reset HONDA ACCORD HYBRID 2023 Owners Manual

27
Quick Reference Guide
Features (P 219)
Audio Remote Controls
(P 224)
●VOL(+/VOL( - (Volume) Switch
Press to adjust the volume up/down.
●Left Selector Wheel
When selecting the audio mode
Roll up or down to select Audio on the
driver information interface, and then
press the left selector wheel.
/ (Seek/Skip) Buttons
Left Selector Wheel VOL
(
+/VOL( - (Volume)
Switch
FM
AM
USB
Bluetooth ®
Apps
(Apple CarPlay/Android Auto)
Roll up or down: To cycle through the
audio modes, roll up or down and then
press the left selector wheel:
Alexa
Customize display
●/ (Seek/Skip) Buttons
Radio: Press / to change the preset station.
iPod, USB device, Bluetooth® Audio or
Smartphone Connection:
Press / to skip to the
beginning of the next song or
return to the beginning of the
current song.
USB device: Press and hold / to
change a folder.
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book 27 ページ ２０２２年１０月１３日　木曜日 　午後４時５０分

uuChild Safety uSafety of Infants and Small Children
82
Safe DrivingA child seat can be installed with a lap/should er belt in any rear seat or, if absolutely
necessary, the front passenger seat. 1.Place the child seat on the vehicle seat.
2. Route the seat belt through the child seat
according to the seat manufacturer’s
instructions, and insert the latch plate into
the buckle.
u Insert the latch plate fully until it clicks.
3. Slowly pull the shoulder part of the belt all
the way out until it stops. This activates the
lockable retractor.
4. Let the seat belt retract a few inches and
check that the retractor has switched
modes by pulling on the webbing. It should
not pull out again until it is reset by
removing the latch plate from the buckle.
u If you are able to pull the shoulder belt
out, the lockable retractor is not
activated. Slowly pull the seat belt all the
way out, and repeat steps 3 – 4.
■Installing a Child Seat with a Lap/Shoulder Seat Belt1Installing a Child Seat with a Lap/Shoulder Seat Belt
A child seat that is not properly secured will not
adequately protect a child in a crash and may cause
injury to the child or other vehicle occupants.
23 ACCORD 4D US HEV MAP-3130B6000.book 82 ページ ２０２２年１０月１３日　木曜日 　午後４時５０分

121
uuGauges and Displays uDriver Information Interface (Right Side Area)
Continued
Instrument Panel
Press the right selector wheel to switch between trip meter A and trip meter B.
■Trip meter
Shows the total number of miles or kilomete rs driven since the last reset. Meters A
and B can be used to measure two separate trips.
Resetting a trip meter
To reset the trip meter, display it, press and hold the right sele ctor wheel, and then
select Reset.
u The trip meter is reset to 0.0.
■Range/Fuel/Trip Meter
Trip Meter A Range
Average Fuel Economy
Instant Fuel
Economy Trip Meter B
23 ACCORD 4D US HEV MAP-3130B6000.book 121 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

uuGauges and Displays uDriver Information Interface (Right Side Area)
122
Instrument Panel
■Average fuel economy
Shows the estimated average fuel economy of each trip meter in mpg or l/100 km.
The display is updated at set intervals. Wh en a trip meter is reset, the average fuel
economy is also reset.
■Instant fuel economy
Shows the instant fuel economy as a bar graph in mpg or l/100 km.
■Range
Shows the estimated distance you can travel on the remaining power and fuel. This
estimated distance is based on the vehicle’s current fuel economy.
1 Average fuel economy
You can change when to reset the average fuel
economy.
2 Customized Features P. 318
1Range
The driving range displayed is only an estimate and
may differ from the actual distance the vehicle can
travel.
23 ACCORD 4D US HEV MAP-3130B6000.book 122 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

uuGauges and Displays uDriver Information Interface (Right Side Area)
124
Instrument Panel
■Trip meter
2 Trip meter P. 121
■Elapsed time
Shows the time elapsed since Trip A or Trip B was reset.
■Average speed
Shows the average speed in mph or km/h since Trip A or Trip B was reset.
■Maps
Shows Google Maps screen.
2 Google Maps P. 288
■Compass/Turn-by- Turn Direction
The compass screen and turn-by-turn di rections appear based on the driving
guidance provided by Apple CarPlay or Android Auto.
2 Apple CarPlay P. 273
2 Android AutoTM P. 280
■Navigation
1Elapsed time
You can change when to reset the elapsed time.
2 Customized Features P. 318
1Average speed
You can change when to reset the average speed.
2 Customized Features P. 318
1Navigation
You can select whether to have the turn-by-turn
display come on or not dur ing the route guidance.
2 Customized Features P. 318
Turn-by-turn directions may not be available for all
apps.
Models with Google built-in
All models
23 ACCORD 4D US HEV MAP-3130B6000.book 124 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

