control arm HONDA CIVIC 1991 Owners Manual

Introduction

This manual contains important information about the safe operation and maintenance of your car.
We urge you to read it carefully, become familiar with the controls itdescribes, and follow its recommendations, to help make your
driving trouble-free and enjoyable.
Statements or labels on the product preceded by the following
words are of special significance:
indicates severe personal injury or death will result if
instructions are not followed.indicates a strong possibility of severe personal
injury or death if instructions are not followed.means hazards or unsafe practices which could
cause minor personal injury or product or property
damage.
NOTE: gives helpful information.
Break-in Period
During the first 600 miles (1,000 km) of driving, avoid full throttle
starts and cruising for extended periods at a constant speed.

NOTE:
This break-in procedure also applies to exchanged or overhauled

engines.
During and after the break-in period, drive the car at moderate
speeds until the engine is fully warmed up.
During the first 200 miles (300 km), try to avoid severe braking.

Brake misuse during this period will reduce future braking efficiency.

Remember, your Honda Automobile dealer knows your car best,and should be consulted for service assistance and advice.ProCarManuals.comMain Menu s t

Seats

Front Seat
Adjust the seat position by pulling up on the adjustment lever under
the front edge of the seat cushion, and sliding the seat to the desiredposition. Then release the lever and
make sure the seat is locked in position by moving it back and forth.

ADJUSTMENT
LEVER

The angle of the seat-back can be changed by pulling up on the lever at the outside edge of the seat and leaning forward or back. Release
the lever and let the seat lock into place when it reaches the desired

angle.

Seat belts are most effective when the driver and passenger are
sitting up straight and well back in each seat.
RELEASE LEVER
Do not adjust the driver's seat while the car is moving; the seat
could move suddenly, causing loss of vehicle control. To reduce the risk of siding under the seat belts in a collision,
the seat-backs should be reclined no more than is necessary for
comfort.
Pull up
Pull up
ProCarManuals.comMain Menu s t

Instrument Panel

CRUISE

CONTROL
MASTER SWITCH (LX/EX Sedan) WIPER/
WASHER
SWITCH
DIGITAL CLOCK
(Si Hatchback
and LX/EX Sedan)

REAR

WINDOW
DEFOGGER
SWITCH
HAZARD
WARNING
LIGHT
SWITCH
GLOVE BOX

ASHTRAY
HEATING/

COOLING
CONTROL
PANEL
CIGARETTE
LIGHTER (Except for STD
Hatchback)

POWER

MIRROR
ADJUSTMENT
SWITCH
(LX/EX Sedan)

IGNITION
SWITCH

HORN
BUTTON
PANEL
BRIGHTNESS CONTROLDIAL
LIGHT SWITCH/
TURN SIGNAL/ HI/LO BEAM SWITCH FUSE
BOX
HOOD

RELEASE

HANDLEProCarManuals.comMain Menu s t

LX/EX Sedan

Si Hatchback

Check Engine Warning Light
This light comes on for a couple of seconds each time the ignition is
turned on. It will also come on, and remain on, if there is a malfunction in the emission control system. If the light comes on
while driving, avoid driving at high speed, and have the system
checked by a Honda dealer as soon as possible.
Parking Brake/Brake Failure Warning Light
Check the brake warning light every time you start the car.
With the parking brake set, the warning light should go on when the ignition switch is turned to II or III. With the parking brake released,
the light should go on when the ignition switch is turned to III. If the light goes on at any other time, it means the brake fluid level in themaster cylinder reservoir is too low; add fluid and have your dealer
check for leaks and brake pad wear immediately. (See page 84 )

(Hatchback) /
Seat Belt Reminder Light
The seat belt reminder light comes on when the ignition switch is

turned on (see pages 14 and 17 ).

Hatch/Trunk-open Indicator Light

This light will go on when you turn on the ignition switch if the hatch/trunk is not fully closed.
When the cruise control system is on, this indicator light is on (see
page 39 ).

If a door is open when the ignition is switched on, this light will go
on and stay on until the door is closed.
BRAKE

CRUISE

CONTROL

DOOR
Cruise Control Indicator Light (LX/EX Sedan)
Door Warning Light (Sedan)ProCarManuals.comMain Menu s t

Hazard Warning System
This system should be used only
when your car is stopped under
emergency or hazardous conditions.
To activate, push the hazard warn- ing switch ( ). The front and rear
turn signals will blink simultaneously and both indicator lights will flash. Push the switch ( ) again to turn

the system off.

Panel Brightness Control
When the light switch is in either of
the two "ON" positions, the intensi-
ty of the instrument lights can be adjusted by turning the panel bright-
ness control dial.
Interior Light
The interior light has a three posi- tion switch. The light is off all the
time in the OFF position. In the mid-dle position, it goes on only when a
door is opened. In the ON position, it is on all the time.

