lock HONDA ACCORD COUPE 2009 8.G Quick Guide

Dash View/
Need to Know
Hood
Release
Trunk Release/Fuel Fill
Door Release Accessory
Power Sockets
Moonroof Switch
Power Mirrors
Indicator
Lights/GaugesHomeLink®Rear Window
Defogger
Climate Control
System
Seat HeatersParking Brake
Audio
System
Transmission
Power Door
Locks
Power
Windows
09 Accord Coupe InsideFront:09 Accord Sedan.qxd 6/19/2008 1:40 PM Pag\
e 1

PASSENGERAIRBAG
OFF
Immobilizer system indicator:
Flashes if an improperly coded key is
used in the ignition switch.
Cruise main indicator: Cruise
control is on and is waiting to be set.
Cruise control indicator: Cruise
control is set.
Lights on indicator: Indicates
parking lights or headlights are on.
ECO indicator (V6 models with
automatic transmission): Comes on
when the engine is performing at its
most economical level.
Turn signal/hazard warning
indicators
Fog lights on indicator (if equipped)
High beam indicator
Outside temperature indicator (if
equipped)/odometer: Displays
outside temperature or odometer
when Select/Reset knob is pressed.Low tire pressure indicator: One or
more of the vehicle’s tires is significantly
under-inflated. Stop, inspect all tires, and
add air as required.
Tire pressure monitoring system
(TPMS) indicator: TPMS malfunction;
have dealer inspect the vehicle.
Side airbag cutoff indicator*:
Passenger’s side airbag is off and will
not deploy during a crash.
Passenger airbag cutoff indicator*:
Passenger’s front airbag is off and will
not deploy during a crash.
Anti-lock brake system (ABS)
indicator: ABS malfunction; see your
dealer as soon as possible.
Vehicle stability assist (VSA
®)
activation indicator: A reminder that
the VSA is turned off. Flashes when
VSA is active.
Vehicle stability assist (VSA) system
indicator*: Possible VSA system
problem.
Daytime running lights (DRL)
indicator
ECO
* Check the owner’s manual for additional information and instructions.
09 Accord Coupe 03ab:ExtraPages.qxd 6/16/2008 1:42 PM Page a3

* Check the owner’s manual for additional information and instructions. Inst Panel/TPMS/Cruise/Compass
Cruise Control
Set/Decel button: Sets cruise control (CRUISE
CONTROL indicator lit) if speed is above 25 mph,
or decreases the set speed if cruise control is set.
Res/Accel button: Resumes set speed if the
cruise control was canceled, or increases set
speed if cruise control is set.
Cancel button: Cancels cruise control. It does not
turn off the cruise control system. You can resume
a set speed if the cruise control was canceled. You
can also cancel the cruise control by tapping the
brake pedal.
Setting the Clock
(without Navigation)
1. With the ignition ON (II), press the CLOCK button until you hear a beep.
2. Press and hold the H button (Preset 4) to set the hour.
3. Press and hold the M button (Preset 5) to set the minutes.
4. Press the CLOCK button again.
Note: On vehicles with navigation, the clock is set
automatically by the navigation system. Cruise control master
button:
Turns the cruise
control system on
(CRUISE MAIN indicator
lit) and off. It does not
set the cruise control.
Compass Operation(EX-L, EX-L V6 w/o Navi)Your vehicle is equipped with a self-calibrating
compass system. Overall operation of this
system can be affected when you drive:
• Near power lines or stations
• Across bridges
• Through tunnels
• Over railroad crossings
• Past large vehicles
• Near large objects that can cause a magnetic
disturbance.
It can also be affected by accessories such as
antennas and roof racks that are mounted by
magnets.
Compass Zone Selection
In most areas, there is a variation between
magnetic north and true north. Zone selection
is required so the compass can compensate for
this variation. See the owner’s manual for zone
selection information.
Calibration
At times, the compass may need to be
manually calibrated after exposure to a strong
magnetic field. If the compass seems to be
continuously showing the wrong direction and
is not self-calibrating, or if the compass display
is blinking with the CAL indicator on, follow the
calibration procedure found in the owner’s
manual.
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 4

