reset HONDA CLARITY PLUG IN HYBRID 2019 Owners Manual

28
Quick Reference Guide Features (P 203)
Audio Remote Controls (P 207)
● ( +
/ ( -
Bar
Press to adjust the volume up/down.
● / Button
Press or to cycle through the audio
mode as follows:
FM AM SiriusXM ® *
USB iPod
Bluetooth ® Audio Pandora ® *
Apple
CarPlay/Android AutoENTER Button / / / Button 3 4
( +
/ ( -
Bar
Button
3 4
3 4 ● ENTER Button
• When listening to the radio and
SiriusXM ® *
a Press ENTER to switch the display to a
preset list you stored in the preset
buttons.
b Press or to select a preset, then
press ENTER .
• When listening to a USB flash drive
a Press ENTER to display the folder list.
b Press or to select a folder.
c Press ENTER to display a list of tracks in
that folder.
d Press or to select a track, then
press ENTER .3 4
3 4
3 4 • When listening to an iPod
a Press ENTER to display the iPod music
list.
b Press or to select a category.
c Press ENTER to display a list of items in
the category.
d Press or to select an item, then
press ENTER .
u Press ENTER and press or
repeatedly until a desired item you
want to listen is displayed.
• When listening to Pandora ® *
a Press ENTER to display the station list.
b Press or to select an item, then
press ENTER .
• When listening to Bluetooth ® Audio
a Press ENTER to display the track list.
b Press or to select a track, then
press ENTER . 3 4
3 4
3 4
3 4
3 419 CLARITY PHEV-31TRW6100.book 28 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

29
Quick Reference Guide
● / Button
Radio: Press to change the preset station.
Press and hold to select the next or
previous strong station.
USB device:
Press to skip to the beginning of
the next song or return to the
beginning of the current song.
Press and hold to change a folder.
Button:
Press to change contents.
2 Driver Information
Interface (P124)
* Not available on all models19 CLARITY PHEV-31TRW6100.book 29 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

uu Child Safety u Safety of Infants and Small Children
76
Safe Driving A child seat can be installed with a lap/should er belt in any rear seat or, if absolutely
necessary, the front passenger seat.
1. Place the child seat on the vehicle seat.
2. Route the seat belt through the child seat
according to the seat manufacturer’s
instructions, and insert the latch plate into
the buckle.
u Insert the latch plate fully until it clicks.
3. Slowly pull the shoulder part of the belt all
the way out until it stops. This activates the
lockable retractor.
4. Let the seat belt retract a few inches and
check that the retractor has switched
modes by pulling on the webbing. It should
not pull out again until it is reset by
removing the latch plate from the buckle.
u If you are able to pull the shoulder belt
out, the lockable retractor is not
activated. Slowly pull the seat belt all the
way out, and repeat steps 3 – 4.■ Installing a Child Seat with a Lap/Shoulder Seat Belt 1 Installing a Child Seat with a Lap/Shoulder Seat Belt
A child seat that is not properly secured will not
adequately protect a child in a crash and may cause
injury to the child or other vehicle occupants.19 CLARITY PHEV-31TRW6100.book 76 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

118 uu Indicators u Driver Information Interface Wa rning and Information Messages
Instrument Panel Message Condition Explanation●
Appears when the speed of th e vehicle is too high for
you to set ACC with LSF. ●
Reduce the speed, then set ACC with LSF. 2 Adaptive Cruise Control (ACC) with Low Speed
Follow (LSF) P. 402●
Appears when ACC with LSF is cancelled due to
excessive vehicle speed. ●
Reduce the speed, then reset ACC with LSF. 2 Adaptive Cruise Control (ACC) with Low Speed
Follow (LSF) P. 402●
Appears when the vehicle ahead of you resumes
driving, after your vehicle has been stopped
automatically by ACC with LSF. ●
Press the RES/+ or −/SET switch or depress the
accelerator pedal to resume. 2 Adaptive Cruise Control (ACC) with Low Speed
Follow (LSF) P. 402●
Appears when pressing the RES/+ or −/SET switch
down while the parking brake is applied. ●
ACC with LSF cannot be set. 2 Adaptive Cruise Control (ACC) with Low Speed
Follow (LSF) P. 402
2 Parking Brake P. 434●
Appears when pressing the RES/+ or −/SET switch
down while the vehicle is moving and the brake
pedal is depressed. ●
ACC with LSF cannot be set. 2 Adaptive Cruise Control (ACC) with Low Speed
Follow (LSF) P. 402●
Appears if ACC with LSF is canceled while your
vehicle is automatically stopped by ACC with LSF. ●
Immediately depress the brake pedal.19 CLARITY PHEV-31TRW6100.book 118 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

uu Gauges and Driver Information Interface u Driver Information Interface
126
Instrument Panel Shows the total number of miles or kilome ters that your vehicle has accumulated.
Shows the total number of miles or kilomete rs driven since the last reset. Meters A
and B can be used to measure two separate trips.
■ Resetting a trip meter
To reset a trip meter, display it, then press and hold the TRIP button. The trip meter
is reset to 0.0 .
Shows the outside temperature in Fahr enheit (U.S.) or Celsius (Canada).
■ Adjusting the outside temperature display
Adjust the temperature reading up to ± 5° F or 3°C if the temperature reading seems
incorrect.
Shows the estimated average fuel economy of each trip meter in mpg or l/100 km.
The display is updated at set intervals. Wh en a trip meter is reset, the average fuel
economy is also reset.■ Odometer
■ Trip Meter
■ Outside Temperature
■ Average Fuel Economy 1 Trip Meter
Switch between trip meter A and trip meter B by
pressing the TRIP button.
1 Outside Temperature
The temperature sensor is in the front bumper.
Road heat and exhaust fr om another vehicle can
affect the temperature reading when your vehicle
speed is less than 19 mph (30 km/h).
It may take several minutes for the display to be
updated after the temperature reading has stabilized.
Use the audio/information screen’s customized
features to correct the temperature.
2 Customized Features P. 306
1 Average Fuel Economy
You can change when to reset the average fuel
economy.
2 Customized Features P. 30619 CLARITY PHEV-31TRW6100.book 126 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