(cont'd)

OFF

ON

DOOR

ACTIVATED
PushProCarManuals.comMain Menu s t

Cruise Control (LX/EX Sedan)

Cruise Control

The Cruise Control system allows you to set and automatically maintain any speed above 25 mph (40 km/h) without keeping your
foot on the accelerator. As its name implies, it is meant for cruising
on straight, uncongested highways or freeways. It is not

recommended to be used in traffic, on winding roads or in bad
weather conditions where the driver should have total control.
To Set the Cruise Control:
Push the CRUISE CONTROL master

switch on the dash; the indicator
light will come on.
Accelerate to the desired speed,
then push and release the SET switch on the steering wheel. TheCruise Control light on the instru-ment panel will come on.
The speed you were going when you released the SET switch is the
speed the Cruise Control will hold. You can then "fine tune" the set speed by briefly holding and releasing the SET switch to decrease it
a few mph or pushing the RESUME switch to slightly increase it.
To Cancel the Cruise Control:
Simply push the CRUISE CONTROL

master switch and the indicator
light will go off (this also erases thememory of the set speed).
If you must temporarily disengage
the system (but you wish to retain
the memory of the set speed): tap the brake pedal, or the clutch pedal (manual transmission) or move the
automatic transmission shift lever
to N (Neutral). If you are still going above 25 mph (40km/h), you can
return to the set speed by simply pushing the RESUME switch. If
the car has decelerated below approximately 25 mph (40 km/h),you
can return to the set speed by using the accelerator conventionallyuntil your speed is above 25 mph (40km/h) and then pushing theRESUME switch.

(cont'd)

Push

PushProCarManuals.comMain Menu s t

Cruise Control (cont'd)
To Change the Set Speed: To a faster speed — For gradual acceleration with your foot off the
accelerator, push and hold the RESUME switch until you reach the
desired speed; release the switch and the system's memory will bere-programmed to the new speed.
For faster acceleration, push the accelerator until you reach the
desired speed, then push and release the SET switch to re-program

the system.

To a slower speed — push and hold the SET switch and the car will coast; when you reach the desired slower speed, release the switch
and the system will be re-programmed.
For temporary acceleration above the set speed, such as for passing,
use the accelerator pedal conventionally. When you want to return
to the set speed, take your foot off the accelerator and coast without applying the brakes.
The Cruise Control automates the function of the accelerator pedal to maintain your car at a constant speed. This can be a
convenience on long trips, but it can also be a danger if there aremany other cars on the road or if the road is unfamiliar. Pay strict
attention to the responsibility of driving whenever using the Cruise Control.
CAUTION:
Because the Cruise Control directly activates the acceleratorpedal, don't rest your foot under the pedal when the Cruise
Control is on; it may pull the pedal down onto your foot.

NOTE:
With Cruise Control on, your speed will still vary slightly,
particularly when going up or down hills. Do not drive with your foot on the brake or clutch pedal (manual
transmission), as this will cause the Cruise Control to disengage.ProCarManuals.comMain Menu s t

Power Windows (LX/EX Sedan)
The power windows can be oper- ated only when the ignition switch
is in the "II" position.
The operation of the windows is controlled by the main switch lo-cated in the master control panel on
the driver's door. When the main
switch is off, only the driver's door

window can be opened and closed.
When the main switch is on, all doorwindows can be opened and closed
by the driver, using the appropriate
switch in the master control panel,and the passenger windows can be

opened and closed by the passen-
gers, using the switch located oneach passenger door.
When opening or closing a window, push and hold either the "up" or
"down" side of the switch until the
window reaches the desired posi-
tion, then release.

NOTE:

The driver's window can be opened fully, without the driver having
to hold the switch down, simply by pushing the switch past the first
"stop."
Be sure, before closing any window, that all hands, arms and
other obstructions are clear of the window frame and glass; severe personal Injury could result.
Always keep the main switch in the off position when children
are in the car; injury may result from unintentional window

operation.
Close

Open
DRIVER'S SWITCH
MAIN SWITCHProCarManuals.comMain Menu s t

Heating and Cooling

The vents, heater and air conditioner are combined in one system;
adjusting four basic controls to different settings can provide a full range of interior temperatures for safe and comfortable driving.
Air conditioner: optional

Ventilation

The flow-through ventilation system can provide fresh air to the
interior when the car is moving or stopped, even with the windows

closed.

NOTE:

For proper air flow, the flow-through vents must not be covered.Keep the air inlet at the base of the windshield free of leaves or
other debris.
You can adjust the controls to direct cool or warm outside air
throughout the car for defogging windows, heating, or cooling by turning on the fan.

(cont'd)

AIR OUTLET

AIR INLETProCarManuals.comMain Menu s t

Fan Switch

Switch the fan to low ( 1 ), medium ( 2 ), medium high ( 3 ) or high
speed ( 4 ), to circulate warm, cool, or outside air, depending on
where the temperature control dial and function levers are set.

Function Lever

Slide the lever right or left to direct outside air or recirculated (inside) air to and from the heater, air conditioner and vents.

Temperature Control Dial
Turn the dial clockwise to make air warmer with the function lever in any position.

Air Conditioner Switch (optional)

With the fan on, push the A/C switch to operate the air conditioner;
the indicator light will come on. Push the switch again to turn the air conditioner off.

(cont'd)

What the Controls Do:

TEMPERATURECONTROL DIAL RECIRCULATION

LEVER
FAN SWITCH

FUNCTION LEVER AIR CONDITIONER SWITCH
and INDICATOR LIGHT

(optional)ProCarManuals.comMain Menu s t