seats HONDA PRELUDE 1998 User Guide

Protecting Children

3. The child seat should fit the vehicle seating position (or
positions) where it will be used.
Due to variations in the design of
child seats, vehicle seats, and seat
belts, all child seats will not fit all
vehicle seating positions.
However, Honda is confident that
one or more child seat models can fit
and be properly installed in all
recommended seating positions in
your vehicle. Whenever possible, we recommend
that parents test a child seat in the
specific vehicle seating position (or
positions) where they intend to use
the seat before making a purchase. If
a previously purchased child seat does not fit, you may need to buy a
different one that will fit.
Driver and Passenger SafetyProCarManuals.comMain Menu Table of Contents s t

Protecting Children

Placing a Child Seat

This page briefly summarizes Honda's recommendations on where
to place rear-facing and forward-
facing child seats in your vehicle.
Front Passenger's Seat

Infants: Never in the front seat, clue
to the passenger airbag hazard.
Small children: Not recommended, due to the passenger's airbaghazard. If a small child must ride
in front, move the vehicle seat to
the rear-most position and secure a front-facing child seat with theseat belt (see page 32).

Back Seats
Infants: Recommended positions.
Secure a rear-facing child seat
with the seat belt (see page 28).

Small children: Recommended
positions. Secure a front-facingchild seat with the seat belt (see
page 32).
Driver and Passenger Safety CONTINUED
Airbags Pose Serious
Risks to Children
The passenger's airbag inflates
with enough force to kill or seriously injure an infant in a
rear-facing child seat.
A small child in a forward-facing child seat is also at risk. If the
vehicle seat is too far forward, or the child's head is thrown
forward during a collision, an inflating airbag can kill orseriously injure the child.
If a small child must ride in the
front, follow the instructions
provided.
ProCarManuals.comMain Menu Table of Contents s t

Protecting Children

Installing a Child Seat

After selecting a proper child seat, and a good position to install the seat,
there are three main steps in
installing the seat:

1. Secure the child seat to the car
with a seat belt. All child seats

must be secured to the car with
the lap part of a lap/shoulder belt.
A child whose seat is not properly secured to the car can be
endangered in a crash. See pages 28 and 32 for instructions on how
to secure child seats in this car.

2. Make sure the child seat is firmly
secured. After installing a child
seat, push and pull the seat
forward and from side to side to
verify that it is secure. To provide security during normal
driving maneuvers, as well as during
a collision, we recommend that
parents secure a child seat as firmly as possible.
However, a child seat does not need
to be "rock solid." In some vehicles
or seating positions, it may be difficult to install a child seat so that
it does not move at all. Some side-to- side or forward-and-back movement
can be expected and should not
reduce the child seat's effectiveness.
If the child seat is not secure, try
installing it in a different seating
position, or use a different style of child seat that can be firmly secured
in the desired seating position.
3. Secure the child in the child seat.

Make sure the child is properly
strapped in the child seat
according to the child seat maker's
instructions. A child who is not
properly secured in a child seat can be thrown out of the seat and
be seriously injured in a crash.

Storing a Child Seat
When you are not using a child seat,either remove it and store it in a safe
place, or make sure it is properlysecured. An unsecured child seat can
be thrown around the vehicle during a crash or sudden stop and injure

someone.

Driver and Passenger SafetyProCarManuals.comMain Menu Table of Contents s t

Protecting Children
Protecting Infants
Child Seat Type
To provide proper support for a baby's head, neck and back, infants
up to about one year of age must be
restrained in a rear-facing child seat.
Two types of seats may be used: a seat designed exclusively for infants,
or a convertible seat used in the rear-
facing, reclining mode. We recommend that an infant stay in
a rear-facing child seat as long as
possible, until they reach the seat maker's weight or height limit and
are able to sit up without support.
Infant Seat Placement

In this vehicle, a rear-facing child seat can be placed in any seating
position in the back seat, but not in
the front seat.

Never put a rear-facing child seat in

the front seat. If the passenger's
airbag inflates, it can hit the back of
the child seat with enough force to
kill or seriously injure an infant. If an infant must be closely watched, we
recommend that another adult sit in
the back seat with the baby.

Do not put a rear-facing child seat in

a forward-facing position. If an

infant faces forward, they could be
very seriously injured during a frontal collision.

CONTINUED

Driver and Passenger Safety

Placing a rear-facing child seat
in the front seat can result in
serious injury or death if the
airbags inflate.
Always place a rear-facing child
seat in the back seat, not the
front.ProCarManuals.comMain Menu Table of Contents s t

Protecting Children

Infant Seat Installation

The lap/shoulder belts in the back seats have a locking mechanism that
must be activated to secure a child
seat.

