reset HONDA PASSPORT 2002 2.G Owners Manual

55Instruments and Controls
This section explains the controls
and displays that contribute to the
daily operation of your Honda.
All the essential controls are
within easy reach.
Control Locations56
. . . . . . . . .
Indicators and Gauges 57 . . . . . .
Gauges 58 . . . . . . . . . . . . . . . . . .
Tachometer 58 . . . . . . . . . . . .
Speedometer 58
. . . . . . . . . . .
Odometer 58 . . . . . . . . . . . . .
Trip Odometer/
Reset Knob 58 . . . . . . . . . . .
Fuel Gauge 59 . . . . . . . . . . . .
Engine Coolant
Temperature Gauge 60 . . . .
Indicator Lights 61 . . . . . . . . . . .
Switches70 . . . . . . . . . . . . . . . . .
Windshield Wiper/Washer 70
Headlights 72 . . . . . . . . . . . . .
Illumination Control 73 . . . . .
Rear Window Defogger 74 . .
Rear Window Wiper/
Washer 74 . . . . . . . . . . . . . .
Turn Signals75 . . . . . . . . . . . .
Hazard Warning Flasher 76 . . Automatic Transmission76
. . . .
Transfer Control
(4WD Models)80 . . . . . . . . .
5-Speed Manual Transmission 83 Transfer Control
(4WD Models)84 . . . . . . . . .
Parking Brake 86 . . . . . . . . . . . .
Accelerator Pedal87 . . . . . . . . . .
Clutch Pedal 87 . . . . . . . . . . . . .
Instruments and Controls

57Instruments and Controls
Indicators and Gauges
ENGINE COOLANT
TEMPERATURE GAUGEANTI-LOCK BRAKE
SYSTEM INDICATOR
A/T OIL TEMP
INDICATOR LIGHT
(A/T only)
CHECK TRANS
INDICATOR LIGHT
(A/T only) SRS INDICATOR LIGHT
CHECK ENGINE
INDICATOR LIGHT
TACHOMETER
TURN SIGNAL INDICATOR LIGHT
4-WHEEL DRIVE (4WD)
INDICATOR LIGHT
HIGH BEAM INDICATOR LIGHT
SPEEDOMETER
ODOMETER TRIP ODOMETER
RESET KNOB
CHARGING SYSTEM
INDICATOR LIGHT BRAKE SYSTEM INDICATOR LIGHT
LOW OIL PRESSURE
INDICATOR LIGHT TURN SIGNAL INDICATOR LIGHT
FUEL GAUGE
SEAT BELT
REMINDER
LIGHT
CRUISE SET
INDICATOR LIGHT
WINTER DRIVE
INDICATOR LIGHT
POWER DRIVE
INDICATOR LIGHT
TRIP ODOMETER
LOW FUEL
INDICATOR LIGHT
REDUCED POWER
INDICATOR LIGHT

TACHOMETERSPEEDOMETER
ODOMETER TRIP ODOMETER
RESET KNOB
TRIP ODOMETER
58Instruments and Controls
Tachometer
The tachometer shows the engine
speed in revolutions per minute
(rpm). To protect the engine from
damage, never drive with the
tachometer needle in the red zone.
Speedometer
The speedometer shows vehicle
speed in miles per hour (mph).
Odometer
The odometer indicates the total
distance your vehicle has been
driven.
Trip Odometer/Reset Button
There are two trip odometers.
Each odometer works
independently, so you can keep
track of two different distances.
Switch between them and the
Gauges

ENGINE COOLANT
TEMPERATURE GAUGEFUEL GAUGE
59Instruments and Controlsodometer by repeatedly pressing
and releasing the reset button.
To reset a trip odometer, display
it, then press and hold the reset
button until the odometer clears to
zero.
Fuel Gauge
The fuel gauge will register the
approximate fuel level in the tank
when the key is in the “
ON”
position. The following conditions
may be considered normal:
•Gas station pumps may shut off
before the fuel gauge indicates
“
F” (FULL).
•The amount of fuel required for
a fill-up may not exactly
correspond to the gauge.
•The needle may not move away
from “
F” (FULL) until some
time after fill-up.

64Instruments and Controls
and the engine. Stop as soon as it
is safe, turn off the engine, and
call for assistance.

