HONDA ACCORD 2004 CL7 / 7.G Manual Online

µµµ
µ
You can insert or
remove the key only in this position.
To turn the key, the shift lever must
be in Park, and you must push the
key in slightly. If the f ront wheels
are turned, the anti-thef t lock may
make it difficult to turn the key.
Firmly turn the steering wheel to the
left or to the right as you turn thekey.
The ignition switch has f our
positions: LOCK (0), ACCESSORY
(I), ON (II), START (III) You can
operate the audio system and the
accessory power sockets in this
position.
This is the normal key
position when driving. Several of the
lights on the instrument panel come
on as a test when you turn the
ignition switch f rom ACCESSORY
(I) to ON (II).
Use this position
only to start the engine. The switch
returns to ON (II) when you let go of
the key.
L OCK (0) A CCESSORY (I)
ON (II)
ST A RT (III)
Ignition Switch
Inst rument s and Cont rols82
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control.
Remove the key from the
ignition switch only whenparked.
——y

y
(
yy

You will hear a reminder beeper if
you leave the key in the ignition
switch in the LOCK (0) or
ACCESSORY (I) position and open
thedriver’sdoor.Removethekeyto
turn of f the beeper. The shif t lever
must be in Park bef ore you can
remove the key from the ignition
switch.To lock the driver’s door, pull and
hold either the inside or outside door
handle, then push the lock tab down.
Release the handle, then close the
door.Each f ront door has a master door
lock switch. Either switch locks and
unlocks all doors. Push the top of the
switch to lock all doors; push the
bottom to unlock them.
On all models except DX, you can
open or close the windows by using
the key in the driver’ s door (see
page ). To lock any passenger’s door when
getting out of the vehicle, push the
lock tab in and close the door.
101
U.S. DX On all models except U.S. DX
Door L ocks
Ignit ion Swit ch, Door L ocks
Inst rument s and Cont rols83
MASTER DOOR LOCK SWITCH
——y


y
(
yy

With the driver’s door open and the
key in the ignition, both door lock
switches are disabled. They are not
disabled if the driver’s door is closed.
Pushing the switch down on the
open passenger’s door will lock all
doors.
On Canadian DX models, all doors
canbelockedfromtheoutsideby
using the key in either f ront door. To
unlock only the driver’s door f rom
the outside, insert the key in the
driver’s door lock, turn the key and
releaseit.If youturnthekeyagain,
all doors will unlock. All f our doors
will unlock when you unlock the
passenger’s door with the key. On LX and EX models, all doors can
be locked f rom the outside by using
the key in the driver’s door. To
unlock just the driver’s door, turn the
keyandreleaseit.If youturnthe
key again, all doors will unlock.
L ockout Prevent ion
Door L ocks
Inst rument s and Cont rols84
——y

y
(
yy

µµ
You can open and close all power
windows from outside the vehicle
with the key. With the remote
transmitter, you can open the
windows. Refer to Power Windows
on page .
The childproof door locks are
designed to prevent children seated
in the rear f rom accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. With the
lever in the LOCK position, the door
cannot be opened f rom the inside
regardless of the position of the lock
tab. To open the door, pull the lock
tab up and use the outside door
handle. Press this button once to
lock all doors. Some exterior and
interior lights will f lash. You cannot
lock it if any door is not f ully closed
or key is in the ignition switch.
When you push LOCK twice within 5
seconds, you will hear a beep to
verify that the security system has
set. The ceiling light (if the ceiling light
switch is in the center position) will
come on when you press the
UNLOCK button. If you do not open
any door, the light stays on f or about
30 seconds, then f ades out. If you
relock the doors with the remote
transmitter before 30 seconds have
elapsed, the light will go of f
immediately.
Pressthisbuttononce
to unlock the driver’s door. Push it
twice to unlock the other doors. 99
On all models except U.S. DX
On the EX model
Setting the Childproof Door
Locks Remote Transmitter
LOCKUNL OCK
Childproof Door L ocks, Remot e T ransmit t er
Inst rument s and Cont rols85
PANIC
BUTTON
TRUNK
RELEASE
BUTTON UNLOCK/
WINDOW-
OPEN
BUTTON
LOCK
BUTTON
LEVER
——y

