active.)
•Alarm Warning: Both
•Alarm Warning: Off
•Alarm Warning: Horn
•Alarm Warning: Lamps
Language
(The Driver Information Center display
language.)
•Language: English
•Language: Français (French)
•Language: Español (Spanish)
Display Units
(The units in which all information will be
displayed.)
•Display Units: English
•Display Units: Metric
See Section 3 of your Owner Manual.
Odometer/Trip Settings
(if equipped)
Press the trip information button
to scroll through the Odometer,Trip A,
Trip B, Tire Pressures, Timer and
Engine Hours choices on the Driver
Information Center.
Odometer
This mode shows the total distance the
vehicle has been driven in either miles
or kilometers. Pressing the reset stem
located on the instrument cluster with
the vehicle off will also display the
odometer.
Trip A
This mode shows the current distance
traveled since the last reset for TRIP A
in either miles or kilometers.
Trip B
This mode shows the current distance
traveled since the last reset for TRIP B
in either miles or kilometers.
YukonYukonDenali 06 Beta3 5/19/05 10:04 AM Page 15