display HONDA ACCORD COUPE 2001 CF / 6.G Service Manual

Security System
On EX and EX-V6 models

The security system helps to protect your car and valuables from theft.
The horn sounds and a combination of headlights, parking lights, side
marker lights and taillights flashes if
someone attempts to break into your
car or remove the radio. This alarm
continues for two minutes, then the system resets. To reset an alarming
system before the two minutes have
elapsed, unlock either front door
with the key or the remote transmitter.
The security system sets auto- matically fifteen seconds after you
lock the doors, hood, and trunk. For
the system to activate, you must lock
the doors from the outside with the
key, lock tab, door lock switch, or
remote transmitter. The security system light next to the driver's door
lock starts blinking immediately to show you the system is setting itself. SECURITY SYSTEM LIGHT
Once the security system is set, opening any door (without using the
key or the remote transmitter), or
the hood, will cause it to alarm. It also alarms if the radio is removed
from the dashboard or the wiring is cut. With the system set, you can still
open the trunk with the master key
or the remote transmitter without
triggering the alarm. The alarm will sound if the trunk lock is forced, or
the trunk is opened with the trunk

release handle.

The security system will not set if the hood, trunk, or any door is not
fully closed. If the system will not set,check the Door and Brake Lamp
Monitor on the instrument panel (see page 56), to see if the doors
and trunk are fully closed. Since it is
not part of the monitor display,
manually check the hood.
Do not attempt to alter this system
or add other devices to it.
Comfort and Convenience Features

Engine Oil

Recommended Oil Oil is a major contributor to your
engine's performance and longevity.
Always use a premium-grade 5W-20 detergent oil displaying the API
Certification Seal. This seal indicates
the oil is energy conserving, and that
it meets the American Petroleum
Institute's latest requirements.
Genuine Honda Motor Oil is the
preferred 5W-20 lubricant for your
vehicle. It is highly recommended that you use Genuine Honda MotorOil in your vehicle for optimum
engine protection. Make sure the API Certification Seal
says "For Gasoline Engines."
The SAE number tells you the oil's
viscosity or weight. Select the oil for
your vehicle according to this chart. 5W-20 oil is formulated for year-
round protection of your Honda, to
improve cold weather starting, and
to help your engine use less fuel.
If 5W-20 oil is not available, a 5W-30 oil may be used. However, it should
be replaced with 5W-20 at the next oil change.
Synthetic Oil
You may use a synthetic motor oil if it meets the same requirements
given for a conventional motor oil: it displays the API Certification Seal,
and it is the proper weight as shownon the chart. When using synthetic
oil, you must follow the oil and filter
change intervals given in the
maintenance schedule.
Additives Your Honda does not require any oiladditives. Additives may adversely
affect your engine's or transmission's
performance and durability.
Maintenance

API CERTIFICATION SEAL

Ambient Temperature

Battery

On EX and EX-V6 models

If your car's battery is disconnected
or goes dead, the audio system will
disable itself. The next time you turn
on the radio you will see "Code" in
the frequency display. Use the Preset buttons to enter the five-digit
code (see page 174 ).
Charging the battery with the cables
connected can seriously damage your
car's electronic controls. Detach the
battery cables before connecting the
battery to a charger.

Maintenance
The battery gives off explosive
hydrogen gas during normal
operation.
A spark or flame can cause the battery to explode with enough
force to kill or seriously hurt you.
Wear protective clothing and a
face shield, or have a skilled mechanic do the battery
maintenance.
NOTICE

Audio System
Operating the Radio
The ignition switch must be in
ACCESSORY (I) or ON (II) to
operate the audio system. Turn the
system on by pushing the PWR/
VOL knob. Adjust the volume by
turning the same knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is broad-
casting in stereo. Stereo
reproduction on AM is not available.

PWR/VOL KNOB
PRESET BUTTONS
TUNE KNOB
SCAN BUTTON
SEEK BUTTONS

AM BUTTON
Comfort and Convenience Features

B

Audio System
AUTO SELECT — If you are
traveling far from home and can no
longer receive the stations you
preset, you can use the Auto Select
feature to find stations in the local

area.

