light HONDA ACCORD COUPE 2009 8.G Quick Guide
[x] Cancel search | Manufacturer: HONDA, Model Year: 2009, Model line: ACCORD COUPE, Model: HONDA ACCORD COUPE 2009 8.GPages: 30, PDF Size: 2.46 MB
Page 1 of 30
Dash View/
Need to Know
Hood
Release
Trunk Release/Fuel Fill
Door Release Accessory
Power Sockets
Moonroof Switch
Power Mirrors
Indicator
Lights/GaugesHomeLink®Rear Window
Defogger
Climate Control
System
Seat HeatersParking Brake
Audio
System
Transmission
Power Door
Locks
Power
Windows
09 Accord Coupe InsideFront:09 Accord Sedan.qxd 6/19/2008 1:40 PM Pag\
e 1
Page 2 of 30
* Check the owner’s manual for additional information and instructions. Dash View/
Need to Know
Key/Remote
Transmitter
HornHeadlights/
Turn SignalsInstrument Panel
Brightness/
Trip MeterWindshield
Wipers/Washers
Cruise
ControlSteering Wheel
Adjustment
VSA Button
Navigation
Voice Controls
**
Remote Audio
Controls
**If equipped
Things You Need to Know
• See About This Quick Start Guide on the rear cover.
• See the owner’s manual for detailed information and instructions marked with an asterisk (*).
• Always check tire pressures when the tires are cold.
• Tire Pressure Monitoring System (TPMS) indicators.
• The malfunction indicator lamp may come on if the gas cap is not tighten\
ed at least 1 click.
• Location of the hood release lever (see Dash View).
09 AccordCoupe:09 Accord Coupe.qxd 6/19/2008 1:42 PM Page 2
Page 3 of 30
Inst Panel/TPMS/Cruise/Compass
Temperature
GaugeMessage in the Information Display
Check Fuel Cap: Fuel cap is missing or not
properly tightened. Check that the fuel cap
is installed and tightened at least one click.
Temperature Gauge: If the pointer is in the
red zone, turn off the engine immediately, or
as soon as safely possible*.
Instrument Panel Indicators
Indicators should go out shortly after
starting the engine. If an indicator stays on
or comes on while driving, follow the
instructions in the description.
• Red indicators are critical and require immediate attention.
• Amber indicators are urgent and require attention as soon as possible.
• Blue and green indicators are used for general information.
Charging system indicator:
Battery is not being charged; see
dealer as soon as possible.
Low oil pressure indicator: Low
oil pressure; turn the engine off as
soon as safely possible.
Security system indicator: Blinks
when the security system is armed.
Supplemental restraint system (SRS) indicator:
SRS malfunction; see dealer as soon as
possible.*
Seat belt reminder light: Fasten seat belts.
Parking brake and brake system indicator:
Parking brake on, low brake fluid level.
Door and trunk open monitor: Comes on if the
trunk lid is left open. Will go out after about 3
minutes, even if the lid is not closed.
Malfunction indicator lamp (CHECK engine
light): Engine or emissions system malfunction;
have dealer inspect the vehicle.
Maintenance minder indicator: A scheduled
maintenance is due; stays on if maintenance is
past due.
Fuel gauge/low fuel indicator
Note: It is important to see the Instruments and Controls section in the\
owner’s manual.
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 3
Page 4 of 30
PASSENGERAIRBAG
OFF
Immobilizer system indicator:
Flashes if an improperly coded key is
used in the ignition switch.
Cruise main indicator: Cruise
control is on and is waiting to be set.
Cruise control indicator: Cruise
control is set.
Lights on indicator: Indicates
parking lights or headlights are on.
ECO indicator (V6 models with
automatic transmission): Comes on
when the engine is performing at its
most economical level.
Turn signal/hazard warning
indicators
Fog lights on indicator (if equipped)
High beam indicator
Outside temperature indicator (if
equipped)/odometer: Displays
outside temperature or odometer
when Select/Reset knob is pressed.Low tire pressure indicator: One or
more of the vehicle’s tires is significantly
under-inflated. Stop, inspect all tires, and
add air as required.
Tire pressure monitoring system
(TPMS) indicator: TPMS malfunction;
have dealer inspect the vehicle.
Side airbag cutoff indicator*:
Passenger’s side airbag is off and will
not deploy during a crash.
Passenger airbag cutoff indicator*:
Passenger’s front airbag is off and will
not deploy during a crash.
