HONDA ACCORD SEDAN 2007 Owner's Manual (in English)

Turning the fan speed control dial all
the way to the left shuts the system
off. When the climate control system is
turned off, the temperature in the
upper display will also turn off.
To
keep stale air and mustiness
from collecting, you should have
the fan running at all times.
Keep
the system off for short
periods only.
If
you press OFF, the climate control
system shuts off.
Press
the OFF button. However, a
lack of airflow can cause the
windowsto fogup.Youshouldkeep
the fan on at all times so stale air and
moisture do not build up in the
interior and cause fogging.
You
can manually select various
functions of the automatic climate
controlsystemwhenitisinAUTO.
All other features remain
automati cally controlled.
Making any manual selection causes
thewordAUTOinthedisplaytogo
out.
If you press the A/C button next to
the display, the manual selections
will show in the display. Making any
manual selection causes the
indicator in the AUTO button to turn
off.
The
system automatically selects the
proper mix of conditioned and/or
heated air to raise or lower the
interior temperature to the
temperature you selected.
If you set the temperature to its
lowest limit (Lo), or its highest limit
(Hi), the system runs at full cooling
or heating only. It does not regulate
the interior temperature.
In cold weather, the fan will not
come on automatically until the
heater starts to develop warm air.
When
the indicator in the Dual button is on,
the driver’s side and passenger’s side
temperature can be controlled
independently (see page ). 111
With navigation system
D ua l T e m pe r at ur e C on t ro l EX-L and EX-V6 without navigation
system
Except EX and EX-V6
EX-L and EX-V6 with navigation system
Vents, Heating, and A/C
To Turn Everything Off
Manual Operation
110
µ µ
µ

Without navigation systemWith navigation system
EX-L and EX-V6
Your vehicle has two temperature
control dials, one f or the driver, and
one f or the f ront passenger.
Push AUTO or . The selected
temperatures appear in the upper
display. For vehicles with navigation
system, when the indicator in the
DUALbuttonisoff,youcanadjust
both sides to the same temperature
by adjusting the driver’s side
temperature control dial or buttons. Thedriver’ssideandthepassenger’s
side can be controlled independently
by adjusting these dials or buttons
when the green indicator in the
DUAL button is lit. Your vehicle has four temperature
control buttons, two f or the driver,
and two f or the passenger.
CONT INUED
Dual Temperature Control
T emperat ure Cont rol Dials/But t ons
Features
111
DUAL BUTTON
Without navigation system
DUAL BUTTON
DRIVER’S SIDE
TEMPERATURE
CONTROL BUTTONS PASSENGER’S SIDE
TEMPERATURE
CONTROL BUTTONS
With navigation system
DRIVER’S SIDE
TEMPERATURE
CONTROL DIAL
PASSENGER’S SIDE
TEMPERATURE
CONTROL DIAL

To set the driver’s side temperature
to a different value than the
passenger’s, press the DUAL button,
then turn the driver’s control dial or
press the or buttons on the
driver’s side. To set the passenger’s
side to a dif f erent value than the
driver’s, turn the passenger’s control
dial or press the or buttons on
the passenger’s side. You can adjust
the passenger’s side without
pressing the DUAL button first.
When you set the temperature to its
lower or upper limit, it is displayed asor .
Dual Temperature Control
112
DRIVER’S SIDE PASSENGER’S SIDEÛÝ
ÛÝ

Theclimatecontrolsystemhastwo
sensors. A sunlight sensor is in the
top of the dashboard, and a
temperature sensor is next to the
steering column. Do not cover the
sensors or spill any liquid on them.
If your vehicle has a climate controlsystem
Sunlight Sensor/T emperature
Sensor
Climat e Cont rol Sensors
Features
113
SUNLIGHT SENSOR TEMPERATURE SENSOR

Playing the AM/FM Radio
114
SOUND BUTTON
SEEK BAR TUNE BAR
SEEK BAR SOUND BUTTON
AM/FM
BUTTON
A.SEL
BUTTON
PWR/VOL KNOB
STEREO INDICATOR
SCAN BUTTON AM/FM
BUTTON
A.SEL
BUTTON
TUNE BAR
PRESET BARS SCAN BUTTON
PWR/VOL KNOB
STEREO INDICATOR PRESET BARS
U.S. VP and LX
Canadian DX-G
U.S.SE,EX,LX-V6,andSE-V6
Canadian SE and SE-V6
EX-L and EX-V6
without navigation system

