ignition HONDA HR-V 2016 2.G Manual PDF

383Continued
Maintenance
Maintenance MinderTM
If the engine oil life is less than 15%, you will see the Maintenance Minder messages
appear on the information display every time you turn the ignition switch to ON
(w*1. The messages notify you when to change the engine oil, or when to bring your
vehicle to a dealer for indicated maintenance services.
To Use Maintenance MinderTM
1. Turn the ignition switch to ON (w*1.
2. Press the (select/reset) knob repeatedly
until the engine oil life appears on the
information display.
The Maintenance Minder indicator ( ) stays
on in the instrument panel after the engine oil
life becomes 0% . Have the indicated
maintenance done by a dealer immediately.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
■Displaying the Engine Oil Life1 Displaying the Engine Oil Life
Based on the engine ope rating conditions, the
remaining engine oi l life is calculated and displayed
as a percentage.
Displayed Engine Oil Life (%)Calculated Engine Oil Life (%)
100 100 to 91
9090 to 81
80 80 to 71
7070 to 61
60 60 to 51
5050 to 41
40 40 to 31
3030 to 21
20 20 to 16
1515 to 11
10 10 to 6
55 to 1
00
15 HR-V GAS-31T7A6000.book 383 ページ ２０１５年６月２９日　月曜日　午前１１時３６分

uuMaintenance MinderTMuTo Use Maintenance MinderTM
386
Maintenance
Reset the engine oil life display if yo u have performed the maintenance service.
1. Turn the ignition switch to ON
(w*1.
2. Display the engine oil life by repeatedly
pressing the (select/reset) knob.
3. Press and hold the knob for ten seconds
or more.
u The engine oil life indicator and the
maintenance item codes blink.
4. Press the knob for five seconds or more.
u The displayed maintenance items
disappear, and the engine oil life display
returns to 100%.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
■Resetting the Display1 Resetting the Display
NOTICE
Failure to reset the engine oil life after a maintenance
service results in the sy stem showing incorrect
maintenance intervals, which can lead to serious
mechanical problems.
The dealer will reset the en gine oil life display after
completing the required ma intenance service. If
someone other than a deal er performs maintenance
service, reset the engine oil life display yourself.
15 HR-V GAS-31T7A6000.book 386 ページ ２０１５年６月２９日　月曜日　午前１１時３６分

434
Handling the Unexpected
If a Tire Goes Flat
Changing a Flat Tire
If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually
to reduce speed. Then, stop in a safe place. Replace the flat tire with a compact
spare tire. Go to a dealer as soon as possibl e to have the full-size tire repaired or
replaced.
1. Park the vehicle on firm, level, and non-slippery surface and apply the parking
brake.
2. Move the shift lever to
(P.
2. Move the shift lever to
(R.
3. Turn on the hazard warning lights an d turn the ignition switch to LOCK
(0*1.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Changing a Flat Tire
Periodically check the tire pressure of the compact
spare. It should be set to the specified pressure.
Specified Pressure: 60 psi (420 kPa, 4.2 kgf/cm
2)
When driving with the compact spare tire, keep the
vehicle speed under 50 mph (80 km/h). Replace with
a full-size tire as soon as possible.
The compact spare tire and wheel in your vehicle are
specifically for this model. Do not use them with
another vehicle. Do not us e another type of compact
spare tire or wheel with your vehicle.
Do not mount tire chains on a compact spare tire.
If a chain-mounted front tire goes flat, remove one of
the full-size rear tires and replace it with the compact
spare tire. Remove the flat front tire and replace it
with the full-size tire that was removed from the rear.
Mount the tire chains on the front tire.
Continuously variable transmission models
Manual transmission models
All models
15 HR-V GAS-31T7A6000.book 434 ページ ２０１５年６月２９日　月曜日　午前１１時３６分

