warning HONDA CR-Z 2011 1.G Owner's Manual

79
Instrument Panel
Indicators Multi-Information Display Warning and Information Messages
Message ConditionExplanation
Appears when the ignition key is turned to

•
ACCESSORY
from ON II. (The driver’s door is
closed.) —
Appears when you open the driver’s door while the

•
ignition key is in LOCK
0. Remove the key from the ignition switch.

•
Appears if the clutch pedal is not fully depressed while
the auto idle stop is in operation, and the engine is ready
to restart. Fully depress the clutch pedal.

•
Auto Idle Stop P.227
Appears when the shift lever is in any forward gear

•
position, and the auto idle stop operating time has continued for a while. Shift to

•
N. Auto Idle Stop P.227
Appears while the auto idle stop is in operation, and

•
to allow the engine to restart again for the following reasons:
The IMA battery charge is low.
•
There is a problem with the system.
• Manually start the engine.

•
Starting the Engine P.197
Main MenuTable of Contents

80
Instrument Panel
Indicators Multi-Information Display Warning and Information Messages
Message ConditionExplanation
Automatic transmission (CVT) model Manual transmission model Appears while you are customizing the settings for the

•
following reasons: The shift lever is moved out of

•
P (CVT).
The parking brake is released (manual transmission).

•
Customization Procedure P.90
Main MenuTable of Contents

83
Instrument Panel
Gauges and Multi-Information Display Multi-Information Display
Multi-Information Display
The multi-information display shows the odometer, trip meter, outside temperature, and other fuel economy information.It also displays important messages such as warnings and other helpful information.Switching the Display

■
Press the button or the SEL/RESET button to change the display.
Eco Guide feedback with Eco Drive Bar
OFF
HFL *
Customizable Setting Entry Engine Oil Life Power Flow
MonitorAverage Vehicle SpeedElapsed Time
Average Fuel Economy Records
Average Fuel Economy A
Range
SEL/RESET Button
(Information) Button Shown when
Bluetooth®

HandsFreeLink ®
is activated.
* Not available on all models
Main MenuTable of Contents

107
Controls
Opening and Closing the Windows
Opening/Closing the Power Windows
Opening/Closing the Power Windows
The auto-reverse function stops sensing when the window is almost closed to ensure that it fully closes. The power windows can be operated for up to 10 minutes after you turn the ignition switch off.Opening either door cancels this function. Auto Reverse If a power window senses resistance when closing automatically, it will stop closing, and reverse direction. The driver’s window auto reverse function is disabled when you continuously pull up the switch.
WARNING
Closing a power window on someone’s hands or fingers can cause serious injury. Make sure your passenger is away from the window before closing it.
The power windows can be opened and closed when the ignition switch is in ON
II, using the switches on the doors. The driver side switch can be used to open and
close both windows. The main switch on the driver side must be switched off (not pushed in) to open and close the passenger’s window from the passenger side. When the main switch is turned on (pushed in), you can only operate the passenger’s window from the driver’s seat. Turn the main switch on if a child rides in the passenger’s seat.
Opening/Closing the Driver’s Window

■
■ Automatic Operation
To open: Push the switch down firmly.
To close: Pull the switch up firmly.
The window opens or closes completely. To stop the window at any time, push or pull the switch briefly.
Manual Operation
■
To open: Push the switch down lightly.
To close: Pull the switch up lightly.
Release the switch when the window reaches the desired position.
On
Main Switch
Passenger’s Window Switch
Driver’s Window Switch Off
Main MenuTable of Contents

109
Controls
Operating the Switches Around the Steering Wheel
Ignition Switch
Ignition Switch
Manual transmission models Automatic transmission (CVT) models
You cannot take the key out unless the shift lever is
in .
On all models If you open the driver's door when the key is in LOCK or ACCESSORY , a warning buzzer will
sound to remind you to take the key out. If the key won't turn from LOCK
to ACCESSORY , turn the key while moving the steering wheel
left and right. The steering wheel will unlock, allowing the key to turn.
WARNING
Removing the key from the ignition switch locks the steering. If you do this while the vehicle is in motion, you can lose control of the vehicle. Only remove the key from the ignition switch when parked.
LO CK: In se rt and re move the key in this position.
AC CESSOR Y: Op erate the audio system and
other acce ssories in this position.
ON : Th is is the position when driving.
ST AR T: Th is position is for starting the engine .
Th e sw itch returns to ON when you let go of the
key.
Main MenuTable of Contents

117
Controls
Operating the Switches Around the Steering Wheel Adjusting the Steering Wheel
Adjusting the Steering Wheel
Adjusting the Steering Wheel
Make any steering wheel adjustments before you start driving.
WARNING
Adjusting the steering wheel position while driving may cause you to lose control of the vehicle and be seriously injured in a crash. Adjust the steering wheel only when the vehicle is stopped.
The steering wheel height and distance from your body can be adjusted so that you can comfortably grip the steering wheel in an appropriate driving posture. 1. Pull the steering wheel adjustment lever up.
The steering wheel adjustment lever is
under the steering column.
Move the steering wheel up or down, and
2.
in or out.
Make sure you can see the instrument panel gauges and indicators.
Push the steering wheel adjustment
3.
lever down to lock the steering wheel in position.
After adjusting the position, make sure you have securely locked the steering wheel in place by trying to move it up, down, in, and out.
To lock
To adjust
Lever
Main MenuTable of Contents