Playing the AM/FM Radio
Features
115
SEEK BAR SCAN
BUTTON
PWR/VOL
KNOBUPPER
DISPLAY
PRESET
ICONS
AUDIO
DISPLAY
BUTTON
TUNE/
SOUND
KNOB
STEREO INDICATOR
AM/FM
BUTTON
SOUND ICON
SCAN
ICON
EX-L and EX-V
6 with navigation system
AUTO
SELECT
ICON

You can use any of five methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN, AUTO
SELECT, and the preset bars or
icons.
Use the TUNE bar or
knob to tune the radio to a desired
freque ncy. Press the side of the
bar or turn the knob to the right to
tune to a higher frequency, and the
side or turn the knob to the left
to tune to a lower frequency.
The seek function
searches up and down from the
cu rrent frequency to find a station
with a strong signal. To activate it,
press the or side of the
bar, then release it.
Pushing
the AUDIO DISPLAY
button will also turn on the system.
XM satellite radio inf ormation is
available on page .
The audio system f or your vehicle
can also be operated using the voice
control system. See the Navi section
in your Quick Start Guide f or an
overview of this system, and the
navigation system manual f or
complete details.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob or the AM/FM
button. Adjust the volume by turning
the PWR/VOL knob.
The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction in
AM is not available.
135
With navigation system
Only on models equipped with
navigation system
To Select a Station
TUNE
SEEK
To Play the Radio
Voice Control System
Playing the AM/FM Radio
116
µ
µ

Pick the preset number (1 6)
you want for that station. Press
the left or right side of the bar or
iconandholdituntilyouheara
beep.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
Each preset bar or icon
can store one f requency on AM, and
two f requencies on FM.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each preset
baroricon.
The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
The system will scan f or a station
with a strong signal. When it f inds
one, it will stop and play that station
f or about 5 seconds.
If you do nothing, the system will
scan f or the next strong station and
play it f or 5 seconds. When it plays a
station you want to listen to, press
the SCAN button again. Usethetune,seek,orscan
function to tune the radio to a
desired station. Push the AUDIO DISPLAY button
to view the preset icons.
1.
2. 3.
4.
With navigation system
CONT INUED
Preset
SCAN
Playing the AM/FM Radio
Features
117
µ
µ µ

If you do not like the stations Auto
Select has stored, you can store
other f requencies on the preset bars
or icons. Use the TUNE, SEEK, or
SCAN f unction to f ind stations, then
store them in the preset bars or
icons as described previously.press the
A. SEL button or Auto Select icon.
This restores the presets you
originally set.
Press the A. SEL button or touch the
Auto Select icon. A. SEL will f lash in
the display, and the system will go
into scan mode f or several seconds.
It stores the f requencies of six AM,
and twelve FM stations in the preset
bars (1 6) or icons. You will see a
‘‘0’’ displayed af ter pressing a preset
bar or icon if Auto Select cannot f ind
a strong station for every preset bar
or icon. If you are
traveling far from home and can no
longer receive your preset stations,
you can use the auto select feature to
find stations in the local area.
The preset f requencies may be lost if
your vehicle’s battery goes dead, is
disconnected, or the radio f use is
removed.
To turn of f Auto Select,
AUTO SELECT
Playing the AM/FM Radio
118
µ µ

Without navigation systemWith navigation system
With navigation systemThe system will automatically return
the display to the selected audio
mode about f ive seconds af ter you
stop adjusting a mode. On vehicles
with navigation system, touch the
RETURN icon to go back to the
audio screen.
Press the SOUND button or icon, or
press the TUNE knob repeatedly to
display the Bass (BAS), Treble
(TRE), Balance (BAL), and Fader
(FAD) settings. On vehicles with
navigation system, touch the
SOUND icon or press the TUNE
knob.
These two
modes adjust the strength of the
sound coming f rom each speaker.
BAL adjusts the side-to-side strength,
while FAD adjusts the f ront-to-back
strength.
Use the TRE/BAS
modes to adjust the tone to your
liking.
If you want to adjust the sound while
the radio/CD is playing, push the
AUDIO DISPLAY button, then touch
the SOUND icon in the display. Touch the arrows next to the BAS or
TRE icons. The adjustment shows
you the current setting.
Touch the lef t or right bars on the
sound grid. Balance is equalized
when the vertical lines are centered
on the grid.
Touchthefrontorrearbarsonthe
sound grid. The f ader is equalized
when the horizontal lines are
centered on the grid. Eachmodeisshowninthedisplayas
it changes. Turn the PWR/VOL
knob to adjust the setting to your
liking. When the level reaches the
center, you will see a ‘‘ ’’ in the
display.
Adjusting the Sound
Balance/Fader
Treble/Bass
Playing the AM/FM Radio
Features
119
µ
µ
µ