HONDA S2000 2008 2.G Owners Manual

If your vehicle needs to be towed,
call a prof essional towing service or
organization. Never tow your vehicle
with just a rope or chain. It is very
dangerous.The operator will load
your vehicle on the back of a truck.
Any other method of towing will
damage the drive system. When you
contact the towing agency, inf orm
them a f lat-bed is required. If your vehicle gets stuck in sand,
mud, or snow, call a towing service
to pull it out (see the previous
column).
For very short distances, such as
f reeing the vehicle, you can use the
detachable towing hook that mounts
on the anchors in the front and rear
bumpers.To use the towing hook:
Remove the cover f rom the
bumper.
Using the wheel nut wrench,
fasten the extension into the bolt
hole in the anchor.
Remove the towing hook, hook
extension, and wheel nut wrench
f rom the tool box.
1.
2.
3.
Emergency T owing
The only way you can saf ely tow
your vehicle is with f lat-bed
equipment.
If Your Vehicle Gets Stuck
Emergency Towing, If Your Vehicle Gets Stuck
228
\f—\f—y

y
(\fy\fy
2008 S2000

Screw the towing hook into the
extension, and tighten it securely
using the wheel nut wrench.
4.
If Your Vehicle Gets Stuck
T aking Care of t he Unexpect ed
229
TIRE WHEEL WRENCH
To avoid damage to your vehicle, use
the towing hook f or straight, f lat
ground towing only. Do not tow at an
angle. The tow hook should not be used
to tow the vehicle onto a f lat bed. Do
not use it as a tie down.
\f—\f—y
y
(\fy\fy
2008 S2000

230
\f—\f—y
y
(\fy\fy
2008 S2000

µ
Thediagramsinthissectiongive
you the dimensions and capacities of
your vehicle and the locations of the
identif ication numbers. It also
includes inf ormation you should
know about your vehicle’s tires and
emissions control systems.
................
Identif ication Numbers .232
................................
Specif ications .234
DOT Tire Quality Grading
......................
(U.S. Vehicles) .236
Unif orm Tire Quality ..................................
Grading .236
.................................
Treadwear .236
......................................
Traction .236
.............................
Temperature .237
.................................
Tire Labeling .238
Tire Pressure Monitoring System
(TPMS) Required Federal ............................
Explanation .240 .......................
Emissions Controls .242
.....................
The Clean Air Act .242
Crankcase Emissions Control
....................................
System .242
Evaporative Emissions Control ....................................
System .242
Onboard Ref ueling Vapor ................................
Recovery .242
...
Exhaust Emissions Controls .243
....................
PGM-FI System .243
Ignition Timing Control
................................
System .243
Three Way Catalytic ...........................
Converter .243
....................
Replacement Parts .243
..
Three Way Catalytic Converter .244
........................
Emissions Testing .245
T echnical Inf ormation
Technical Inf ormation
231
\f—\f—y
y
(\fy\fy
2008 S2000

Your vehicle has several identif ying
numbers located in various places.
The vehicle identif ication number
(VIN) is the 17-digit number your
dealer uses to register your vehicle
f or warranty purposes. It is also
necessary f or licensing and insuring
your vehicle. The easiest place to
find the VIN is on a plate fastened to
the top of the dashboard. You can
seeitbylookingthroughthe
windshield on the driver’s side. It is
also on the certification label
attached to the driver’s doorjamb,
and is stamped on the engine
compartment bulkhead. The VIN is
also provided in bar code on the
certif ication label.
Identif ication Numbers
232
VEHICLE IDENTIFICATION NUMBERCERTIFICATION LABEL
\f—\f—y
y
(\fy\fy
2008 S2000

The transmission number is on a
label underneath the transmission.
The engine number is stamped on
the f ront right corner of the engine
block, below the valve cover.
Identif ication Numbers
Technical Inf ormation
233
TRANSMISSION NUMBERENGINE NUMBER
\f—\f—y

y
(\fy\fy
2008 S2000

ÃŽ
ÃŽ
´
µ
ÃŽ
ÃŽ
Specif ications
234
Dimensions
Engine
WeightsCapacities
Seating Capacities
162.0 in (4,115 mm)
68.9 in (1,750 mm)
50.6 in (1,285 mm)
94.5 in (2,400 mm)
57.9 in (1,470 mm)
59.4 in (1,510 mm)
132 cu-in (2,157 cm
)
11.1 : 1
3.43 x 3.57 in (87.0 x 90.7 mm)
Length
Width
Height
Wheelbase
Track
See the certification label attached
to the driver’s doorjamb.Water cooled 4-stroke DOHC
VTEC 4-cylinder gasoline engine
Type
BorexStroke
Displacement
Compression ratio
Spark plugs
Spark Plug Gap 0.04 in (1.1 mm) PK22PR-L11S
PFR7G-11S
Gross vehicle weight rating
(GVWR)
Excluding the oil remaining in the engine
0.16 US gal (0.6
)
Including the coolant in the reserve tank and that remaining in the
engine
Reserve tank capacity:
Fuel tank
Engine coolant
Engine oil
Manual
transmission
fluid
Differential
fluid
Windshield
washer
reservoir
6.3 US qt (6.0
)
2.6 US qt (2.5)
0.81 US qt (0.77)
0.78 US qt (0.74)
1.7 US qt (1.6
)
1.6 US qt (1.5)
5.9 US qt (5.6)
4.8 US qt (4.5)
5.1 US qt (4.8)
2.01 US gal (7.6
)
1.72 US gal (6.5)
13.2 US gal (50
)
Total
Front
2
2
Front
Rear
1:
2:
NGK :
DENSO : Change
Total
Change
Including filter
Without filter
Total
Change
Total
Change
Total
U.S. Vehicles
Canadian
Vehicles
0mm
0.1 mm
1
2
\f—\f—y
\fy
(\fy\fy
2008 S2000