119
Controls
Adjusting the Seats
Adjusting the Seat PositionAdjust the driver’s seat as far back as possible while allowing you to maintain full control of the vehicle. You should be able to sit upright,
well back in the seat and be able to adequately press the pedals without leaning forward, and grip the steering wheel comfortably. The
passenger’s seat should be adjusted in a similar manner, so that it is as far back from the front airbag in the dashboard as possible.
Move back.
Allow suficient space.
Adjusting the Seats
The National Highway Trafic Safety Administration and Transport Canada recommend that drivers
allow at least 10 inches (25 cm) between the center of the steering wheel and their chest. Always make seat adjustments before driving.Once a seat is adjusted correctly, rock it back and forth to make sure it is locked in position.
WARNING
Sitting too close to a front airbag can result in serious injury or death if the front airbags inflate. Always sit as far back from the front airbags as possible while maintaining control of the vehicle.
Driver’s seat is shown.
Height Adjustment (Driver's seat only)Pull up or push down the lever to raise or lower the seat. Horizontal Position AdjustmentPull up on the bar to move
the seat, then release the bar.
Seat-back Angle AdjustmentPull up the lever to change the angle.
Main MenuTable of Contents

120
Controls
Adjusting the Seats Adjusting the Seat Position
Adjusting the Seat-Backs
■
Adjust the driver’s seat-back to a comfortable, upright position, leaving ample space between your chest and the airbag cover in the center of the steering wheel. The passenger should also adjust their seat- back to a comfortable, upright position.
Reclining a seat-back so that the shoulder part of the belt no longer rests against the occupant’s chest reduces the protective capability of the belt. It also increases the chance of sliding under the belt in a crash and being seriously injured. The farther a seat-back is reclined, the greater the risk of injury.
Adjusting the Seat-Backs
Do not put a cushion, or other object, between the seat-back and your back. Doing so may interfere with proper seat belt or airbag operation. If you cannot get far enough away from the steering wheel and still reach the controls, we recommend that you investigate whether some type of adaptive equipment may help.
WARNING
Reclining the seat-back too far can result in serious injury or death in a crash. Adjust the seat-back to an upright position, and sit well back in the seat.
Main MenuTable of Contents

121
Controls
Adjusting the Seats Adjusting the Seat Position
Head Restraints
■
Your vehicle is equipped with head restraints in both seating positions. However, they are non-adjustable.Head restraints are effective for protection against whiplash and other rear-impact crash injuries.
Removing and Installing the Head Restraint for Cleaning
■
To remove the head restraint:
1. Unhook the strap on the outside edge of the seat-back.Pull out the strap throughout the band
2.
on the outside under edge of the head restraint.Push the release button, and pull the head
3.
restraint upward.
To install the head restraint: 1. Put the legs back in place, then slightly lower it.
Do not push it down fully until it locks
in place.
Insert the strap onto the band, then hook
2.
it to the magnet on the outside edge of the seat-back.Push the head restraint down until it locks.
3.
Make sure the head restraint locks in place when you reinstall it.
Head Restraints
The driver’s and passenger’s seats have active head restraints.
WARNING
Failure to reinstall the head restraints can result in severe injury during a crash. Always replace the head restraints before driving.
Band Strap
Release Button
Magnet
Main MenuTable of Contents

122
Controls
Adjusting the Seats Adjusting the Seat Position
Maintain a Proper Sitting Position
■
After all occupants have adjusted their seats, and put on their seat belts, it is very important that they continue to sit upright, well back in their seats, with their feet on the floor, until the vehicle is safely parked and the engine is off. Sitting improperly can increase the chance of injury during a crash. For example, if an occupant slouches, lies down, turns sideways, sits forward, leans forward or sideways, or puts one or both feet up, the chance of injury during a crash is greatly increased. In addition, an occupant who is out of position in the seat can be seriously or fatally injured in a crash by striking interior parts of the vehicle or being struck by an inflating front airbag.
Active Head Restraints

■
The driver’s and passenger’s seats have active head restraints. In a rear impact, an occupant properly secured by a seat belt will be pushed against the seat-back and the head restraint will move forward. This reduces the distance between the restraint and the occupant’s head. It also helps protect the occupants against the likelihood of whiplash and injuries to the neck and upper spine.
Maintain a Proper Sitting Position
WARNING
Sitting improperly or out of position can result in serious injury or death in a crash. Always sit upright, well back in the seat, with your feet on the floor.
Active Head Restraints
In order for the active head restraint to operate properly: Do not hang any items on the head restraints, or

•
from the restraint legs.Do not place any objects between an occupant

•
and the seat-back.
After a collision, the activated restraint should
return to its normal position. If the restraints do not
return to their normal position, or in the event of a severe collision, have the vehicle inspected by a dealer.
Main MenuTable of Contents