automatic transmission HONDA INSIGHT 2010 2.G User Guide

´
µ
´ µ
To shif t up or down, use the
(right) or (lef t) paddle shif ter on
either side of the steering wheel.
Pull the (right) paddle shifter to
upshift. Pull (left) to downshift. When you pull either paddle shif ter,
the shif t indicator shows you the
selected speed number.
Downshif ting gives you more power
when climbing, and provides engine
braking when going down a steep hill. WhenyouaredrivingintheD
position, pulling either paddle shif ter
switches f rom the ordinary
automatic transmission (CVT) to the
D-paddle shif t mode. You can shif t
the transmission up or down through
seven-stages manually with the
paddle shif ters.
When the transmission returns to
ordinary automatic transmission
(CVT), the displayed shif t indicator
disappears.
Except LX models
Driving with the Paddle Shif ters
Using the Paddle Shif ters in the
D position (D-Paddle Shif t Mode)
316
SHIFT INDICATOR
—
—y
y
)"y
y
2010 Insight

´
µ
CONT INUED
The transmission control system
monitors the accelerator pedal use
and your driving conditions. When
you press the accelerator pedal as in
the normal driving, the system
judges that you are driving at a
constant cruising speed without
using the paddle shif ters. Under
these conditions, D-paddle shif t
mode is canceled, and the
transmission automatically returns to
ordinary automatic transmission
(CVT). When the transmission returns to
ordinary automatic transmission
(CVT), the displayed shif t indicator
disappears.
To cancel the D-paddle shif t mode
manually, pull and hold the side
paddle shif ter until the shif t indicator
goes out.
Downshifting with the (left)
paddle shif ter allows you to increase
the engine braking when going down
steep or long hills, and provides
more power when climbing uphills.
You can upshif t the transmission
manually to reduce the rpm.
The transmission remains in the
selected speed if you do not
accelerate.
Driving with the Paddle Shif ters
Driving
317
—
—y
y
)"yy
2010 Insight

Each time you pull either paddle
shif ter, the transmission shif ts one
speed up or down. If you want to
shif t up or down more than two
speeds, pull the paddle shif ter twice,
pause, and then pull it again.The automatic transmission (CVT)
will not allow you to change shif t if :
The transmission downshif ts to f irst
speed and returns to ordinary
automatic transmission (CVT) when
the vehicle comes to a complete stop
and the vehicle speed is about 6 mph
(10 km/h).
If there is a problem in the
transmission while you are driving
with the paddle shifters, the D
indicator f lashes, the D-paddle shif t
mode is canceled, and the
transmission returns to ordinary
automatic transmission (CVT).
You downshif t bef ore the engine
speed reaches the highest
threshold of the lower speed.
If you try to do this, the shift
indicator will f lash the number of
the lower speed several times,
then return to a higher speed.
You upshif t bef ore the engine
speed reaches the lowest
threshold of the higher speed.
You press both paddle shif ters at
thesametime.
You pull one of the two paddle
shifters with another paddle
shif ter being pressed.
Driving with the Paddle Shif ters
318
—
—y


