oil additives HONDA CIVIC SEDAN 2006 Owner's Manual (in English)

Help assure your vehicle’s f uture
reliability and perf ormance by paying
extra attention to how you drive
during the f irst 600 miles (1,000 km).
During this period:Avoid full-throttle starts and rapid
acceleration.
Avoidhardbrakingforthefirst
200 miles (300 km).
Do not change the oil until the
scheduled maintenance time. Your vehicle is designed to operate
on unleaded gasoline with a pump
octane number of 87 or higher. Use
of a lower octane gasoline can cause
a persistent, heavy, metallic rapping
noise that can lead to engine damage.
You may hear a knocking noise from
the engine if you drive the vehicle at
low engine speed (below about 1,000
rpm) in a higher gear. To stop this,
raise the engine speed by shif ting to
a lower gear.
We recommended using a quality
gasoline containing detergent
additives that help prevent fuel
system and engine deposits.
In addition, in order to maintain good
perf ormance, f uel economy, and
emissions control, we strongly
recommend, in areas where it is
available, the use of gasoline that does NOT contain manganese-based
f uel additives such as MMT.
Use of gasoline with these additives
may adversely af f ect perf ormance,
and cause the malfunction indicator
lamp on your instrument panel to
come on. If this happens, contact
your authorized dealer f or service.
Some gasoline today is blended with
oxygenates such as ethanol or
MTBE. Your vehicle is designed to
operate on oxygenated gasoline
containing up to 10 percent ethanol
by volume and up to 15 percent
MTBE by volume. Do not use
gasoline containing methanol.
If you notice any undesirable
operating symptoms, try another
service station or switch to another
brand of gasoline.
For f urther important f uel-related
inf ormation, please ref er to your
.
You should also f ollow these
recommendations with an
overhauled or exchanged engine, or
when the brakes are replaced.
Do not tow a trailer.
On vehicles with manual transmission
Break-in Period
Fuel Recommendation
Quick Start Guide
Break-in Period, Fuel Recommendation
150
——y
y
(#y
y

Your vehicle does not require any oil
additives. Additives may adversely
af f ect the engine or transmission
perf ormance and durability. You may use a synthetic motor oil if
it meets the same requirements
given f or a conventional motor oil: it
displays the API Certif ication Seal,
and it is the proper weight. You must
f ollow the oil and f ilter change
intervals shown on the information
display.Open the hood, and remove the
engine oil f ill cap. Remove the oil
drain bolt and washer f rom the
bottom of the engine. Drain the oil
into an appropriate container.
Run the engine until it reaches
normal operating temperature,
then shut it off.
Always change the oil and f ilter
according to the maintenance
messages shown on the inf ormation
display. The oil and f ilter collect
contaminants that can damage your
engine if they are not removed
regularly.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
technician.
1.
2.
Synthetic Oil
Engine Oil A dditives
Changing the Engine Oil and
Filter
A dding Engine Oil, Changing the Engine Oil and Filter
192
DRAIN BOLT
WASHER
——y

y
(#y
y

If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certif ication seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,
motor oil does not contain the proper
additives, and continued use can
cause stif f er shif ting. Replace as
soon as it is convenient.
Check the f luid level with the
transmission at normal operating
temperature and the vehicle sitting
on level ground. Remove the
transmission f iller bolt, and caref ully
f eel inside the bolt hole with your
f inger. The f luid level should be up
to the edge of the bolt hole. If it is
not, add Honda Manual
Transmission Fluid (MTF) until it
starts to run out of the hole. Reinstall
the f iller bolt, and tighten it securely.
Insert the dipstick all the way back
in the transmission.
If you are not sure how to add f luid,
contact your dealer.
If you are not sure how to add f luid,
contact your dealer.
6.
T ransmission Fluid
Manual Transmission
Maint enance
197
FILLER BOLT
Correct Level
——y
y
(#yy

CONT INUED
BatteryCharging System ...........................
Indicator .64,229
............................
Jump Starting .225
..............................
Maintenance .215
............................
Specif ications .243
..............................
Bef ore Driving .149
..................................
Belts, Seat .10,20
.........................
Beverage Holders .100
Brakes ...........
Anti-lock System (ABS) .172
.............
Break-in, New Linings .150
....................
Bulb Replacement .203
...........................................
Fluid .198
.................
Pad Wear Indicators . 171
.......................................
Parking .170
.................
System Indicator . 60,231
.............................
Braking System .171
.................
Break-in, New Vehicle . 150
..
Brightness Control, Instruments . 72
........................
Brights, Headlights .71
....................................
Accessories .155
ACCESSORY (Ignition Key .......................................
Position) .77
.............
Accessory Power Socket . 100
....................
Additives, Engine Oil . 192
.............................
Airbag (SRS) .11, 23
...
Airbags, Additional Information . 23
...
Additional Safety Precautions . 34
..........
AdvancedAirbagSystem . 28
.............................
Airbag Service .33
How the Passenger Airbag Of f ......................
Indicator Works .32
How the Side Airbag Of f ......................
Indicator Works .32
..
How the SRS Indicator Works . 31
How Your Front Airbags .........................................
Work .26
...
How Your Side Airbags Work . 29
How Your Side Curtain Airbags .........................................
Work .31
........................
SRS Components .23
..............
Air Conditioning System . 102
.......................
Air Pressure, Tires .210
......................................
Antif reeze .194 Anti-lock Brakes (ABS)
...............................
Indicator .61, 172
...................................
Operation .172
..............
Anti-thef t, Audio System . 142
Anti-thef t Steering Column ..........................................
Lock .77
............................................
Armrest .90
................................
Audio System .106
.....
Auto Door Locking/Unlocking . 79
.........................
Auto Door Locking .79
.....................
Auto Door Unlocking .81
...
Automatic Seat Belt Tensioners . 21
.............
Automatic Speed Control . 145
..............
Automatic Transmission . 166
..........................
Capacity, Fluid .242
...............
Checking Fluid Level . 196
.......................................
Shif ting .166
Shif t Lever Position ...............................
Indicators .166
................
Shif t Lever Positions . 167
....................
Shif t Lock Release . 169
Index
A B
INDEX
I
——y

y
(#yy