y
(
yy

µ
You cannot lock the doors with the
remote transmitter if any door is not
f ully closed or the key is in the
ignition switch.
If you unlock the doors with the
remote transmitter, but do not open
any of the doors within 30 seconds,
the doors automatically relock. On
the EX model, the security system
will also set. Pressthisbuttonfor
about one second to attract attention;
thehornwillsoundandtheexterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
other button on the remote
transmitter or turn the ignition
switch to ON (II). Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by a Honda dealer.
To open the trunk, push the Trunk
Release button f or approximately
one second.
The trunk will not open if the key is
in the ignition switch.
On all models except U.S. and Canada DX
On all models except U.S. and Canada DX
PA NIC
Remote Transmitter Care
Remote Transmitter
Inst rument s and Cont rols86
——y

y
(
yy

´
Battery type: CR1616
If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
To replace the battery:Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
Separate the transmitter by prying
its middle seam with your
f ingernail. Inside the transmitter, separate
the inner cover f rom the keypad
by releasing the two tabs on the
cover.
Remove the old battery from the
back of the inner cover, and note
the polarity. Make sure the
polarity of the new battery is the
same ( side f acing down), then
insert it into the back of the cover.
Install the parts in reverse order.
1. 2.
3. 4. 5.
Replacing the Transmitter Battery
Remote Transmitter
Inst rument s and Cont rols87
SCREWBATTERY
TAB
——y

y
(
yy

As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and (2) this device must accept anyinterf erence received, including
interf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f or
compliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not cause
interf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
Remote Transmitter
Inst rument s and Cont rols88
——y

y
(
y
y

Youcanopenthetrunkinthree
ways:Pull the trunk release handle to
the lef t of the driver’s seat.
Usethemasterkeytoopenthe
trunk lock. The valet key does not
work in this lock.
Press and hold the trunk release
button on the remote transmitter. To close the trunk, press down on
the trunk lid.
See page f or cargo loading and
weight limit inf ormation. Keep the
trunk lid closed at all times while
driving to avoid damaging the lid,
and to prevent exhaust gas from
getting into the interior. See
on page . To protect items in the trunk when
you need to give the key to someone
else:
Lock the trunk release handle
with the master key. Also make
sure the trunk pass-through cover
is locked (see page ).
Give the person the valet key.
(all models except U.S. DX) 1. 2.
56
174
97
Carbon
Monoxide Hazard
Trunk
Inst rument s and Cont rols89
Pull MASTER KEY
TRUNK RELEASE HANDLE MASTER KEY
——y


y
(
yy

As a saf ety f eature, your vehicle has
a release lever on the trunk latch so
the trunk can be opened f rom the
inside.To open the trunk, push the release
lever to the lef t.
Parents should decide if their
children should be shown how to use
this feature.
For more inf ormation about child
saf ety, see page .
18
Emergency T runk Opener
Trunk
Inst rument s and Cont rols90
——y

y
(
yy

After the seat reaches a comfortable
temperature, select LO by pushing
the back of the switch. This will keep
the seat warm.
In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat’s temperature drops.
In LO, the heater runs continuously.
It does not cycle with temperature
changes.Follow these precautions whenever
you use the seat heaters:
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current f rom the
battery.
If the engine is lef t idling f or an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting.
Both f ront seats are equipped with
seat heaters. The ignition switch
must be in the ON (II) position to
use them. The seat heater switch is
located on each f ront door. Push the
f ront of the switch, HI, to rapidly
heat up the seat.
On EX-V6 models and EX models with leather interior
Seat Heaters
Inst rument s and Cont rols91
——y

y
(
yy