Top HONDA CIVIC 2000 6.G Workshop Manual

Keyless Receiver Unit Troubleshooting
lf a faulty keyless door lock control unit has one of the symptoms below, turn to the page listed and tollow the
appropriate troubleshooting procedure. lf the symptom seems relatod to an input problem, or is not covered
by the troubleshooting procedures, do the Input Tests on page 130-16. Refer to the circuit schematic on
pages 130-12 and 130-13 as needed.
Symptom Index
Keyless Entry Does Not Work In Any Mode
Ceiling Light Does Not Come On When The Doors Are Unlocked
With TheTransmitter ....
Doors Do Not Unlock Or Lock With The Transmitter . .
Horn Does Not Sound With The Transmitter 'Beep" Feature On .........
Horn Does Not Sound In The Panic Mode ..
HornDoes NotStopSounding ...............
Page 1 30-17
Page 130- 18
Page 130-1 I
Page 130-19
Page 130-19
Page 1 30-19
Page 130-16Input Tests
\.
130-15

Horn Does Not Sound In The Panic
Mode Or With The Transmitter "Beep"
Feature On
NOTE: The transmitter has a Beep On/Ott toature.
Refer to page 130-14 for how lo turn the be€p on or
off.
1. Does the horn sound whon the HORN button is
oressed?
Yes - Go to the next step.
No - Repair the horn circuit.
2. Does the transmitter LED come on when any of
the buttons are Dressed?
Yes - Go to the next steP.
No - Check the transmitter battery, then retest.
lf the beep feature still does not work, go
to the next steo.
3. Recheck with a known good transmitter
reprogrammed to the vehicle. Does the system
work properly in all modes?
Yes - Replace and program the transmitter,
then retest. Use the procadure on pag€
1 30-1 4 for transmitter programming.
No - Go to the neLt siep.
4. With the keyless door lock control unit connector
disconnected, run a iumper wire from terminal
15 to ground.
Does the horn sound?
Yes - Replace the keyless door lock control unit.
No - Repair the open in th€ terminal 15 (GRY)
wire.
\lr
130.19
Horn Does Not Stop Sounding
1. ls the vehicle equipped with the optional security
system?
Yes - Go to the next step.
No - Go to steD 3.
Does the horn stop sounding when the security
control unit connoctor is disconnected?
Yes - Replace the sEcurity control unit.
No - Go to the nsxt step.
Does the horn stop sounding when the keyless
door lock control unit connector is disconnected?
Yes - Replace the keyless door lock control unit.
No - ReDair the horn circuit.

How the Circuit Works
Arming the Security System
The security system can be armed:
r By pressing the remote control LOCK button
(if equipped)
. 20 seconds atter closing all doors (C)UDX only)
Arming with the Transmitter
The security system can be armed by removing the
ignition key from the ignition switch, closing all
doors and the trunk, and pressing the LOCK button
on the transmitter. When you arm the system in this
way, the remote control LED comes on, the status
LED flashes once per second, the parking lights
flash once. the doors lock. and the horn sounds
once if the beeo sound mode is on.
Passive Arming (CX and Dx only)
When you turn the ignition to OFF, remove the
ignition key from the ignition switch, and close all
the doors and the trunk; the system will
automatically arm itself 20 seconds after the trunk
or last door is closed. When you arm the system
this way, the status LED tlashes 4 times per second
during the exit delay time, and once per second
after the system is armed; the parking lights will
flash once to confirm that the system is armed.
Triggering the Alarm
Atter you've armed the system, it will trigger the
alarm if any door or the trunldhatch is opened. lf the
battery is disconnected when the system is armed or
in the alarm mode, reconnecting it will immediately
trigger the alarm. When the alarm is triggered, the
following will occur for 30 seconds:
. the horn sounds
o the parking lights flash once per second
. the status LED flashes hvice oer second
. the starter is disabled
After 30 seconds, the alarm will stop and the
system will rearm. Pressing the transmitter
UNLOCK button will disarm the svstem.
tlr
133-13
Disarming the System without the Remote
Transmitter (HX, LX, and EX)
You can disarm the system by turning the ignition
switch to ON (ll) and pressing the disarm/valet
switch on the right side ol the stereo tuner face. The
disarm switch will also disarm the svstem after the
system has been triggered.
Disarming the System with the Remote
Transmitter (Hx, Lx, Ex, DX-V, and Si)
Pressing the transmitter UNLOCK button will disarm
the system. The parking lights llash t\ivice if the
alarm has not been tnggered. The parking lights
flash three times if the alarm has been triggered.
The driver's door will unlock. lf you press the unlock
button twice, it will unlock all doors. lf a door is not
opened within 30 seconds, the system will lock all
doors and rearm.
Disarming the System (CX and DX only)
lf the system arms itself, there is a 20 second delay
after you open a door before the alarm will trigger.
To disarm the system in this mode, simply turn the
ignition switch to the ON position
ldentitying Tripped Sensors
The system identifies which sensor trips the alarm
by flashing the status LED. To display the trip
sensor flash code, press the disarm/valet switch 3
times within 5 seconds after the system has been
disarmed. The status sensor will blink according to
the followino codes:
SensorsNumber of Flashes
Door
TrunldHatch
System Switches
1 blink, pause, repeat
2 blinks, pause, repeat
3 blinks, pause, repeat
For further operating instructions, see the security
syslem owner's manual.
(cont'd)