If you keep driving with the
malfunction indicator lamp on,
you can damage your vehicle ’s
emissions controls and engine.
Those repairs may not be covered
by your vehicle’ s warranties.
Reduced Power
Indicator
This light comes on for a few
seconds when you turn the key to
the “ON” position
If it comes on at any other time, it
indicates that there is a problem in
the throttle “drive-by-wire”
system. With the light on, your
vehicle goes into “limp home” mode — the engine runs on three
cylinders, and the accelerator
pedal no longer controls engine
speed.
As soon as it is safe, pull off the
road and turn off the engine.
Restart the engine to reset the
system. If the light remains on, or
comes on again while driving,
have the vehicle towed to your
Honda dealer for repair.
Turn Signal
Indicators
A green light flashing on the
instrument panel lets you know
that the front and rear turn signal
lights are working. If the light
stays on and does not flash, check
for a burned out bulb. If there is
no light when the lever is moved,
check the fuse and bulb.
Whenever the Hazard Warning Flasher Switch is on, both turn
signals will flash.
Low Fuel Indicator
This light comes on when the tank
becomes nearly empty. Fill up the
tank as soon as possible.
If the low fuel indicator light
comes on when the fuel tank is
not nearly empty, have the fuel
tank sensing unit and related
components inspected and
repaired by your Honda dealer.
Driving on a road with many
sharp curves may cause the fuel
indicator light to blink
intermittently. This is normal.

67Instruments and Controls
as indicated by the “
U/S” (upshift)
light on the instrument panel.
If vehicle speed drops below
20 mph (30 km/h), or if the
engine is not running smoothly,
you should downshift to the next
lower gear. You may need to
downshift two or more gears to
keep the engine running smoothly
or for satisfactory performance.
This indicator comes on for a few
seconds when you turn the
ignition switch to the “ON”
position.4-Wheel Drive
(4WD) Indicator
4WD models only
This indicator lights when the
4-Wheel Drive system is engaged.
With the 4WD-2WD switch in the
“
OFF” or 2WD position, this light
will come on to provide a “bulb
check” when the key is turned to
the “
ON” position, but should go
out after the engine is started.
If the 4WD-2WD switch is in the
“
ON” or 4WD position, this light
will come on when the key is
turned to the “
ON” position and
remain on after the engine is
started.
Anti-Lock Indicator
This light will come on and go out
when the ignition switch is turned
to the “
ON” position. (If the light
does not come on, see your Honda
dealer to have the system
repaired.)
If the light remains on after
engine start-up or comes on
during operation of the vehicle,
stop as soon as possible and turn
the key off. Then start the engine
to reset the system. If the light
stays on, or it comes on again
while you’re driving, the anti-lock
brake system should be checked
at your Honda dealer.
Until you get it fixed, you ’ll have
normal brakes, but you won ’t
have anti-lock.

81Instruments and Controls
Shifting the Transfer Control
Lever
4H
↔ 4L: Stop the vehicle. Place
the transmission lever in
“N” (Neutral) position.
Then move the transfer
control lever from 4H to
4L, or 4L to 4H.
Move the transfer control lever
quickly and securely between
positions. Do not stop midway.
The transfer gear box can be
damaged if the control lever is not
firmly in gear. Some noise is
normal when shifting.
Always stop the vehicle before
shifting between low and high
range (4H
4L or 4L
4H).
If the 4WD indicator continues to
blink rapidly, it indicates that the
system was shifted out of
sequence. Stop the vehicle, select
4WD with the 4WD-2WD switch, shift the lever from 4L to 4H, then
select 2WD. Drive in a straight
line to reset the system. If the
indicator continues to blink, see
your Honda dealer.
Do not use 4-wheel drive for
driving on dry pavement. This
causes noise and wear, and taking
tight turns can damage the
transfer case and driveshafts. It
also reduces fuel economy.
Be careful that you do not exceed
the following maximum allowable
speeds when accelerating.
mph (km/h)
RangeAutomatic TransmissionRange“L”“2”“3”
“2H”35 (56)65
(105)–
“4H”35 (56)65
(105)65
(105)
“4L”15 (24)30 (48)50 (81)
Driving Pattern Selector
You can select a driving pattern
suitable for existing driving
conditions.
When neither “POWER” nor
“
WINTER” lights are illuminated,
the normal driving program for
general driving conditions is
operative.

