ECO mode HONDA PASSPORT 2002 2.G Owners Manual

4Driver and Passenger Safety
Yo u
’ll find many safety
recommendations throughout this
section, and throughout this
manual. The recommendations on
this page are the ones we consider
to be the most important.
Always Wear Your Seat Belt
A seat belt is your best protection
in all types of collisions. Airbags
supplement seat belts, but airbags
are designed to inflate only in a
moderate to severe frontal
collision. So even though your
vehicle is equipped with airbags,
make sure you and your
passengers always wear your seat
belts, and wear them properly.
(See page 13.)
Restrain All Children
Children are safest when they are
properly restrained in the back
seat, not the front seat. A child
who is too small for a seat belt must be properly restrained in a
child safety seat. (See page 18.)
Be Aware of Airbag Hazards
While airbags save lives, they can
cause serious or fatal injuries to
occupants who sit too close to
them, or are not properly
restrained. Infants, young
children, and short adults are at
the greatest risk. Be sure to follow
all instructions and warnings in
this manual. (See page 7.)
Don’t Drink and Drive
Alcohol and driving don
’t mix.
Even one drink can reduce your
ability to respond to changing
conditions, and your reaction time
gets worse with every additional
drink. So don’ t drink and drive,
and don’ t let your friends drink
and drive either. Control Your Speed
Excessive speed is a major factor
in crash injuries and deaths.
Generally, the higher the speed
the greater the risk, but serious
accidents can also occur at lower
speeds. Never drive faster than is
safe for current conditions,
regardless of the maximum speed
posted.
Keep Your Vehicle in Safe
Condition
Having a tire blowout or a
mechanical failure can be
extremely hazardous. To reduce
the possibility of such problems,
check your tire pressure and
condition frequently, and perform
all regularly scheduled
maintenance. (See page 204.)
Important Safety Precautions

Driver and Passenger Safety19
If you are wearing a seat belt,
the child can be torn from your
arms. For example, if your
vehicle crashes into a parked
vehicle at 30 mph (48 km/h), a
20 lb (9 kg) infant will become
a 600 lb (275 kg) force, and
you will not be able to hold on.
•Never put a seat belt over
yourself and an infant or
child. During a crash, the belt
could press deep into the child
and cause very serious injuries.
Children Should Sit in the
Back Seat
According to accident statistics,
children of all ages and sizes are
safer when they are restrained in
the back seat, not the front seat.
The National Highway Traffic
Safety Administration
recommends that all children ages
12 and under be properly
restrained in the back seat.
In the back seat, children are less
likely to be injured by striking
hard interior parts during a
collision or hard braking. Also,
children cannot be injured by an
inflating airbag when they ride in
the back.
The Passenger ’s Airbag
Poses Serious Risks to
Children
Airbags have been designed to
help protect adults in a moderate
to severe frontal collision. To do
this, the passenger ’s airbag is
quite large, and it inflates with
tremendous speed.
Infants
Never put a rear-facing child
seat in the front seat of a vehicle
equipped with a passenger ’s
airbag. If the airbag inflates, it
can hit the back of the child seat
with enough force to kill or very
seriously injure an infant.

Driver and Passenger Safety23
Due to variations in the design of
child seats, vehicle seats, and seat
belts, all child seats will not fit all
vehicle seating positions.
However, Honda is confident that
one or more child seat models can
fit and be properly installed in all
recommended seating positions in
your vehicle.
Before purchasing a child seat, we
recommend that parents test the
child seat in the specific vehicle
seating position (or positions)
where they intend to use the seat.
If a previously purchased child
seat does not fit, you may need to
buy a different one that will fit.

Driver and Passenger Safety26
3.Secure the child in the child
seat. Make sure the child is
properly strapped in the child
seat according to the child seat
maker ’ s instructions. A child
who is not properly secured in
a child seat can be thrown out
of the seat in a crash and
seriously injured.
Storing a Child Seat
When you are not using a child
seat, either remove it and store it
in a safe place, or make sure it is
properly secured. An unsecured
child seat can be thrown around
the vehicle during a crash or
sudden stop and injure someone.Protecting Infants
Child Seat Type
Only a rear-facing child seat
provides proper support for a
baby’ s head, neck, and back.
Infants up to about one year of
age must be restrained in a
rear-facing child seat.
Two types of seats may be used:
a seat designed exclusively for infants, or a convertible seat used
in the rear-facing reclining mode.
Placing a rear-facing child seat
in the front seat can result in
serious injury or death if the
airbags inflate.
Always place a rear-facing child
seat in the back seat, not the
front.
We recommend that an infant be
restrained in a rear-facing child
seat until the infant reaches the
seat maker
’s weight or height
limit and is able to sit up without
support.