37. Top Right Side of D16Y7 Engine
Component Location
J\
40. Front of D16Y5 Engine (D1685/D16Y7 Similar)\,
38. Top Center of Engine (except Dl685)41. Front of Dl6Y5 Engine (DI685/D16Y7 Similar)
39. Right Rear of Engine Compartment42. Front of Dl6Y8 Engine ('96-'98)
201 -6
t

43. Underside of Vehicle ('96-'98 D16Y8)46. Lower Rear of D16YB Engine (Others Similar)
44. Right Side of D16Y8 Engine (Others Similar)47. Rear of D16Y8 Engine (D16Y5 and D1685 Similar)
\
45. Rear of D16Y8 Engine (All except D16Y7)48. Top Left Side of D16Y7 Engine
201-7

Component Location
49. Top of D16Y7 Engine52. Behind Left Side of Dash Panel\
\
50. Left Side of Dash Panel53. Behind Left Side of Dash Panel ('96-'97)
51. Behind Left Side of Dash Panel54. Behind Left Side of Dash Panel ('96-'97 Models)
201 -g
\

Cornponent Location
85. Behind Right Kick Panel\
\
88. Driver's Door
CONNECTOR B ii
86. Behind Right Kick Panel89. Top Front of Driver's Door (Frt. Pass. Similar)
87. Underside of Driver's Seat90. Front of Driver's Door (Frt. Pass. Similar)
201-14
\

115. Left Side of Trunk Lid (except '99-'00 Sedan)118. Left Rear of Trunk/Cargo Area (except '99-'00 Sed.)b
\
116. Center of Trunk Lid119. Top of Transmission (CVT)
117. Rear Spoiler on Trunk Lid120. Right Side Rear of Engine Compartment (CVT)
L
ffi=
201 -19

139. Behind Glove Box ('99-'00)142. Lett Rear Corner Engine Gompartment (GX)
140. Underside of Rear Shelf ('99-'00 Sedans)143. Right Rear of Engine Compartment (GX)
141. Top Center of Engine (GX)144. Behind Left Kick Panel (GX)
201-23

Connector Views
Cavity Numbering Systemu
WIRE SIDE
ofTERMINAL SIDE
ot
MALE TERMINALSFEMALE TERMINALS
LOCKING DEVICE
Must be at top.
In-Line Connector View Index (views begi202-2)
Connector View
cs16.................. 58
c551 . .... ............. 47
c552 ..... ............. 22
c556.................. 61
c557.................. 62
c562 ..... ............. 42
c568.................... 4
cs70.................... 5
c571 . . . . . . . . . . . . . . . . . . . . 5
c575.................. 73
C604 (Hatchback) ........ 7
C605 (Hatchback) ........ I
C607 (Hatchback) ........ 9
c639 .. ............... 23
c656 ... ............... 24
c723.................. 57
202