y
)"yy
2010 Insight

´µ µ
With the shif t lever in the S position,
you can select the 7-Speed Manual
shif t mode to shif t speeds; much like
a manual transmission using the
paddle shif ters, but without a clutch
pedal.
To enter the 7-speed manual shif t
mode, press the release button on
thesideof theshiftlever,movethe
lever to the S position, then pull
either paddle shif ter. To cancel the
7-speed manual shif t mode and
return to the ordinary automatic
transmission (CVT), move the shif t
lever f rom the S position. When
moving the shift lever, be careful not
to operate incorrectly. While you are
driving in the 7-speed manual shif t
mode, the transmission will not
automatically return to the ordinary
automatic transmission (CVT). When you move the shif t lever f rom
the ‘‘D’’ to ‘‘S’’ position and pull
either paddle shif ter, the shif t
indicator displays ‘‘M’’ along with the
selected speed number.
To upshif t, pull the (right) paddle
shif ter. To downshif t, pull the
(lef t) paddle shif ter.If you keep depressing the
accelerator pedal without pressing
the paddle shif ter, the speed will be
automatically shifted up just before
the tachometer’s red zone.
The transmission also shif ts
automatically as the vehicle comes to
a complete stop. It downshif ts to f irst
speed when the vehicle speed
reaches 6 mph (10 km/h) or less.
Downshifting with the (left)
paddle shif ter allows you to increase
the engine braking when going down
steep or long hills, and provides
more power when climbing uphills.
You can upshif t the transmission
manually to reduce the rpm.
CONT INUED
Except LX models
Driving with the Paddle Shif ters
Using the Paddle Shif ters in the S
position (7-Speed Manual Shif t
Mode)
Driving
319
SHIFT INDICATOR
‘‘M’’ INDICATOR
—
—y
y
)"yy
2010 Insight

µ
à
à
à
à
à
à
The automatic transmission (CVT)
will not allow you to change shif t if :
You downshif t bef ore the engine
speed reaches the highest
threshold of the lower speed.
If you try to do this, the shift
indicator will f lash the number of
the lower speed several times,
then return to a higher speed.
You upshif t bef ore the engine
speed reaches the lowest
threshold of the higher speed.
You press both paddle shif ters at
thesametime.
You pull one of the two paddle
shifters with another paddle
shif ter being pressed. Drive in the highest speed number
that lets the engine run and
accelerate smoothly. This will give
you ef f ective emissions control. The
f ollowing shif t points are
recommended:
To shift to Low,
press and hold both paddle shif ters
simultaneously until you see L in the
shift indicator. Use Low to get more
power when climbing, and f or
maximum engine braking when
going down steep hills.
Shif t up 12
23
34
45
56
67 Normal acceleration
15 mph (24 km/h)
25 mph (40 km/h)
40 mph (64 km/h)
45 mph (72 km/h)
50 mph (81 km/h)
55 mph (89 km/h)
Driving with the Paddle Shif ters
Recommended Shif t Points L (L ow) mode
320
—
—y
y
)"yy
2010 Insight

The engine automatically stops
when:
The vehicle comes to a stop with the
shif t lever in the D position and the
brake pedal pressed.The engine will not stop
automatically under the f ollowing
conditions:
Vehicle speed does not go above 7
mph (11 km/h) af ter starting the
engine
The engine coolant temperature is
low
The transmission f luid
temperature is low
The vehicle is stopped with the
shif t position in R, S, or L
When the vehicle is stopped on an
incline
The climate control is in use and
either or is pressed The engine may not stop
automatically under the following
conditions:
When the ECON button is on, the
engine is more likely to stop. See
page f or the ECON button.
The vehicle is stopped by braking
suddenly Theclimatecontrolsystemisin
use to dehumidif y the moist air
inside the vehicle The ECON button is off, and there
is a signif icant dif f erence between
the ambient temperature and the
temperature setting of the climate
control system The IMA battery temperature is
excessively high or low The IMA battery charge is low
The engine may also stop when
vehicle speed drops below 7 mph (11
km/h) with the brake pedal pressed. To help maximize f uel economy,
your vehicle has an Auto Idle Stop
f unction. Depending on
environmental conditions and vehicle
operation, the engine will shut of f
when you come to a stop.
124
Auto Idle Stop
Driving
321
—
—y