64Instruments and Controls
and the engine. Stop as soon as it
is safe, turn off the engine, and
call for assistance.

If you keep driving with the
malfunction indicator lamp on,
you can damage your vehicle ’s
emissions controls and engine.
Those repairs may not be covered
by your vehicle’ s warranties.
Reduced Power
Indicator
This light comes on for a few
seconds when you turn the key to
the “ON” position
If it comes on at any other time, it
indicates that there is a problem in
the throttle “drive-by-wire”
system. With the light on, your
vehicle goes into “limp home” mode — the engine runs on three
cylinders, and the accelerator
pedal no longer controls engine
speed.
As soon as it is safe, pull off the
road and turn off the engine.
Restart the engine to reset the
system. If the light remains on, or
comes on again while driving,
have the vehicle towed to your
Honda dealer for repair.
Turn Signal
Indicators
A green light flashing on the
instrument panel lets you know
that the front and rear turn signal
lights are working. If the light
stays on and does not flash, check
for a burned out bulb. If there is
no light when the lever is moved,
check the fuse and bulb.
Whenever the Hazard Warning Flasher Switch is on, both turn
signals will flash.
Low Fuel Indicator
This light comes on when the tank
becomes nearly empty. Fill up the
tank as soon as possible.
If the low fuel indicator light
comes on when the fuel tank is
not nearly empty, have the fuel
tank sensing unit and related
components inspected and
repaired by your Honda dealer.
Driving on a road with many
sharp curves may cause the fuel
indicator light to blink
intermittently. This is normal.

67Instruments and Controls
as indicated by the “
U/S” (upshift)
light on the instrument panel.
If vehicle speed drops below
20 mph (30 km/h), or if the
engine is not running smoothly,
you should downshift to the next
lower gear. You may need to
downshift two or more gears to
keep the engine running smoothly
or for satisfactory performance.
This indicator comes on for a few
seconds when you turn the
ignition switch to the “ON”
position.4-Wheel Drive
(4WD) Indicator
4WD models only
This indicator lights when the
4-Wheel Drive system is engaged.
With the 4WD-2WD switch in the
“
OFF” or 2WD position, this light
will come on to provide a “bulb
check” when the key is turned to
the “
ON” position, but should go
out after the engine is started.
If the 4WD-2WD switch is in the
“
ON” or 4WD position, this light
will come on when the key is
turned to the “
ON” position and
remain on after the engine is
started.
Anti-Lock Indicator
This light will come on and go out
when the ignition switch is turned
to the “
ON” position. (If the light
does not come on, see your Honda
dealer to have the system
repaired.)
If the light remains on after
engine start-up or comes on
during operation of the vehicle,
stop as soon as possible and turn
the key off. Then start the engine
to reset the system. If the light
stays on, or it comes on again
while you’re driving, the anti-lock
brake system should be checked
at your Honda dealer.
Until you get it fixed, you ’ll have
normal brakes, but you won ’t
have anti-lock.

68Instruments and Controls
Check Automatic
Transmission Indicator
The indicator light comes on for a
few seconds when the ignition
switch is turned to the “
ON”
position.
If the light flashes, it means the
computer controlling the
transmission has found a problem.
Have the automatic transmission checked by your Honda dealer as
soon as possible. You can safely
drive the vehicle while the light is
flashing, but the computer may
put the transmission into its
“backup mode.”
In the backup mode, the
transmission may not shift
automatically. If the transmission
does not shift automatically, you
must move the shift lever to
change gears. This chart shows
the shift lever position and the
gear range that will result.
“L” position
First gear
“2” position
Third gear
“3” position
Fourth gear
“
D” position
Fourth gear When the transmission is in
backup mode and does not shift
automatically, you should move
the selector lever to the
appropriate position for your
driving needs, as follows:
Select “
3” or “D” for high speed
driving (over 50 mph, 80 km/h).
Select “2” for moderate speed
driving (between 15 mph [25
km/h] and 50 mph [80 km/h]).
Select “L” when starting from a
stop, driving up or down a steep
hill, or for engine braking when
towing a trailer downhill.
Do not exceed 65 mph (45 mph if
towing a trailer).