The following pages provide instructions and tips on how to
secure a rear-facing child seat with
this type of seat belt.
1. With the child seat in the desiredback seating position, route the
belt through the child seat according to the seat maker's
instructions, then insert the latch
plate into the buckle. 2. To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
then let the belt feed back into the retractor (you might hear a
clicking noise as the belt retracts).
3. After the belt has retracted, tug on it. If the belt is locked, you will not
be able to pull it out. If you can pull
the belt out, it is not locked and
you will need to repeat these steps.

Driver and Passenger SafetyProCarManuals.comMain Menu Table of Contents s t

Protecting Children

Protecting Small Children
Child Seat Type
A child who can sit up without support, and who fits within the child
seat maker's weight and height
limits, should be restrained in a
forward-facing, upright child seat. Of the different seats available, we
recommend those that have a five-
point harness system as shown.
We also recommend that a small child stay in the child seat as long as
possible, until they reach the weightor height limit for the seat. Child Seat Placement
In this vehicle, the best place to
install a forward-facing child seat is
in one of the seating positions in the
back seat.

Placing a forward-facing child seat in
the front seat of a vehicle equipped
with a passenger airbag can be

hazardous. If the vehicle seat is too
far forward, or the child's head is thrown forward during a collision, an
inflating passenger's airbag canstrike the child with enough force to
cause very serious or fatal injuries. If
a small child must be closely
watched, we recommend that another adult sit in the back seat
with the child.

CONTINUED

Driver and Passenger SafetyProCarManuals.comMain Menu Table of Contents s t

Protecting Children

Protecting Larger Children
When a child reaches the recommended weight or height limit
for a forward-facing child seat, the child should sit in one of the backseats and wear a lap/shoulder belt.
If a child is too short for the shoulder
part of the belt to properly fit, we recommend that the child use a
booster seat until they are tallenough to use the seat belt without a

booster.

The following pages give instructions on how to check properseat belt fit, what kind of booster
seat to use if one is needed, and
important precautions for children
who must sit in the front seat.
Checking Seat Belt Fit

To determine whether a lap/
shoulder belt properly fits a child,
first have the child put on the seat belt, following the instructions on
page 14. Then check how the belt

fits.

CONTINUED

Driver and Passenger Safety

Allowing a larger child to sit
improperly in the front seat can
result in injury or death if the
airbags inflate.
If a larger child must sit in front,
they should move the seat as
far back as possible and wear their seat belt properly.ProCarManuals.comMain Menu Table of Contents s t

Protecting Children

Physical Size

Physically, a child must be large
enough for the lap/shoulder belt to
properly fit over their hips, chest, and shoulder (see page 14). If the
seat belt does not fit properly, the
child should not sit in the front.

Maturity

To safely ride in front, a child must be able to follow the rules, including
sitting properly and wearing their

seat belt properly throughout a ride. If you decide that a child can safely
ride up front, be sure to:
Carefully read the owner's manual,
and make sure you understand all seat belt instructions and all safety
information. Move the vehicle seat to the rear-
most position.
Have the child sit up straight with
their back against the seat and
their feet on or near the floor. Check that the child's seat belt is
properly positioned and secured.
Closely supervise the child. Even
mature children sometimes need
to be reminded to fasten their seat
belt or sit properly.
Using Child Seats with Tethers

Your car has two attachment points on the rear shelf for securing a
tether-style child seat to the car.

Driver and Passenger SafetyProCarManuals.comMain Menu Table of Contents s t

Additional Information About Your Seat Belts

All seat belts have an emergency locking retractor. In normal driving,
the retractor lets you move freely in
your seat while it keeps some
tension on the belt. During a collision or sudden stop, the retractor
automatically locks the belt to help
restrain your body.
The seat belts in all seating positions except the driver's have an additional
locking mechanism that must be activated to secure a child seat. (See
pages 28 and 32 for instructions on
how to secure child seats with this
type of seat belt.)
If the shoulder part of the belt is
pulled all the way out, the locking
mechanism will activate. The belt
will retract, but it will not allow a passenger to move freely. To deactivate the locking
mechanism, unlatch the buckle and
let the seat belt fully retract. To
refasten the belt, pull it out only as
far as needed.
See page 14 for instructions on how
to wear the lap/shoulder belt
properly.

Driver and Passenger SafetyProCarManuals.comMain Menu Table of Contents s t

Seat Adjustments

Front Seat Adjustments
See pages 11 — 12 for important safety
information and warnings about how to
properly position seats and seat-backs.
Make all seat adjustments before
you start driving.
To adjust the seat forward and backward, pull up on the lever under
the seat cushion's front edge. Move
the seat to the desired position andrelease the lever. Try to move the
seat to make sure it is locked in

position.
To change the angle of the seat-back,
pull up on the lever on the outside of
the seat bottom. Move the seat-back
to the desired position and release the lever. Let the seat-back latch in

the new position.

Instruments and ControlsProCarManuals.comMain Menu Table of Contents s t