display GMC YUKON 2007 Get To Know Guide

Getting to Know YourYukon/Yukon Denali16
Automatic Dimming Rearview
Mirror with Compass and
Temperature Display (ifequipped)
Automatic Dimming
The automatic dimming feature is turned
on each time the vehicle is started. To
turn the feature off or back on, press
and hold the (On/Off) button forapproximately six seconds.
Compass and Temperature Display
Operation
To turn the compass and temperature
display on or off, briefly press the On/Offbutton.
To switch between Fahrenheit and
Celsius readings:
1. Press and hold the On/Off button for
approximately four seconds until thedisplay flashes F or C.
2.Briefly press the On/Off button again
to select Fahrenheit or Celsius. Your
selection will be set once the displaystops blinking.
To adjust for compass variance when
traveling on a longdistance trip or tocalibrate the compass, refer to yourOwner Manual.
See Section 2 of your Owner Manual.
CONVENIENCE
A number of audio controls can be
adjusted at the steering wheel.
+ – (Volume):Pull up on the + or – but
ton to increase or decrease the volume.
(Next/Previous):Press the up or
down arrow to go to the next or previous
radio station stored as a favorite or,when a CD is playing, to the next orprevious track.
SRCE (Source): Press this button
toswitch between AM, FM, XM (if
equipped), CD and AUX.
(Seek):Press this button to go to
the next radio station.
(
Mute/Voice Recognition):Press
this button to silence the system. Pressthe button again to turn on the sound.
Press and hold the button for one sec
ond to interact with the OnStar system.
See Section 3 of your Owner Manual.
Audio Steering Wheel Controls
(if equipped)

19
Press the (Heated Washer Fluid)
button, located below the climate controls on the instrument panel, to sprayheated washer fluid on the windshield.This will help to clear ice, tree sap orbugs from the windshield. A light on the
switch will flash while the washer fluid is
heating, which may take up to 40 seconds. The wipers will automatically turn
on for four cycles or until the button ispressed again.
See Section 3 of your Owner Manual.
The rear vision camera displays a view
of the area behind the vehicle on thenavigation screen when the vehicle isshifted into Reverse. Once shifted out ofReverse, the navigation screen willreturn to the last screen displayed afterapproximately 10 seconds.
To turn the camera on or off:
1.Shift into Park.
2. Press the Menu hard key to enter the
Menu options.
3.Press the Menu hard key to select
Display, or touch the Display screenbutton.
4. Touch the Rear Camera Options
screen button.
5.Touch the Rear Camera Image in
Reverse screen button.
To clean the camera lens, located above
the license plate, rinse it with water andwipe it with a soft cloth.
See Section 2 of your Owner Manual.
Your vehicle is equipped with an
Automatic Headlamp System, which
turns on the Daytime Running Lamps
(DRL) during the day and the head
lamps and other exterior lamps at night
or when necessary.
The system uses a light sensor, located
on top of the instrument panel, to determine light conditions. For proper systemoperation, avoid placing any objects on
or near the sensor.
Exterior Lamp Controls
The exterior lamps control knob is locat
ed on the instrument panel to the left ofthe steering wheel.
(Off):When operating in the AUTO
position, a momentary turn of the knob
to the Off position will turn off theAutomatic Headlamp System and allexterior lights, excluding the DRLs.
AUTO (Automatic):Automatically turns
on the DRLs in the daytime and theAutomatic Headlamp System at night or
when necessary.
(Parking Lamps):Manually turns
on parking lamps and taillamps.
(Headlamps):Manually turns on
the headlamps and other exterior lamps.
(Fog Lamps)(if equipped): Press
this button to turn the fog lamps on or
off.
Heated Windshield Washer Fluid
(if equipped)
Rear Vision Camera
(if equipped)
Automatic Headlamp System