* Check the owner’s manual for additional information and instructions. Driver Controls
P Park: Transmission
is locked.
R Rerverse
N Neutral: Transmission
is not locked; use brake
pedal or parking brake.
D Drive: Normal driving.
D3 Third: 1st three gears
only.
2 Second: Transmission
is locked in 2nd gear.
1 First: Transmission
is locked in 1st gear.
Tip: The ignition must be ON (II) and the
brake pedal pressed to shift out of Park.
D3
Button
Automatic TransmissionTilt/Telescopic Steering Wheel
Adjust the steering
wheel (up, down,
in or out) to the
desired position.
Pull the lever underside the steering column toward you.
Push the lever to fully lock it in place.
Manual Transmission
The vehicle is
equipped with a clutch
interlock switch. Push
the clutch pedal all
the way down when
starting the engine. 1. With the ignition ON (II),
move the switch to L (driver’s
side) or R (passenger’s side).
2. Push the edge of the switch to adjust the mirror right, left,
up, or down.
3. When finished, move the switch back to the center (off)
position.
Power Mirrors
Tip: If equipped, the outside mirror heaters
can be turned on by pressing the heated
mirror button.
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 6

Unlock button:
Press once to
unlock the driver’s
door. Press again
to unlock the
passenger’s door.
Continue to hold
the button on the
second press to
open the windows
and moonroof;
release the button
to stop.
Tip: If you do not open a door within 30 seconds, the
doors relock.
Lock button: Press to lock both doors. Press again
and a beep verifies that the doors are locked.
Tip: The doors will not lock if any door is not fully
closed or the key is in the ignition. The beep will not
sound if both doors, the hood, and the trunk are not
fully closed.
Trunk release button: Press and hold until the trunk
opens.
Panic button: Press and hold for two seconds to turn
on. Press any button on the remote transmitter or turn
the ignition to ON (II) to turn off. The panic mode turns
off automatically after 30 seconds.
Tip: The panic mode will not work if the ignition is in
ON (II).
Locks/Windows/
VSA®/Moonroof
Power Door Locks with Auto Window
Open and Close Feature
• The master lock switch locks and unlocks both doors.
• Pull back on the driver’s door lock tab to lock both doors. Push forward on the tab to unlock
only the driver’s door. The lock tab on the
passenger’s door locks and unlocks only that
door.
Unlock: To unlock only the driver’s door from
outside, turn the key to the right and release.
To unlock the passenger’s door, turn the key
again. Continue to hold the key on the second
turn to open the windows and moonroof;
release to stop.
Lock: To lock both doors from outside, turn
the key to the left and release. Turn the key
again and hold to close the windows and
moonroof; release to stop.
Master Switch
Lock
UnlockLock
Ta b
Red
Indicator
Lock
Unlock
Key/Remote Transmitter
Lock
Button
Panic
ButtonTrunk
Release
Button
Unlock
Button
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:57 PM Page 7

* Check the owner’s manual for additional information and instructions. Locks/Windows/VSA
®/Moonroof
Power Windows
• The driver’s and passenger’s (if equipped) windows have an Auto Down and Auto Up
function. Push the switch firmly down to the
second detent and release it to fully lower the
window. Pull the switch firmly back and release
it to fully raise the window. The first detent is
used to open or close the window to the
desired position.
• The main button controls power to the passenger’s window. Push down on the button
and the passenger’s window cannot be opened
or closed. The button’s indicator will come on.
Main
ButtonTip: The power
windows can be
operated for
10 minutes after the
ignition is turned off.
This is cancelled by
opening either door.
Tip:The moonroof
operates for 10
minutes after the
ignition switch is
turned off. This is
cancelled by opening
any door.
Moonroof (if equipped)
• Open: Pull back fully, then release (auto open),
or until the desired position is reached.
• Close: Push forward fully, then release (auto
close) or until the desired position is reached.
• Tilt: Push up on the middle of the switch until
the desired position is reached.
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 8