µ
µ
µµ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
ÃŽ
ÃŽ
ÃŽ
ÃŽ
ÃŽ
ÃŽ
ÃŽ
ÃŽ
ÃŽ
ÃŽ
Specif ications
Technical Inf ormation
235
Battery
Lights
Fuses
Tires
Alignment
Air conditioning 55 W
12 V 12 V 36 AH/5 HR
35 W
12 V Capacity
Headlights
Front turn signal lights
Rear turn signal lights
Front side marker/
parking lights
Back-up lights
License plate light
Interior light
Trunk light
Side turn signal lights 12 V
12 V
12 V
12 V
12 V21 W
5W
5W
5W
5W
12 V
12 V
12 V
21 W
21 W
5 W Under-hood
Interior
0.15 in (3.7 mm)
0.00 in (0.0 mm)
12 V 45 AH/20 HR
60 psi (420 kPa , 4.2 kgf/cm
)
32 psi (220 kPa , 2.2 kgf/cm)
Size
Pressure 32 psi (220 kPa , 2.2 kgf/cm)
T125/70D16 96M 255/40R17 94W
245/40R17 91W
215/45R17 87W
Toe
Camber
Caster 6°
1°30’
0°30’
0.22 in (5.6 mm)
On vehicles with high voltage discharge type headlights,
replacement of a headlight bulb should be performed by your dealer.
Refrigerant type
Charge quantity
Lubricant type SP-10 21.2 22.9 oz (600 650 g)HFC-134a (R-134a) See page227or the fuse box
cover.
See page226or the fuse label
attached to the inside of the fuse
box door under the dashboard.
(H1)
(AMBER)
Front
Rear
Spare Tire
Front
Rear
Spare Tirein
High
Low
Front
Rear
Front
Rear
Frontin
:
1 : Except CR models
2 : CR models
1
1
1
1
2
1
2
\f—\f—y\f\f\fy
(\fy\f\fy
2008 S2000

Quality grades can be f ound where
applicable on the tire sidewall
between tread shoulder and
maximum section width. For
example:
All passenger car tires must conf orm
to Federal Saf ety Requirements in
addition to these grades.The treadwear grade is a compara-
tive rating based on the wear rate of
the tire when tested under controlled
conditions on a specif ied government
test course. For example, a tire
graded 150 would wear one and one-
half (1 1/2) times as well on the
government course as a tire graded
100. The relative perf ormance of
tires depends upon the actual condi-
tions of their use, however, and may
depart signif icantly f rom the norm
due to variations in driving habits,
service practices and dif f erences in
road characteristics and climate.
The traction grades, f rom highest to
lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to
stop on wet pavement as measured
under controlled conditions on
specif ied government test surf aces
of asphalt and concrete. A tire
marked C may have poor traction
perf ormance.
Warning: The traction grade
assignedtothistireisbasedon
straight-ahead braking traction tests,
and does not include acceleration,
cornering, hydroplaning, or peak
traction characteristics.
The tires on your vehicle meet all
U.S. Federal Saf ety Requirements.
All tires are also graded f or
treadwear, traction, and temperature
perf ormance according to
Department of Transportation
(DOT) standards. The f ollowing
explains these gradings.
DOT Tire Quality Grading (U.S. Vehicles)
Unif orm T ire Quality Grading
T readwear 200
Traction AA
Temperature A T readwear T raction
236
\f—\f—y
y
(\fy\f
y
2008 S2000

The temperature grades are A (the
highest), B, and C, representing the
tire’s resistance to the generation of
heat and its ability to dissipate heat
when tested under controlled
conditions on a specif ied indoor
laboratory test wheel. Sustained high
temperature can cause the material
of the tire to degenerate and reduce
tire life, and excessive temperature
can lead to sudden tire f ailure. The
grade C corresponds to a level of
perf ormance which all passenger car
tires must meet under the Federal
Motor Vehicle Saf ety Standard No.
109. Grades B and A represent
higher levels of perf ormance on the
laboratory test wheel than the
minimum required by law.Warning: The temperature grade f or
this tire is established f or a tire that
is properly inf lated and not
overloaded. Excessive speed,
underinf lation, or excessive loading,
either separately or in combination,
can cause heat buildup and possible
tire f ailure.
DOT Tire Quality Grading (U.S. Vehicles)
Temperature
Technical Inf ormation
237
\f—\f—y
y
(\fy\fy
2008 S2000