85Instruments and Controls
“4H” (High Range, 4-Wheel
Drive)
Use this for normal driving on
gravel, wet, icy or snow-covered
roads. This position provides
greater traction than two-wheel
drive. Top speed is limited to 65
mph (105 km/h).“4L” (Low Range, 4-Wheel
Drive)
Use this for maximum power and
traction. Top speed is limited to
65 mph (105 km/h). Use
“4L” for
climbing or descending steep
hills, off-road driving, and hard
pulling in sand, mud or deep
snow.
Operating the 4WD-2WD Switch
2H  4H: To shift between
ranges, push the switch
with the vehicle going in
a straight line at any
speed below 65 mph
(105 km/h). The 4WD
indicator will blink for a
short time as the system
completes the shift.
Taking your foot off the
accelerator pedal for a
moment will help to
engage the new range. Shifting the Transfer Control
Lever
4H
↔ 4L: Stop the vehicle.
Depress the clutch, then
move the transfer control
lever from 4H to 4L, or
4L to 4H.
Move the transfer control lever
quickly and securely between
positions. Do not stop midway.
The transfer gear box can be
damaged if the control lever is not
firmly in gear. Some noise is
normal when shifting.
If the 4WD indicator continues to
blink rapidly, it indicates that the
system was shifted out of
sequence. Stop the vehicle, select
4WD with the 4WD-2WD switch,
shift the lever from 4L to 4H, then
select 2WD. Drive in a straight
line to reset the system. If the
indicator continues to blink, see
your Honda dealer.

108Interior Features
The
LOCK button on the driver
’s
door panel removes power from
the passengers’ windows. Only
the driver ’s window can be raised
and lowered.
PASSENGERS’
WINDOW LOCK
OFF ON
Checking the Circuit Breaker
In the event the power windows
do not operate, check the circuit
breaker.
•To reset the circuit breaker, first
turn the ignition switch off, and
then push the knob on the circuit
breaker. The windows should
now operate.
•If the circuit breaker
immediately goes off again or
the windows do not operate,
have the electrical system
checked by a dealer as soon as
possible.
Operation
The tailgate has a hatch glass and
a door. The hatch glass must be
raised before opening the door.
To open the hatch glass, push in
on the button on the tailgate door.
If the tailgate is locked, first
unlock the tailgate with the power
door locks or by using the key in
the outside tailgate lock. Make
sure the rear window wiper is off
and in its parked position before
opening the hatch glass.
Lock
Unlock
Tailgate

125Comfort and Convenience Features
AM/FM/Cassette Stereo
Audio System
For LX and EX models
Your Honda’s audio system
provides clear reception on both
AM and FM bands, while the
preset buttons allow you to easily
select your favorite stations.
The cassette system features
Dolby B* noise reduction,
automatic sensing of chromium-
dioxide (CrO
2) tape, and
autoreverse for continuous play.
* Dolby noise reduction manufactured under
license from Dolby Laboratories Licensing
Corporation. “
DOLBY” and the symbol
are trademarks of Dolby Laboratories
Licensing Corporation.
Operating the Radio
The ignition switch must be in
ACCESSORY or ON. Turn the
system on by pressing the
PWR/
VOL knob. Adjust the volume by
turning the
PWR/VOL knob.
The band and frequency that the
radio was last tuned to is
displayed. To change bands, press
the
AM or FM button. On the FM
band, ST will be displayed if the
station is broadcasting in stereo.
Stereo reproduction on
AM is not
available.
You can use any of three methods
to find radio stations on the
selected band:
TUNE, SEEK, or
the
Preset buttons.
TUNE – Use the TUNE bar to tune
the radio to a desired frequency.
Press the right side (
) to tune to
a higher frequency, or the left side (
) to tune to a lower frequency.
The frequency numbers will start
to change rapidly. Release the bar
when the display reaches the
desired frequency. To change the
frequency in small increments,
press and release the
TUNE bar
quickly.
SEEK – The SEEK function
searches the band for a station
with a strong signal. To activate it,
press and release the
SEEK/SCAN
button. The system scans upward
from the current frequency. It
stops when it finds a station with
a strong signal.
Preset – You can store the
frequencies of your favorite radio
stations in the six preset buttons.
Each button will store one
frequency on the
AM band, and
two on the
FM band (FM1 and
FM2).
Audio System