y
)"yy
2010 Insight

If you have the skills and tools to
perf orm more complex maintenance
tasks on your vehicle, you may want
to purchase the service manual. See
page f or inf ormation on how to
obtain a copy, or see your dealer. This section explains why it is
important to keep your vehicle well
maintained and how to f ollow basic
maintenance saf ety precautions.
This section also includes
instructions on how to read the
maintenance minder messages on
the multi-information display, and
instructions f or simple maintenance
tasks you may want to take care of
yourself .......................
Maintenance Saf ety .336
....................
Maintenance Minder . 337
..............................
Fluid Locations .347
........................
Adding Engine Oil .348
.........
Changing the Oil and Filter . 350
..............................
Engine Coolant .353
....................
Windshield Washers .355
....
Automatic Transmission Fluid . 356
Continuously Variable ............
Transmission (CVT) . 356
....................................
Brake Fluid .357
.............................................
Lights .359
................................
Roof Antenna .369
................
Cleaning the Seat Belts . 369
.....................................
Floor Mats .369
..................
DustandPollenFilter . 370
.................................
Wiper Blades .370
...............................................
Tires .375
......
Checking the 12 Volt Battery . 381
.............................
Vehicle Storage .383
Maintenance
Maint enance
335
—
—y


y
)"yy
435
2010 Insight

µµµ
µ
µ µ
Youshouldcheckthefollowing
items at the specif ied intervals. If
you are unsure of how to perf orm
any check, turn to the appropriate
page listed.
Engine oil level Check every
time you fill the fuel tank. See
page .
Engine coolant level Check the
radiator reserve tank every time
youfillthefueltank.Seepage .
Automatic transmission Check
the f luid level monthly. See page .
Brakes Check the f luid level
monthly. See page .
Tires Check the tire pressure
monthly. Examine the tread f or
wear and foreign objects. See page . Lights Check the operation of
the headlights, parking lights,
taillights, high-mount brake light,
turn signals, brake lights, and
license plate light monthly. See
page .
According to state and federal
regulations, Honda will not deny a
claim f or emissions warranty
coverage simply because you did not
maintain the vehicle or do not have
maintenance records to show that
you did. However, any part of that
f ails because of abuse or lack of
required maintenance will not be
covered by this warranty. U.S. Vehicles:
289
356 357
375 359
288
CONT INUED
Owner’s Maintenance Checks
Maintenance, replacement, or
repair of emissions control
devices and systems may be done
by any automotive repair
establishment or individual using
parts that are ‘‘certif ied’’ to EPA
standards.
Maintenance Minder
Maint enance
345
—
—y


y
)"yy
2010 Insight

Fluid Locations
Maint enance
347
RADIATOR CAP
ENGINE OIL DIPSTICK
(Orange loop)
WASHER FLUID
(Blue cap) AUTOMATIC
TRANSMISSION (CVT)
FLUID DIPSTICK
(Yellow loop)
ENGINE COOLANT
RESERVOIR BRAKE FLUID
(Black cap)
ENGINE OIL FILL CAP
—
—y


y
)"yy
2010 Insight

Check the f luid level with the engine
at normal operating temperature.Remove the dipstick (yellow loop)
f rom the transmission, and wipe it
with a clean cloth.
Insert the dipstick all the way into
the transmission securely as
shown in the illustration.
If the level is below the lower
mark, add f luid into the dipstick
hole to bring it to the level
between the upper and lower
marks.
Pour the f luid slowly and caref ully
so you do not spill any. Clean up
any spill immediately; it could
damage components in the engine
compartment.
Park the vehicle on level ground.
Start the engine, let it run until the
radiator f an comes on, then shut
of f the engine. For accurate
results, wait about 60 seconds (but
no longer than 90 seconds) bef ore
doing step 2. Remove the dipstick and check
the f luid level. There is a HOT
side and a COLD side on the
dipstick. The f luid level should be
between the upper and lower
marks on the HOT side.Always use Honda CVTF
(Continuously Variable
Transmission Fluid).
3.
4. 5.
2.
1. Continuously Variable
Transmission (CVT)
Automatic Transmission Fluid
356
DIPSTICK UPPER
MARK
HOT
Range LOWER
MARK
—
—y

y
)"y
y
2010 Insight