fog GREAT WALL FLORID 2008 User Guide

Downloaded from www.Manualslib.com manuals search engine 241Vehicle Body
Front & Rear Window Glasses
Windshield removal
1. Use steel wire to strip the glass sealant from the four
sides of the windshield.
2. Remove the windshield and trim strip from the vehicle.
3. Remove the trim strip and inner rearview mirror from
the windshield.
4. Use a blade to remove the glass sealant on the end of
the glass.
5. Use a polisher to remove the glass sealant on the glass
window frame, and polish clean the glass sealant.
Rear window glass removal
1. Disconnect the battery's negative cable.
2. Disconnect the defogger electrical connector of the
rear window.
3. Use steel wire to strip the glass sealant off the rear
window glass.
4. Remove the rear window glass.
5. Use a blade to remove the glass sealant.
6. Use a polisher to remove the glass sealant on the
glass frame.
Rear window glass installation
1. Coat glass sealant primer on the rear door's sheet
metal seam and rear window glass.
2. Coat the rear window glass with glass sealant, glass
sealant height is 10±2 mm.
3. Install the rear window glass.
4. Use adhesive tape fix the rear window glass and back
door, and fix the rear window glass.
5. Connect the defogger electrical connector of the rear
window.
6. Connect battery's negative cable.
7. Remove the tape after the glass sealant has been on
24 hours.
Windshield installation
1. Install the trim strip and inner rearview mirror on the
windshield.
2. Coat the windshield frame and its edge with primer.
3. Use a glue gun to coat the windshield with glass
sealant, glass sealant height is 10±2 mm.
4 . U s e a d h e s i v e t a p e f i x t h e w i n d s h i e l d a n d t h e
windshield's outside sheet metal.
5. Remove the tape after the glass sealant has solidified
for 24 hours.
Windshield
Windshield trim strip
Inner rearview mirror
Defogger electrical connector
Rear window glass

Downloaded from www.Manualslib.com manuals search engine GWFLORID Maintenance Manual258
7. Disconnect the wire harness of the left & right fog lamps.
8. Remove the bumper attachments.
Remove the front bumper plastic support and energy absorb-
ing block from the vehicle body respectively.
9. Remove the bumper bracket.
Screw off the cross slot & concave hexagon head self-tapping
screw and large washer subassembly (Q2756319+Q422) on the
left / right side mounting bracket of the front bumper, and pull
the left / right side mounting bracket out.Front bumper body
Front bumper body
Front bumper energy absorbing block
Front bumper plastic support
Front bumper left side mounting bracket
Cross slot & concave hexagon head self-tapping screw and large washer subassembly