To activate Auto Select, press the
A. SEL button. A. SEL will flash in
the display, and the system will go
into scan mode for several seconds.
It automatically scans both bands,
looking for stations with strong
signals. It stores the frequencies of
six AM stations and twelve FM
stations in the preset buttons. You
can then use the preset buttons to
select those stations.
If you are in a remote area, Auto
Select may not find six strong AM
stations or twelve strong FM stations.
If this happens, you will see a "0"
displayed when you press any preset
button that does not have a station

stored.

Comfort and Convenience Features

A. SEL BUTTON
A. SEL INDICATOR

D

Audio System

Operating the CD Player
You operate the CD player with the
same controls used for the radio.
With the system on, insert the disc
into the CD slot. Push the disc in
halfway, the drive will pull it in the
rest of the way and begin to play.
The number of the track that is
playing is shown in the display.
You can also play 3-inch (8-cm) discs
without using an adapter ring. In all
cases, play only standard round discs.
Odd-shaped CDs may jam in the
drive or cause other problems.
When the system reaches the end of
the disc, it will return to the begin-
ning and play that disc again.
You can switch to the radio while a
CD is playing by pressing the AM or
FM button. Press the CD button to
return to playing the CD. The CD
will begin playing where it left off.
CONTINUED

Comfort and Convenience Features
CD SLOTSKIP BUTTONS
REPEAT BUTTONCD BUTTONRDM BUTTON

G

Audio System

If you turn the system off while a CD
is playing, either with the PWR/VOL
knob or by turning off the ignition,
the disc will stay in the drive. When
you turn the system back on, the CD
will begin playing where it left off.
Press the eject button to remove the
disc from the drive.
If you eject the disc, but do not
remove it from the slot, the system
will automatically reload the disc
after 15 seconds and put the CD
player in pause mode. To begin
playing the disc, press the CD button.
You can use the SKIP buttons while
a disc is playing to select passages
and change tracks.
To move rapidly within a track, press
and hold an appropriate SKIP button.
Press the button to move forward,or the button to move backward.
Release the button when the system
reaches the point you want.
Each time you press the button
and release it, the system skips
forward to the beginning of the next
track. Press and release the
button to skip backward to the
beginning of the current track. Press
and release it again to skip to the
beginning of the previous track.

REPEAT — To activate the Repeat

feature, press and release the Repeat

button. You will see REPEAT in the

display. The system continuously

replays the current track. Press the

Repeat button again to turn it off.

RANDOM PLAY — This feature,

when activated, plays the tracks on

the CD in random order, rather than

in the order they are recorded on the

CD. To activate Random Play, press

the RDM button. You will see RDM

in the display. The system will then

select and play tracks randomly.

This continues until you deactivate

Random Play by pressing the RDM

button again.
Comfort and Convenience Features

H

Audio System

CD Player Error Indications
If you see an error indication in the
display while operating the CD
player, find the cause in the chart to
the right. If you cannot clear the
error indication, take the vehicle to
your Honda dealer.
Comfort and Convenience Features

I

Audio System

CD Changer Error Indications
If you see an error indication in the
display while operating the CD
changer, find the cause in the chart
to the right. If you cannot clear the
error indication, take the vehicle to
your Honda dealer.

Comfort and Convenience Features

J

Audio System

The tape direction indicator will light
to show you which side of the
cassette is playing. The indicates
the side you inserted facing upward
is now playing. If you want to play
the other side, press the PROG

button.

Dolby noise reduction turns on when
you insert a cassette. If the tape was
not recorded with Dolby noise
reduction, turn it off by pressing the
NR button.
When the system reaches the end of
the tape, it will automatically reverse
direction and play the other side. If
you want to remove the cassette
from the drive, press the EJECT

button.

If you turn the system off while a
tape is playing, either with the PWR/
VOL knob or by turning off the
ignition, the cassette will remain in
the drive. When you turn the system
back on, the tape will begin playing
where it left off.
To switch to the radio or CD player
while a tape is playing, press the AM,
FM or CD button. To change back to
the cassette player, push the TAPE
button.

Tape Search Functions

With a cassette playing, you can use
the FF, REW, SKIP, or REPEAT
function to find a desired program.
FF/REW — Fast Forward and Re-
wind move the tape rapidly. To re-
wind the tape, push the REW button.
You will see REW in the display. To
fast forward the tape, push the FF
button. You will see FF displayed.
Press the PLAY button to take the
system out of rewind or fast forward.
If the system reaches the end of the
tape while in fast forward or rewind,
it automatically stops that function,
reverses direction, and begins to play.
Comfort and Convenience Features

L