448
Handling the Unexpected
Shift Lever Does Not Move
Follow the procedure below if you cannot move the shift lever out of the (P
position.
1.Set the parking brake.
2. Remove the key from the ignition switch.
2. Remove the built-in key from the smart
entry remote.
3. Wrap a cloth around the tip of a small flat-
tip screwdriver. Put it into the shift lock
release slot as shown in the image, and
remove the cover.
4. Insert the key into the sh ift lock release slot.
5. While pushing the key down, press the shift
lever release button and place the shift lever
into
(N.
u The lock is now released. Have the shift
lever checked by a dealer as soon as
possible.
■Releasing the Lock
Continuously variable transmission models
SlotCover
Models without smart entry system
Models with smart entry system
All models
Release Button
Shift Lock
Release Slot
15 HR-V GAS-31T7A6000.book 448 ページ ２０１５年６月２９日　月曜日　午前１１時３６分

456
Handling the Unexpected
Fuses
Fuse Locations
If any electrical devices are not working,
turn the ignition switch to LOCK
(0*1 and
check to see if any appl icable fuse is blown.
■Fuse box A
Located near the brake fluid reservoir. Push
the tabs to open the box.
Fuse locations are shown on the fuse box
cover. Locate the fuse in question by the
fuse number and box cover number.
■Engine Compartment Fuse Box
Tab
■Circuit protected and fuse rating
Circuit ProtectedAmps
1Headlight Low Beam Main20 A
2CDC*(30 A)
3Hazard10 A
4DBW15 A
5Wiper*(30 A)
6Stop10 A
7IGP15 A
8IG Coil15 A
9EOP*(10 A)
10INJ*(20 A)
11VST2*(30 A)
12Main Fan30 A
13Starter SW*(30 A)
14MG Clutch7.5 A
15Battery Sensor(7.5 A)
16Small Light10 A
17AFP Main*(10 A)
18Horn10 A
19Fog Light*(10 A)
20SBW*(10 A)
*1:Models with the sma rt entry system have
an ENGINE START/STOP button
instead of an ignition switch.
Circuit ProtectedAmps
21Back Up Main10 A
22Audio(10 A)
23Sub Fan(30 A)
24VST1*(30 A)
25STRLD*(7.5 A)
26IGP CAM*(7.5 A)
27––
28––
29Back Up*(30 A)
30IGP LAF(7.5 A)
31IGPS(7.5 A)
32Right Headlight Low Beam10 A
33Left Headlight Low Beam10 A
* Not available on all models
15 HR-V GAS-31T7A6000.book 456 ページ ２０１５年６月２９日　月曜日　午前１１時３６分

460
uuFuses uInspecting and Changing Fuses
Handling the Unexpected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK (0*1. Turn
headlights and all accessories off.
2. Check the fuses on the battery in the
engine compartment.
u If the fuse is blown, have it replaced by a
dealer.
3. Remove the fuse box cover.
4. Inspect the small fuses in the engine
compartment and the vehicle interior.
u If there is a burned out fuse, remove it
with the fuse puller and replace it with a
new one.
5. Check the large fuse in the vehicle interior.
u If the fuse is blown, use a Phillips-head
screwdriver to remo ve the screw and
replace it with a new one.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Inspecting and Changing Fuses
NOTICE
Replacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a new one of the same specified
amperage.
Confirm the specified amperage using the charts on
Fuse Locations .
There is a fuse puller on the back of the engine
compartment fuse box cover.
Fuse Box on the Battery Blown
Fuse Puller
Combined Fuse
Blown Fuse
15 HR-V GAS-31T7A6000.book 460 ページ ２０１５年６月２９日　月曜日　午前１１時３６分

471Continued
Information
Emissions Testing
Testing of Readiness Codes
Your vehicle has “Readiness Codes,” as part of the onboard self diagnostic system.
Some states use these codes as a test to see if your vehicle’s emissions components
are working properly.
The codes may not be read properly if testing is performed just after the battery has
gone dead or been disconnected.
To check if they are set, tu rn the ignition switch to ON
(w*1, without starting the
engine. The malfunction indicator lamp will co me on for several seconds. If it then
goes off, the readiness codes are set. If it blinks five times, the readiness codes are
not set.
If you are required to have your vehicle te sted before the readiness codes are ready,
prepare the vehicle for retest ing by doing the following:
1. Fill the gas tank to approximately 3/4 full.
2. Park the vehicle and leave the engine off for 6 hours or more.
3. Make sure the ambient temperature is between 40°F and 95°F (4°C and 35°C).
4. Start the engine without touching the ac celerator pedal, and let it idle for 20
seconds.
5. Keep the vehicle in
(P (continuously variable transmission) or (N (manual
transmission). Increase the engine speed to 2,000 rpm, and hold it there for about
three minutes.
6. Let the engine idle with your foot off the accelerator for 20 seconds.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Testing of Readiness Codes
The readiness codes are erased when the battery is
disconnected, and set again only after several days of
driving under a variety of conditions.
If a testing facility determines that the readiness
codes are not set, you may be requested to return at
a later date to complete the test.
If the testing facility determines the readiness codes
are still not set, see a dealer.
15 HR-V GAS-31T7A6000.book 471 ページ ２０１５年６月２９日　月曜日　午前１１時３６分