Continued
127uu Gauges and Driver Information Interface u Driver Information Interface
Instrument Panel
Shows the instant fuel economy as a bar graph in mpg or l/100 km.
Shows the time elapsed since Trip A or Trip B was reset.
Shows the average speed in mph or km/h since Trip A or Trip B was reset.
Shows you turn-by-turn driv ing directions to your destination linked with the
navigation system. 2 Refer to the Navigation System Manual■ Instant Fuel Economy
■ Elapsed Time
■ Average Speed
■ Turn-by-Turn Directions 1 Elapsed Time
You can change when to reset the elapsed time.
2 Customized Features P. 306
1 Average Speed
You can change when to reset the average speed.
2 Customized Features P. 306
1 Turn-by-Turn Directions
The driver information in terface shows a compass
when the route guidance is not used.
You can select whether th e turn-by-turn display
comes on or not during the route guidance.
2 Customized Features P. 30619 CLARITY PHEV-31TRW6100.book 127 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

131uu Gauges and Driver Information Interface u Driver Information Interface
Continued
Instrument Panel
■ Drive Cycle Score/Lifetime Points
Appear for a few seconds when you set the power mode to VEHICLE OFF (LOCK).
Each has three stages. Depending on your driving style, the leaf icon(s) and the
gauge increase or decrease to indicate that you have reached a different stage of
fuel economy.
■ Resetting the Drive Cycle Score
1. Make sure the transmission is in ( P
. Turn the power mode to ON.
2. If ECON mode is on, press the ECON button to turn it off.
3. Turn the power mode to VEHICLE OFF (LOCK).
4. Turn the power mode to ON again.
u Make sure to complete steps fro m 4 through 6 within 30 seconds.
5. Depress the brake pedal twice.
u The color of the ambient meter wi ll change from white to green.
u When the Fuel Efficiency Backlight setting on the audi o/information display
is off, the color stays white.
6. Press the ECON button twice.
u The color of the ambient mete r will turn to monochrome.
7. Turn the power mode to VEHICLE OFF (LOCK). Advancing to
2nd Stage Advancing to
3rd Stage
Receding to
2nd Stage Receding to
3rd StageLifetime PointsDrive Cycle Score19 CLARITY PHEV-31TRW6100.book 131 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

170 uu Operating the Switches Around the Steering Wheel u Driving Position Memory System *
Controls Driving Position Memory System *You can store two driver’s seat with the driving position memory system.
When you unlock and open the driver’s do or with a remote transmitter, or smart
entry system, the seat adjusts automatica lly to one of the two preset positions.
• DRIVER 1 transmitter is linked to memory button 1.
• DRIVER 2 transmitter is linked to memory button 2. 1 Driving Position Memory System *
Using the audio/informati on screen, you can disable
the automatic seat adjustment function.
2 Customized Features P. 306
DRIVER 1 DRIVER 2
* Not available on all models 19 CLARITY PHEV-31TRW6100.book 170 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

207uu Audio System u Audio Remote Controls
Continued
Features
Audio Remote Controls Allow you to operate the audio system whil e driving. The information is shown on
the driver information interface.
Buttons
Press or to cycle through the audio
mode as follows:
FM AM SiriusXM ® *
USB iPod
Bluetooth ® Audio Pandora ® *
Apple
CarPlay/Android Auto
ENTER Button
• When listening to the radio and SiriusXM ® *
1. Press ENTER to switch the disp lay to a preset list you stored in the preset buttons.
2. Press or to select a preset, then press ENTER .
• When listening to a USB flash drive
1. Press ENTER to display the folder list.
2. Press or to select a folder.
3. Press ENTER to display a list of tracks in that folder.
4. Press or to select a track, then press ENTER . 1 Audio Remote Controls
Some modes appear only when an appropriate
device or medium is used.
Depending on the Bluetooth ® device you connect,
some functions may not be available.
Press the (Hang-up/back) button to go back
to the previous command or cancel a command.
Press the button to switch display.
2 Switching the Display P. 211 Button ENTER Button
Button ( +
( -
Bar
Button Button3
Button4 3 4
3 4
3 4
3 4
3 4
* Not available on all models 19 CLARITY PHEV-31TRW6100.book 207 ページ ２０１８年１０月２５日　木曜日　午後２時２９分

209uu Audio System u Audio Remote Controls
Features
( +
( -
(Volume) Bar
Press ( +
: To increase the volume.
Press ( -
: To decrease the volume.
Buttons
• When listening to the radio
Press : To select the next preset radio station.
Press : To select the previous preset radio station.
Press and hold : To select the next strong station.
Press and hold : To select the previous strong station.
• When listening to an iPod, USB flash drive, or Bluetooth ® Audio
Press : To skip to the next song.
Press : To go back to the beginning of the current or previous song.
• When listening to a USB flash drive
Press and hold : To skip to the next folder.
Press and hold : To go back to the previous folder.
• When listening to Pandora ® *
Press : To skip to the next track.
Press and hold : To select the next station.
Press and hold : To select the previous station.
* Not available on all models 19 CLARITY PHEV-31TRW6100.book 209 ページ ２０１８年１０月２５日　木曜日　午後２時２９分