Getting to Know YourYukon/Yukon Denali22
This feature uses ultrasonic sensors on
the rear bumpers to help you avoid col
liding with objects when parking the
vehicle. It operates only at speeds lessthan 3 mph.
The rear parking assist display is locat
ed near the rear window. The lights onthe display provide distance information.Lowtoned beeps play out of the rearspeakers (for objects near the rearbumper).
To turn off the system, press the disable
button located below the climate con
trols on the instrument panel. The indi
cator light will illuminate when the system is off.
See Section 3 of your Owner Manual.
The Universal Home Remote is a com
bined universal transmitter and receiverthat can activate up to three devices,such as garage door openers, entrydoor locks, gates and security systems.
It’s recommended that you read the
instructions in your Owner Manual com
pletely before attempting to program anyof the three channels on the Universal
Home Remote. The engine should be
turned off when programming theremote.
See Section 2 of your Owner Manual.
Ultrasonic Rear Parking Assist
(if equipped)
StabiliTrak is an advanced computer
controlled vehicle stability and tractionenhancement system that assists withdirectional control of the vehicle in
difficult driving conditions. It turns onautomatically every time you start your
vehicle.To limit wheelspin and help maintain directional control, you shouldalways leave the system on. However, if
your vehicle becomes stuck and rocking
StabiliTrak®– Stability Control
System (if equipped)
PERFORMANCE & MAINTENANCE
Universal Home Remote
(if equipped)
Note: Do not use the Universal Home
Remote with any garage door opener thatdoes not have the “stop and reverse” fea
ture or any opener manufactured beforeApril 1, 1982.
6Speed Automatic
Transmission Controls (Denali Models only)
The 6speed automatic transmission has
a unique gear range selection modecalled Driver Shift Control that enablesthe driver to select the range of gearsdesired for the current driving conditions,such as when driving on downhill grades.
To use this feature, move the shift lever
to the Manual (M) position and select alower or higher driving gear using the
+ / – button on the shift lever. The dis
play on the instrument panel cluster will
show the current gear selection.
Press the – (minus) side of the button to
downshift. When slowing to a stop, thevehicle will automatically downshift.
Press the + (plus) side of the button to
upshift. As vehicle speed increases, youwill need to manually upshift.
If current vehicle speed is too high or
too low for the requested gear, the shift
will not occur.
See Section 2 of your Owner Manual.

23
the vehicle is required, the system
should be turned off.
To turn off the traction control part of the
system, press the (StabiliTrak) button located below the climate controlson the instrument panel.
To turn off the traction control and stabil
ity enhancement systems, press andhold the button for five seconds.
When the system is turned off, the
StabiliTrak light will illuminate.
See Section 4 of your Owner Manual.
The Tire Pressure Monitor alerts you
when a significant reduction in pressureoccurs in one or more of your vehicle’s
tires by illuminating the (Low Tire
Pressure) warning light, which will remain
on until you correct the tire pressure.You
may also have a CHECK TIRE PRESSURE message appear on the DIC (ifequipped).
Correcting the Tire Pressure
When the low tire pressure warning light
illuminates, you must fill the tire to the
proper tire inflation pressure. The Tireand Loading Information label shows thecorrect inflation pressure for the tireswhen they’re cold. “Cold” means yourvehicle has been sitting for at least threehours or driven no more than one mile.
You can temporarily remove the DIC mes
sage by acknowledging it with your DIC
controls. However, at the next vehiclestartup, the DIC message will reappear ifthe tire pressure has not been corrected.
During cooler conditions, the low tire
pressure warning light may appear whenthe vehicle is first started and then turn
Tire Pressure Monitor
off as you start to drive the vehicle. This
could be an early indicator that your tirepressures are getting low and need tobe inflated to the proper pressure.
See Section 5 of your Owner Manual.
The Oil Life System calculates engine oil
life based on vehicle use and displays
CHANGE ENGINE OIL in the Driver
Information Center (DIC) when it’s nec
essary to change your engine oil and fil
ter. The Oil Life System should be reset
to 100% only following an oil change.
Reset the Oil Life System using the DIC:
1. Turn on the ignition.
2. Press the (Vehicle Information)
button until the DIC displays OIL LIFEREMAINING.
3. Press and hold the (Set/Reset)
button until 100% is displayed.
4. Turn off the ignition.
Reset the Oil Life System without the DIC:
1. Turn on the ignition, with the engine off.
2. Fully press and release the accelera
tor pedal slowly three times withinfive seconds.
3.If the CHANGE ENGINE OILmes
sage flashes, the system is reset;
otherwise, repeat the procedure.
4.Turn off the ignition.
See Section 5 of your Owner Manual.
Resetting the Engine
Oil Life System
Note: The Tire Pressure Monitor can
alert you about low tire pressure, but itdoesn’t replace normal monthly tiremaintenance.