spare wheel HONDA CR-V 2004 RD4-RD7 / 2.G Owners Manual

Locate the jacking point nearest
thetireyouneedtochange.Itis
pointed to by an arrow molded into
the underside of the body. Place
the jack under the jacking point.
Turn the end bracket clockwise
until the top of the jack contacts
the jacking point. Make sure the
center of the jacking point tab is
restinginthejacknotch.
Pull of f the center spacer. Using
the wheel wrench, loosen the
three wheel nuts and remove them.
Remove the spare tire from the
holder.
Loosen the f ive wheel nuts 1/2
turn with the wheel wrench.
Unzip the flap around the lower
edge of the cover.
Pull out the bottom of the cover,
then gradually pull it of f .
9.
11.
10.
7.
8.
On EX-L model in Canada
Changing a Flat T ire
T aking Care of t he Unexpect ed
Hard plastic spare tire cover
202
CENTER SPACER
JACKING POINT
NUTS

CONT INUED
Bef ore mounting the spare tire,
wipeanydirtoff themounting
surface of the wheel and hub with
a clean cloth. Wipe the hub
carefully;itmaybehotfrom
driving.
Use the extension and wheel
wrench as shown to raise the
vehicle until the f lat tire is of f the
ground.
Remove the wheel nuts, then
remove the f lat tire. The wheel
nuts will be very hot if you were
recently driving. Place the f lat tire
on the ground with the outside
surface facing up. Put on the spare tire. Put the
wheel nuts back on f inger-tight,
then tighten them in a crisscross
pattern with the wheel wrench
until the wheel is f irmly against
the hub. Do not try to tighten
them f ully.
Lower the vehicle to the ground
and remove the jack.
14.
12.
13. 15.
16.
Changing a Flat T ire
T aking Care of t he Unexpect ed203
BRAKE HUB
WHEEL WRENCH EXTENSION

Tighten the wheel nuts securely in
the same crisscross pattern. Have
the wheel nut torque checked at
the nearest automotive service
f acility.
Tighten the wheel nuts to:
Remove the center cap from the
flat tire.Put the flat tire on the spare tire
holder. Put the wheel nuts on
finger-tight, then tighten them
with the wheel wrench. Put the
center spacer in the center of the
wheel.
Tighten the wheel nuts to:Store the jack in its holder. Turn
the jack’s end bracket to lock it in
place. Install the cover on the side
of the cargo area.
Install the spare tire cover. Close the tailgate. Store the tool kit in the storage bin
under the cargo area f loor.
17.
18. 19.20.
21.
22.
23.
Changing a Flat T ire
T aking Care of t he Unexpect ed204
CENTER SPACER
80 lbf·ft (108 N·m , 11 kgf·m)
40 lbf·ft (54 N·m , 5.5 kgf·m)Loose items can fly around the
interiorinacrashandcould
seriously injure the occupants.
Store the wheel, jack, and tools
securely before driving.