77Instruments and Controls
and the forward driving ranges.
The shift lever can be shifted
freely into any position indicated
by the arrow “
”. The lever
cannot be shifted into any position
indicated by the arrow “
”
without pushing the button
located on the end of the shift
lever.
PARK
REV
NEUT
DRIVE
3RD
2ND
1ST
In this 4-speed automatic
transmission, the following three
modes can be selected by pressing
the “
POWER” or “WINTER”
switch on the floor console, with
the key switch in the “
ON”
position:
•NORMAL mode
•POWER mode
•WINTER mode
P (Park)
— Used to lock the
transmission when the vehicle is
parked or while starting the
engine. Never move the shift lever
to Park until your vehicle is fully
stopped. Use this position
together with the parking brake.
The shift lever can be moved from
PARK position if the regular brake
is applied.
Refer to “Starting” in this section. R (Reverse)
— Used for backing
the vehicle. Bring your vehicle to
a complete stop before shifting to
Reverse.
N (Neutral) — The out-of-gear
position. You may restart a stalled
engine while the vehicle is still
moving with the selector in
Neutral. Refer to “Starting” in this
section. This position is also used
when towing the vehicle. See “In
Case of Emergency ” for towing
information.
D (Drive) (First to Fourth
Gear)
— This position is for all
normal forward driving. For
normal driving, we recommend
that you put the shift lever in the
“
D” range. This will reduce
vehicle noise and improve fuel
economy.

78Instruments and Controls
3 (Third) — When operating your
vehicle on slippery roads, on a
long descending slope, or on a
road with many sharp curves, you
will want to use engine braking.
At this time, put the shift lever
into this range.
2 (Second) — You may choose this
position when traveling down a
moderate grade where you want to
slow down a little without using
the brake itself. Change back to
the “
D” position to return to
normal driving. With the shift
lever in “2, ” the vehicle will start
in first gear and automatically shift
to second gear.
L (First) — This position may be
selected for maximum braking
down severe grades. Return the
selector lever to the “
D” position
to resume normal driving. It is
possible to move the lever into first gear at any speed. However,
the transmission will not actually
shift to first gear until vehicle
speed is below 35 mph (Power
Mode) or 25 mph (Normal Mode).
When starting out in “L,” the
transmission will not upshift.
Starting — Start the engine with
the lever in the “P” or “N”
position. It will not start in any
other position. If it does, have
your vehicle checked by your
Honda dealer.
Always apply the foot brake
before shifting into any driving
position. This prevents the vehicle
from creeping.
Do not press the accelerator pedal
while shifting from “
P” or “N” to
any driving position.
Shift Lock — As a safety measure
for vehicles with an automatic
transmission, you cannot shift
from “
P” (Park) position into any
other position unless the brake
pedal is depressed when the key
switch is in the “
ON” position or
the engine is running.
The shift lever may not move if
the pushbutton on the shift lever is
pressed before the brake pedal is
depressed. In this case, release
the pushbutton, press the brake
pedal and try again.
If the shift lever won’ t move from
the “
P” position even when these
instructions are followed, perform
the following steps:

80Instruments and Controls
Transfer Control
4WD Models
The “4WD” indicator light
illuminates when 4WD is engaged
with the 4WD-2WD switch.
“2H” (High Range, 2-Wheel
Drive)
Use this for normal driving on dry
pavement. This position gives
greater economy, quieter ride and
the least drivetrain wear.
“4H” (High Range, 4-Wheel
Drive)
Use this for normal driving on
gravel, wet, icy or snow-covered
roads. This position provides
greater traction than two-wheel
drive. Top speed is limited to 65
mph (105 km/h).
“4L” (Low Range, 4-Wheel
Drive)
Use this for maximum power and
traction. Top speed is limited to 65 mph (105 km/h). Use
“4L” for
climbing or descending steep
hills, off-road driving, and hard
pulling in sand, mud or deep
snow.
Operating the 4WD-2WD Switch
2H  4H: To shift between
ranges, push the switch
with the vehicle going in
a straight line at any
speed below 65 mph
(105 km/h). The 4WD
indicator will blink for a
short time as the system
completes the shift.
Taking your foot off the
accelerator pedal for a
moment will help to
engage the new range.
If the vehicle is stopped,
you should let it roll
forward slightly to
complete the shift.