Anti-lock brake system (ABS)
indicator: ABS malfunction; see your
dealer as soon as possible.
Vehicle stability assist (VSA
®)
activation indicator: A reminder that
the VSA is turned off. Flashes when
VSA is active.
Vehicle stability assist (VSA) system
indicator*: Possible VSA system
problem.
Daytime running lights (DRL)
indicator
ECO
* Check the owner’s manual for additional information and instructions.
09 Accord Coupe 03ab:ExtraPages.qxd 6/16/2008 1:42 PM Page a3
Page 7 of 30
Driver Controls
Headlights/Turn Signals Lever
Auto Lighting Off
The headlights, all exterior lights and all the instrument
panel lights turn off within 15 seconds after you remove
the key and close the driver's door.
Auto Lighting On (EX-L, EX-L V6 models)
Turns on the headlights and all other exterior lights when
low ambient lighting is detected.1.MIST
2. OFF
3. ADJ ring: Rotate to adjust wiper
interval speed.
4. Wiper ON: Push the lever down:
a. INT (1st detent): Wipers operate
intermittently.
b. LO (2nd detent): Long sweep
intervals.
c. HI(3rd detent): Short
sweep intervals.
5. Wiper and Washer ON : Pull back
and hold to clean the front windshield.
A
B
C
Windshield Wipers/Washers Lever
Pull up to apply.
To release, pull up
slightly, push button,
and lower completely.
Note: If you start to
drive with the parking
brake applied, a beep
sounds.
1. Turn signal
2. Off
3. Parking/indicator lights
4. AUTO (if equipped)
5. Headlights
6. High beams
7. Flash high beams
8. Fog lights OFF (if equipped)
9. Fog lights ON (if equipped)
Parking Brake
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 3:20 PM Page 5
Page 14 of 30
* Check the owner’s manual for additional information and instructions. Climate Control
Defroster button: Turns the defroster on
(indicator lit) and off to clear the windshield of fog
or frost.
Tip: If there is frost on the windows, select
Recirculation mode. If the windows are fogged,
select Fresh Air mode.
Rear window defogger button: Turns the
defogger on (indicator lit) and off to clear the rear
window of fog or frost.
Tip: The top part of the rear window is the radio
antenna; it may take longer for that part to clear.
AUTO button: Turns on the automatic climate
control system, which regulates the interior
temperature, mode controls, and fan speed.
“AUTO” is not displayed when the system is in
semiautomatic mode. If you press the mode
and/or fan control buttons while in AUTO mode,
the system is changed to semiautomatic mode.
The system no longer controls the mode controls
and fan speed.On models with navigation – In auto mode, the
system regulates each temperature based on
information from a sunlight sensor and the
navigation global positioning system (GPS). If one
side of the vehicle is getting direct sunlight, the
system will adjust that side to a lower temperature.
Tip: When you set the temperature to its lower
limit (LO) or its upper limit (HI), the system runs at
full cooling or heating capacity. It does not regulate
the interior temperature or fan speed.
Dual Mode Temperature Controls (if equipped)DUAL button: Allows for independent driver’s and
passenger’s side temperature control. When
selected, the indicator in the button is lit. Press
again to return temperature control to the driver
side control. The indicator will turn off.
Note: When defroster mode is selected, dual
mode function is cancelled.
OFF button: Completely turns off the climate
control system.
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 12
Page 16 of 30
SOUND AdjustmentSound level adjustment is accessed by pressing
the SOUND button. On EX and EX-L models, the
selector knob (non-navigation models) can be
used. For these models, do this:
1. Press and release the MENU button.
2. Turn the selector knob to move to any of these settings:
BASS TREBLE FADER BALANCE SUBW (EX-
L only) SVC CLOCK ADJUST (on 6-CD system, this is
accessed by the MENU button).
3. Press the selector knob to choose the desired setting.
4. Turn the selector knob to adjust the setting up or down.
5. Press MENU to return to the original display.
Using the Remote Audio Controls
VOL buttons: Adjusts the
volume.
MODE button: Changes
the system to the next
mode: AM/FM1/FM2/CD/
XM1/XM2.
CH buttons
Radio: • Press and release to change to the next or previous preset station.
• Press and hold until you hear a beep. The next station (+ or -) is selected.
CD: Skips to the beginning of the next track or
the start of the current track.
* Check the owner’s manual for additional information and instructions.
