remove seats HONDA CR-V 2015 RM1, RM3, RM4 / 4.G Owners Manual
[x] Cancel search | Manufacturer: HONDA, Model Year: 2015, Model line: CR-V, Model: HONDA CR-V 2015 RM1, RM3, RM4 / 4.GPages: 533, PDF Size: 24.82 MB
Page 38 of 533

Continued37
uuSeat Belts uFastening a Seat Belt
Safe Driving
3. Position the lap part of the belt as low as 
possible across your hips, then pull up on 
the shoulder part of the belt so the lap part 
fits snugly. This lets  your strong pelvic 
bones take the force of a crash and reduces 
the chance of internal injuries.
4. If necessary, pull up  on the belt again to 
remove any slack, then check that the belt 
rests across the center of your chest and 
over your shoulder. Th is spreads the forces 
of a crash over the strongest bones in your 
upper body.
The front seats have adjustab le shoulder anchors to accommodate taller and shorter 
occupants.
1.Move the anchor up  and down while 
holding the release buttons.
2. Position the anchor so that the belt rests 
across the center of  your chest and over 
your shoulder.1 Fastening a Seat Belt
To release the belt, push the red  PRESS button then 
guide the belt by hand  until it has retracted 
completely.
When exiting the vehicle, be sure the belt is out of 
the way and will not get ca ught by closing the door.
3WARNING
Improperly positioning the seat belts can 
cause serious injury or death in a crash.
Make sure all seat belts are properly 
positioned before driving.Lap belt 
as low as 
possible
■Adjusting the Shoulder Anchor1Adjusting the Shoulder Anchor
The shoulder anchor  height can be adjusted to four 
levels. If the belt contacts  your neck, lower the height 
one level at a time.
After an adjustment, make  sure that the shoulder 
anchor position is secure.
Push
Push
15 CR-V-31T0A6300.book  37 ページ  2015年2月2日 月曜日 午前10時35分 
Page 180 of 533

Continued179
uuAdjusting the Seats uAdjusting the Seat Positions
Controls
A passenger sitting in th e center back seating 
position should adjust the height of their head 
restraint to an appropriate position before the 
vehicle begins moving.
To raise the head restraint:
Pull it upward.
To lower the head restraint:
Push it down while pressing the release 
button.
Head restraints can be removed for cleaning or repair.
To remove a head restraint:
Pull the restraint up as far as  it will go. Then push the release button, and pull the 
restraint up and out.
To reinstall a head restraint:
Insert the legs back in place,  then adjust the head restraint to an appropriate height 
while pressing the release button. Pull up on  the restraint to make sure it is locked 
in position.
■Changing the Rear Center Seat Head Restraint Position
■Removing and Reinstalling the Head Restraints1 Removing and Reinstalling the Head Restraints
3WARNING
Failure to reinstall, or  correctly reinstall, the 
head restraints can result in severe injury 
during a crash.
Always replace the he ad restraints before 
driving.
Front and rear center head restraints
15 CR-V-31T0A6300.book  179 ページ  2015年2月2日 月曜日 午前10時35分 
Page 183 of 533

182
uuAdjusting the Seats uRear Seats
Controls
Rear Seats
The rear seats can be folded down separate ly to allow for additional storage space.
■To fold down the seat
1. Store the center seat belt first. Insert the  latch plate into the slot on the side of the 
anchor buckle.
2. Retract the seat belt into the holder on the ceiling.
2 Seat Belt with Detachable Anchor  P. 38
3.Lower the center head restraint to its lo west position. Put the armrest back into 
the seat-back.
4.Pull the release strap.
u The seat cushion flip s forward, the head 
restraints tilt downward, and the seat-
back then folds flat.
4. Pull the release lever.
u The seat cushion flip s forward, the head 
restraints tilt downward, and the seat-
back then folds flat.
■Folding Down the Rear Seats1 Folding Down the Rear Seats
Make sure all items in the cargo area or items 
extending to the rear seats are properly 
secured. Loose items can fly forward if you have 
to brake hard.
Remove any items from th e rear seat cushion and 
floor before you fold down the rear seat.
Make sure the seat-back completely lowers (a click 
sounds). Otherwise it will no t re-latch when returned 
to the upright position.
The front seat(s) must be  far enough forward so they 
do not interfere with the rear seats as they fold 
down.
Pull
From the rear door side
LeverFrom the cargo area side
15 CR-V-31T0A6300.book  182 ページ  2015年2月2日 月曜日 午前10時35分