engine coolant HONDA CIVIC 1999 6.G Workshop Manual

HONDA CIVIC 1999 6.G Workshop Manual CIVIC 1999 6.G HONDA HONDA https://www.carmanualsonline.info/img/13/6068/w960_6068-0.png HONDA CIVIC 1999 6.G Workshop Manual

Page 51 of 2189

HONDA CIVIC 1999 6.G Workshop Manual MEASUREMENTSTANDARD INFWIEngine oilCapacityf (uS qt, lmp qt)
Inner-to outer rotor radial clearancePump body-to outer rotor radialclearancePump body to-rotor axial clearance
4.8 (5.1, 4.2) for eng;ne o

Page 101 of 2189

HONDA CIVIC 1999 6.G Workshop Manual 20. Remove the shift cable (CVT)
WASHER
Pt-Aslc
21. Disconnect the Power
switch connector, and
cramp.
LOCKNUT29 N.m {3.0 kgf m,22lbfft}
steering pressure (PSP)
remove the wire harness
CLIP
ll
I
Remov

Page 105 of 2189

HONDA CIVIC 1999 6.G Workshop Manual 39. Remove the left and right front mount and bracket
MOUNT/BRACKET
40. Remove the rear mount bracket.
41. Remove the uPPsr bracket.
42. Remove the transmission mount bracket, then
remove the transmi

Page 110 of 2189

HONDA CIVIC 1999 6.G Workshop Manual Engine Removal/lnstallation
Installation (contd)
Except CVT:
12 x 1.25 mm64 N.m (6.5 kgd.m,
Tighten the bolts/nut on the left front mount in thenumbered sequence shown {O - @).
(t 12 x 1.25 mm83 Nm

Page 129 of 2189

HONDA CIVIC 1999 6.G Workshop Manual Timing Belt
Inspection
1.
2.
3.
Remove the cylinder head cover.
. Refer to page 6 46 when installing.
Remove the upper cover (see page 6 19).
Inspect the timing belt for cracks and oil or coolantsoakr

Page 134 of 2189

HONDA CIVIC 1999 6.G Workshop Manual Gylinder Head
lllustrated Index
CAUTION:
. To avoid damage, wait until the engine coolant temperatule drops below 100"F (38C) before removing the cylinder
head.
. When handling a metal gasket, take c

Page 138 of 2189

HONDA CIVIC 1999 6.G Workshop Manual Removal
Engine removal is not required for this procedure
!!!s@ Make sure iacks and salety stands are
f ta"eata"ea propetty and hoist brackets are attached to the
correct positions on the engine.
CAUT

Page 140 of 2189

HONDA CIVIC 1999 6.G Workshop Manual 13. Remove the upper radiator hose heater hose and
water bYPass hose
WATEREYPASSHOSEUPPERRADIATORHOSE
14.
HEATERHOSE
Remove the engine wire harness connectors and
wire harness clamps from the cylinde

Page 171 of 2189

HONDA CIVIC 1999 6.G Workshop Manual Inspection
Remove the cylinder head cover.
NOTE: Refer to page 6-86 when installing the cylin-
der head cover.
Inspect the timing belt for cracks and oil or coolant
soakrng.
NOTE:
. Replace the belt i

Page 175 of 2189

HONDA CIVIC 1999 6.G Workshop Manual Cylinder Head
lllustrated Index
CAUTION:
. To avoid damaging the cylinder head, wait until the engine coolant tempsraturo drops below 100"F (38"C1 bofote
removing it,
. when handling a metal gasket, t
Page:   1-10 11-20 21-30 31-40 41-50 ... 100 next >