Seats
Power Front Seats (if equipped)Driver’s Seat Height Adjustment (if equipped)
12
• Pull up and releasethe lever repeatedly
to raise the seat to
the desired height.
• Push down and release the lever
repeatedly to lower
the seat to the
desired height.
•Driver’s and passenger’s
seat: Moves the seat
forward and backward.
• Driver’s and passenger’s
seat: Adjusts the seat-back
angle forward or backward.
• Driver’s seat only: 1
moves the front of the seat
up or down. 2 raises or
lowers the whole seat.
• Driver’s seat only: Adjusts
the whole seat up and
forward or down and back.
• Driver’s Power Lumbar (if
equipped): Press either
side of the bar to increase
or decrease lumbar support.
• Pull up on the bar under the seat cushion’s front
edge to move the seat
forward and backward.
Release the bar to lock
the seat into position.
• Pull up on the lever on the outside of the seat to
change the angle of the
seat-back. Release the
lever to lock the seat-
back into position.
Manual Seat Adjustment
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 9

* Check the owner’s manual for additional information and instructions.
Seats
Folding Rear Seat
The back of the rear seat folds down, giving
you direct access to the trunk. The seat-back
can be released from inside the trunk.
Tip: When storing cargo,
you can move the rear
center shoulder belt out
of the way by removing
the belt from the guide.
1. Pull the release handle, located
inside the trunk
on the driver’s
side.
2. Fully lower the rear headrests.
3. From inside the vehicle, pull
forward on the
rear seat-back.
4. To lock the seat- back upright,
push it firmly
against the trunk
panel. Make sure
it is latched in
place by pulling
on the top of the
seat.
Seat Heaters (if equipped)
Push the right of the switch (HI indicator lit) to heat
up the seat. After the seat reaches a comfortable
temperature, set the heat to low by pushing the left of
the switch (LO indicator lit).
• In HI, the heater turns off when the seat getswarm, and turns back on after the seat temperature
drops. It continues to cycle as long as you leave it
set on HI.
• In LO, the heater runs continuously. It does not cycle with temperature changes.
Note: Because of sensors for the side airbag system,
there is no heater in the passenger’s seat-back. Only
the seat bottom contains a heater.
Tip: The seat heater
switches do not turn off
automatically when the
ignition is turned off. The
seat heaters will come
back on when the
ignition is turned to ON
(II) unless the seat
heater switches are
turned off.
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 10

SOUND AdjustmentSound level adjustment is accessed by pressing
the SOUND button. On EX and EX-L models, the
selector knob (non-navigation models) can be
used. For these models, do this:
1. Press and release the MENU button.
2. Turn the selector knob to move to any of these settings:
BASS TREBLE FADER BALANCE SUBW (EX-
L only) SVC CLOCK ADJUST (on 6-CD system, this is
accessed by the MENU button).
3. Press the selector knob to choose the desired setting.
4. Turn the selector knob to adjust the setting up or down.
5. Press MENU to return to the original display.
Using the Remote Audio Controls
VOL buttons: Adjusts the
volume.
MODE button: Changes
the system to the next
mode: AM/FM1/FM2/CD/
XM1/XM2.
CH buttons
Radio: • Press and release to change to the next or previous preset station.
• Press and hold until you hear a beep. The next station (+ or -) is selected.
CD: Skips to the beginning of the next track or
the start of the current track.
* Check the owner’s manual for additional information and instructions.
(EX, EX-L display shown)
Audio DisplayAudio information is shown in the center display.
Note: With headlights on, the instrument panel
brightness control knob can be used to adjust
audio illumination.
Selector Knob/Interface Dial (if equipped)
Most audio system functions can be controlled by
standard controls. You can access some audio
and navigation functions by using the selector
knob/interface dial on the audio system. Press
ENTER to select an item.
Interface Dial (models with Navigation)
The dial consists of:
• KNOB: Turns left and right to scroll through the display items and adjust the levels.
• SELECTOR (ENTER): Use to select items.
(Navigation display shown)
Selector KnobInterface Dial
Enter
Knob
Selector
09 Accord Coupe 13ab:ExtraPages.qxd 6/16/2008 1:43 PM Page a13