(EX, EX-L display shown)
Audio DisplayAudio information is shown in the center display.
Note: With headlights on, the instrument panel
brightness control knob can be used to adjust
audio illumination.
Selector Knob/Interface Dial (if equipped)
Most audio system functions can be controlled by
standard controls. You can access some audio
and navigation functions by using the selector
knob/interface dial on the audio system. Press
ENTER to select an item.
Interface Dial (models with Navigation)
The dial consists of:
• KNOB: Turns left and right to scroll through the display items and adjust the levels.
• SELECTOR (ENTER): Use to select items.
(Navigation display shown)
Selector KnobInterface Dial
Enter
Knob
Selector
09 Accord Coupe 13ab:ExtraPages.qxd 6/16/2008 1:43 PM Page a13
Page 24 of 30
* Check the owner’s manual for additional information and instructions. HFL/
HomeLink
®
Press and hold the button on the
remote and the HomeLink button at
the same time. Then, while
continuing to hold the HomeLink
button, press and release the button
on the remote every 2 seconds.
Does the LED blink at a faster rate within 20
seconds?
Press and hold the
HomeLink button
again. Training
complete
YES
NO
HomeLink indicator
flashes for 2 seconds,
then remains on. HomeLink LED
remains on.
YES
NO YES
NO
Position the remote transmitter you
wish to link 1–3 inches from the
HomeLink button you want to program.1
Press and hold the desired HomeLink
button and the button on the remote
transmitter you wish to link.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
2
aThe remote has a rolling code.
Press the “learn” button on the
remotely controlled device (e.g.,
garage door opener).
Press the programmed HomeLink
button again; the remotely
controlled device should operate. Within 30 seconds, press and hold
the programmed HomeLink button
for 2 seconds.a
Press and hold the programmed
HomeLink button for about a
second.
Does the device (garage door opener) work?
3
b
4
5
Training a Button
Indicator remains
on for about 25
seconds (standard
transmitter). Indicator flashes rapidly
for 2 seconds, then
remains on for about 23
seconds (rolling code
transmitter).
Press and hold the desired
HomeLink button until the HomeLink
indicator begins to flash slowly.
When the indicator begins to flash
slowly, continue to hold the HomeLink
button and follow steps 1– 4 under
Training a Button.1
2
Retraining a Button
Erasing CodesTo erase codes stored in all buttons,
press and hold the two outer buttons until
the HomeLink indicator begins to flash
(about 10 to 20 seconds), then release
the buttons.
You should erase all three codes before
selling the vehicle.
If you have any problems programming
HomeLink, see the owner's manual included with
the device you are trying to program, or call
HomeLink at 1-800-355-3515 or go online to
www.homelink.com .
HomeLink®(if equipped)The HomeLink® Universal Transceiver built into your vehicle can be programmed to operate up to th\
ree remote
controlled devices around your home, such as garage doors, lighting, or \
home security systems.
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 16
Page 25 of 30
Navigation/
Voice Control
Screen: All selections and instructions are displayed
on the screen. The display is not a “touch screen” –
you enter information into the system either by voice
or by using the Interface Dial.
Tip: Clean the screen with a soft, damp cloth, and
a mild cleanser intended for eyeglasses or
computer screens.
AUDIO button: Press to display the audio screen.
MAP/GUIDE button: Displays the map. When en
route, switches the display between the map and
guidance screens.
MENU button: Displays the “Enter a destination by”
screen. When en route, displays the route options on
the MENU screen.
SETUP button: Displays the Setup screen to change
and personalize information in the system.
INFO button: Displays the screen for selecting
Cellular Phonebook Voice Command Help, Map
Legend, Calendar, Calculator, and Key to Zagat
Ratings. More options are available by moving the
Interface Dial to the right.
Interface Dial/ENTER button: Moves left, right, up,
and down. Use to move the highlighting around the
display, to scroll through lists, or to look around a
displayed map. Push in to enter the selection into the
system.
CANCEL button: Cancels the current screen and
returns to the previous screen.
Display mode ( *) button:
Switches the display
between Day mode, Night mode, and OFF.
Navigation SystemSee the navigation system manual for more
information.
CANCEL button
SETUP button
INFO button Interface Dial/
ENTER button
MENU button
AUDIO
button MAP/GUIDE
button Lower Display Screen
Display mode
button
PASSENGER’S
TEMPERATURE
DRIVER’S TEMPERATURE
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 17