oil additives HONDA FIT 2008 1.G Owners Manual
[x] Cancel search | Manufacturer: HONDA, Model Year: 2008, Model line: FIT, Model: HONDA FIT 2008 1.GPages: 280, PDF Size: 4.84 MB
Page 139 of 280
Help assure your vehicle’s f uture
reliability and perf ormance by paying
extra attention to how you drive
during the f irst 600 miles (1,000 km).Avoid full-throttle starts and rapid
acceleration.
During this period: Your vehicle is designed to operate
on unleaded gasoline with a pump
octane number of 87 or higher. Use
of a lower octane gasoline can cause
a persistent, heavy metallic rapping
noise that can lead to engine damage.
In addition, in order to maintain good
perf ormance, f uel economy, and
emissions control, we strongly
recommend, in areas where it is
available, the use of gasoline that
does NOT contain manganese-based
f uel additives such as MMT.
Use of gasoline with these additives
may adversely af f ect perf ormance,
and cause the malfunction indicator
lamp on your instrument panel to
come on. If this happens, contactyour authorized dealer f or service.
Some gasoline today is blended with
oxygenates such as ethanol or
MTBE. Your vehicle is designed to
operate on oxygenated gasoline
containing up to 10 % ethanol by
volume and up to 15 % MTBE by
volume. Do not use gasoline
containing methanol.
If you notice any undesirable
operating symptoms, try another
service station or switch to another
brand of gasoline.
For f urther important f uel-related
inf ormation, please ref er to your
.
Avoidhardbrakingforthefirst
200 miles (300 km).
Do not change the oil until the
scheduled maintenance time.
You should also f ollow these
recommendations with an
overhauled or exchanged engine, or
when the brakes are replaced. We recommend using quality
gasolines containing detergent
additives that help prevent fuel
system and engine deposits.
Break-in Period Fuel Recommendation
Quick Start Guide
Break-in Period, Fuel Recommendation
136
\f—\f—y\f\f\fy
(
\fy\f
y
2008 Fit
Page 191 of 280
Your vehicle does not require any oil
additives. Additives may adversely
af f ect the engine or transmission
perf ormance and durability.Run the engine until it reaches
normal operating temperature,
then shut it off.
Open the hood, and remove the
engine oil f ill cap. Remove the oil
drain bolt and washer f rom the
bottom of the engine. Drain the oil
into an appropriate container.
Always change the oil and f ilter
according to the maintenance
messages shown on the inf ormation
display. The oil and f ilter collect
contaminants that can damage your
engine if they are not removed
regularly.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
mechanic.
You may use a synthetic motor oil if
it meets the same requirements
given f or a conventional motor oil, it
displays the API Certif ication Seal,
and it is the proper weight. You must
f ollow the oil and f ilter change
intervals given in the maintenance
schedule.
1.
2.
Synthetic Oil
Engine Oil A dditives
Changing the Engine Oil and
Filter
A dding Engine Oil, Changing the Engine Oil and Filter
188
WASHER
OIL DRAIN BOLT
\f—\f—y\f\fy
(
\fy\f
y
2008 Fit
Page 197 of 280
Check the f luid level with the
transmission at normal operating
temperature and the vehicle on level
ground. Remove the transmission
f iller bolt, and caref ully f eel inside
the bolt hole with your f inger. The
f luid level should be up to the edge
of the bolt hole. If it is not, add
Honda Manual Transmission Fluid
(MTF) until it starts to run out of the
hole.Put a new washer on the f iller bolt,
then reinstall the f iller bolt and
tighten it securely.
If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certif ication seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,
motor oil does not contain the proper
additives, and continued use can
cause stiffer shifting. Replace as
soon as it is convenient.
If you are not sure how to check and
add f luid, contact your dealer.
Insert the dipstick all the way back
into the transmission securely as
shown in the illustration.
If you are not sure how to add f luid,
contact your dealer.
6.
T ransmission Fluid
Manual Transmission Fluid
194
WASHER
Correct level FILLER BOLT
Use only Honda Genuine ATF-Z1
(Automatic Transmission Fluid). Do
not mix with other transmission f luids.
Using transmission f luid other than
Honda Genuine ATF-Z1 may cause
deterioration in transmission operation
and durability, and could result in
damage to the transmission.
Damage resulting f rom the use of
transmission f luid other than Honda
Genuine ATF-Z1 is not covered by the
Honda new vehicle warranty.
\f—\f—y\f
y
(
\fy\f
y
2008 Fit
Page 266 of 280
CONT INUED
....................................
Accessories .144
ACCESSORY (Ignition Key
.......................................
Position) .78
...............
Accessory Power Socket .99
....................
Additives, Engine Oil .188
.......
Adjusting the Steering Wheel .75
...........................
Advanced Airbags .27
...............................
Airbag (SRS) .9,22
..............
Air Conditioning System .102
.........................................
Usage .103
.......................
Air Pressure, Tires .210
.......................
Alcohol in Gasoline .136
......................................
Antif reeze .190
Anti-lock Brakes (ABS)
...............................
Indicator .62,168
...................................
Operation .168
..............
Anti-thef t, Audio System .128
.
Anti-thef t Steering Column Lock .78
................................
Audio System .107
...
Automatic Seat Belt Tensioners .20
.............
Automatic Speed Control .131
..............
Automatic Transmission .157
..........................
Capacity, Fluid .244
...............
Checking Fluid Level .193 ..........................
Paddle Shif ters .162
.......................................
Shif ting .157
Shif t Lever Position
...............................
Indicators .157
................
Shif t Lever Positions .158
....................
Shif t Lock Release .161
......................
Auxiliary Input Jack .127
............................
Capacities Chart .244
.............
Carbon Monoxide Hazard .53
Battery
Charging System ...........................
Indicator .60,230
............................
Jump Starting .226
..............................
Maintenance .214
............................
Specif ications .245
..............................
Bef ore Driving .135
....................................
Belts,Seat.8,18
...........................
Beverage Holders .98
..................................
Booster Seats .50
Brakes
...........
Anti-lock System (ABS) .168
.............
Break-in, New Linings .136
....................
Bulb Replacement .201
...........................................
Fluid .195
.........................................
Parking .96 .................
System Indicator .60,232
..........................
System Design .167
........................
Wear Indicators .167
.............................
Braking System .167
.................
Break-in, New Vehicle .136
..
Brightness Control, Instruments .74
..................
Brights, Headlights .72,73
Bulb Replacement
..........................
Back-up Lights .201
..............................
Brake Lights .201
Front Parking Lights/
...
Front Side Marker Lights .198
.................................
Fog Lights .199
.................................
Headlights .196
.........
High-mount Brake Light .202
............................
Specif ications .245
....................................
Taillights .201
............
Turn Signal Lights .198,201
..............................
Bulbs, Halogen .196
Index
A
B
C
INDEX
I
\f—\f—y\f\fy
(
\fy\fy
2008 Fit