Continued127
uuGauges and Displays uDriver Information Interface (Right Side Area)
Instrument Panel
■The Driver Attention Monitor resets when:
• The power system is turned off.
• The driver unfastens the seat belt and ope ns the door while the vehicle is stopped.
■For the Driver Attention Monitor to function:
• The vehicle must be traveling above 25 mph (40 km/h).
• The electric power steering (EPS) system indicator must be off.
■Depending on driving conditions or other factors, the Driver Attention
Monitor may not function in the following circumstances:
• The steering assist function of the Lane Keeping Assist System (LKAS) is active.
2Lane Keeping Assist System (LKAS) P. 445
•The condition of the road is poor; e. g., the surface is unpaved or bumpy.
• It is windy.
• The driver is frequently op erating the vehicle in an assertive manner, such as
changing lanes or accelerating.
■Customizing
You can change the Driver Attention Monitor settings. Select Tactile And Audible
Alert , Tactile Alert , or Off.
2Customized Features P. 318
1For the Driver Attention Monitor to function:
The bars on the driver information interface remain
grayed out unless the Driv er Attention Monitor is
functioning.
23 ACCORD 4D US HEV MAP-3130B6000.book 127 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

uuGauges and Displays uHead-Up Display*
138
Instrument Panel
■Adjusting the head-up display brightness
Roll the right selector wheel to scroll to select HUD brightness, then press the right
selector wheel.
Brighten: Roll the right selector wheel up.
Dim : Roll the right selector wheel down.
Press the right selector wheel to exit.
■Adjusting the head-up display height
Roll the right selector wheel to scroll to select HUD height, then press the right
selector wheel.
Raise the head-up display : Roll the right selector wheel up.
Lower the head-up display : Roll the right selector wheel down.
Press the right selector wheel to exit.
■Adjusting the head-up display angle
Roll the right selector wheel to scroll to select HUD rotation, then press the right
selector wheel.
Rotate the head-up display clockwise : Roll the right selector wheel down.
Rotate the head-up di splay counterclockwise : Roll the right selector wheel up.
Press the right selector wheel to exit.
1 Head-Up Display Settings
When you unlock and open the driver’s door with a
remote transmitter or keyless access system, the
head-up display adjusts auto matically to one of the
two preset positions.
23 ACCORD 4D US HEV MAP-3130B6000.book 138 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

Continued151
uuLocking and Unlocking the Doors uLocking/Unlocking the Doors from the Outside
Controls
The vehicle will automatically lock after you
lock the doors in advance then close the
doors.
Activate lock presetting after closing the
driver’s door.
1. Touch the door lock sensor or press the lock
button on the remote transmitter.
u Alert sounds and lock presetting is
activated.
2. Close all the doors.
u Some exterior lights flash and a beeper
sounds when vehicle locks.
Make sure the doors are locked before
moving away from the vehicle.
■Lock Presetting1 Lock Presetting
Lock presetting will be re set if a door is opened
before the vehicle ha s locked completely.
Before locking a door, make sure that the key is not
inside the vehicle.
You can turn this function on and off. 2 Customized Features P. 318
Door Lock Sensor
23 ACCORD 4D US HEV MAP-3130B6000.book 151 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

184
uuOperating the Switches Around the Steering Wheel uDriving Position Memory System*
Controls
Driving Position Memory System*
You can store two driver’s seat positions (except for power lumbar) with the driving
position memory system.
When you unlock and open the driver’s door with a keyless remote or keyless access
system, the seat adjusts to retracted posi tions of one of the two preset positions
automatically.
• The DRIVER 1 and DRIVER 2 transmitters move the driver’s seat to the preset
seat position that was last used via that respective transmitter.
The driver’s seat moves rearward depending
on the set seating position once you
•Stop the vehicle.
• Put the transmission in
(P.
• Set the power mode to VEHICLE OFF.
• Open the driver’s door.
Once the power mode is in the ACCESSORY
position, the driver’s seat moves forward to
the DRIVER 1 or 2 preset position.
1 Driving Position Memory System*
Using the audio/informati on screen, you can disable
the automatic seat adjustment function. 2 Customized Features P. 318
The driver’s seat easy exit feature can be turned On/
Off .
2 Customized Features P. 318
System Operation
The system will not operate if:
•Either memory button is pre ssed while the seat is in
motion.
•The seat position is adju sted while in operation.
•Either of the memorized positions is set fully to the
rear.
The system may not recognize a key if:
•The key is in close proximity to a cell phone or other
wireless device.
•Both keys are in the vehicle at the same time.
•The Driving Position Memory System is disabled in
customized features.
•Opening driver’s door wi thout fully grabbing the
door handle.
Multiple separate accounts can be created for each
owner of a transmitter.
See the following page for details. 2 Registering a User P. 292
DRIVER 1 DRIVER 2
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book 184 ページ ２０２２年１０月１３日　木曜日　午後４時５０分

Continued207
uuInterior Convenience Items uOther Interior Convenience Items
Controls
■When charging does not start
Perform one of the solutions in the following table.
IndicatorCauseSolution
Green &
AmberBlinking
simulta- neously
There is an obstacle(s) between
the charging area and the
device.Remove the
obstacle(s).
The device is not within the
charging area. Pick up and reset the
device to the center of
the charging area
where is located.
The temperature of the wireless
charger pad increases. Temporarily suspend
charging the device.
Wait for the
temperature to drop
and attempt to charge
the device again.
AmberBlinkingThe wireless charger is faulty.Contact a dealer for
repairs.
1
Wireless Charger*
This system consumes a lot of power. Do not use the
system for a long time when the power system is off.
This may weaken the 12-volt battery, making it
difficult to turn the power system on.
When using the wireless charger, check the user’s
manual that came with th e compatible device you
want to charge.
3CAUTION
Metal objects between the charge pad and
the device to be charged will get hot and
can burn you.
• Always remove foreign objects from the
charge pad before charging the device.
• Be sure the surface is clear of dust and
other debris before charging.
• Do not spill liquids (e.g., water, drinks,
etc.) on the charger and the device.
• Do not use oil, grease, alcohol, benzine,
or thinner for cleaning the charge pad.
• Do not cover the system with towels,
clothing, or other objects while charging.
• Avoid spraying aerosols which may come
in contact with the charge pad surface.
* Not available on all models
23 ACCORD 4D US HEV MAP-3130B6000.book 207 ページ ２０２２年１０月１３日　木曜日　午後４時５０分