481
Index
Information............................................. 374
Low Fuel Indicator..................................... 76
Refueling ................................................ 374
Gauges ........................................................ 88
Gear Shift Lever Positions
Continuously Variable Transmission ................................. 334, 336
Manual Transmission .............................. 341
Glass (care) ....................................... 425, 428
Glove Box ................................................. 152
H
Halogen Bulbs .................................. 399, 401
Handling the Unexpected ....................... 431
HandsFreeLink ® (HFL) ...................... 260, 283
Menus ............................................ 262, 286
Phone Setup ................................... 266, 291
Hazard Warning Button .............................. 4
Head Restraints ........................................ 142
Headlights ................................................ 127
Aiming.................................................... 399
Dimming......................................... 127, 131
Operating ............................................... 127
Heated Door Mirrors ............................... 135
Heated Windshield .................................. 136
Heating and Cooling System ................... 161
Cooling................................................... 164
Defrosting the Windshield and Windows .............................................. 164
Dust and Pollen Filter .............................. 424 Heating ................................................... 163
HFL (HandsFreeLink ®)....................... 260, 283
High Beam Indicator .................................. 80
Hill Start Assist System ..................... 327, 331
I
Identification Numbers ............................ 468
Engine and Transmission ......................... 468
Vehicle Identification ............................... 468
Ignition Switch .......................................... 122
Illumination Control ................................. 134
Knob ....................................................... 134
Immobilizer System .................................. 116
Indicator .................................................... 81
Important Handling Information .............. 32
Indicators .................................................... 72
All-Wheel Drive (AWD) .............................. 82
Anti-lock Brake System (ABS) ..................... 77
Automatic Brake Hold ....................... 74, 366
Automatic Brake Hold System ............ 73, 366
Brake Depressing ....................................... 74
Brake System (Amber) ............................... 72
Brake System (Red) ............................ 72, 453
Charging System ............................... 75, 451
CRUISE CONTROL .............................. 82, 345
CRUISE MAIN .................................... 82, 344
Door and Tailgate Open ...................... 34, 78
ECON Mode .............................................. 81
Electric Parking Brake ................................ 73
Electric Parking Brake System ............. 73, 454 Electric Power Steering (EPS)
System ............................................ 78, 453
Fog Light ................................................... 80
Forward Collision Warning (FCW) .............. 83
High Beam ................................................ 80
High Temperature ..................................... 77
Immobilizer System ................................... 81
Lane Departure Warning (LDW) ................. 84
Lights On .................................................. 80
Low Fuel ................................................... 76
Low Oil Pressure ................................ 75, 451
Low Temperature ...................................... 77
Low Tire Pressure .............................. 79, 359
Maintenance Minder
TM...................... 82, 383
Malfunction Indicator Lamp............... 75, 452
Seat Belt Reminder .............................. 36, 76
Security System Alarm ............................... 82
Shift Lever Position .................................... 75
Smart Entry System ................................... 79
Starter System ........................................... 80
Supplemental Restraint System ............ 54, 77
TPMS ........................................................ 79
Transmission ............................................. 76
Turn Signal ................................................ 80
Vehicle Stability Assist (VSA® )
System ............................................ 78, 354
VSA ® OFF .......................................... 78, 355
Washer Level ............................................. 82
Information .............................................. 465
Information Display ................................... 89
15 HR-V GAS-31T7A6000.book 481 ページ ２０１５年６月２９日　月曜日　午前１１時３６分