lock Hyundai Creta 2016 Owner's Manual

7-28
Maintenance
EXPlANATION OF SChEdulEd MAINTENANCE ITEMS
Engine oil and filter
The engine oil and filter should be
changed at the intervals specified in
the maintenance schedule. If the car
is being driven in severe conditions,
more frequent oil and filter changes
are required.
Drive belts
Inspect all drive belts for evidence of
cuts, cracks, excessive wear or oil
saturation and replace if necessary.
Drive belts should be checked peri
odically for proper tension and
adjusted as necessary.
When you are inspecting the belt,
place the ignition switch in the
LOCK/OFF or ACC position.
Fuel filter
A clogged filter can limit the speed at
which the vehicle may be driven,
damage the emission system and
cause multiple issues such as hard
starting. If an excessive amount of
foreign matter accumulates in the
fuel tank, the filter may require
replacement more frequently.
After installing a new filter, run the
engine for several minutes, and
check for leaks at the connections.
We recommend that the fuel filter be
replaced by an authoized HYUNDAI
dealer.
Fuel lines, fuel hoses and con
nections
Check the fuel lines, fuel hoses and
connections for leakage and dam
age. We recommend that the fuel
lines, fuel hoses and connections be
replaced by an authoized HYUNDAI
dealer.
NOTICE
Diesel Engine
Never work on injection system
with engine running or within 30
seconds after shutting off engine.
High pressure pump, rail, injectors
and high pressure pipes are sub
ject to high pressure even after
the engine stopped. The fuel jet
produced by fuel leaks may cause
serious injury, if it touch the body.
People using pacemakers should
not move than 30cm closer to the
ECU or wiring harness within the
engine room while engine is run
ning, since the high currents in the
Common Rail system produce
considerable magnetic fields.
WARNING

7-34
Maintenance
ENGINE COOlANT
The highpressure cooling system
has a reservoir filled with yearround
antifreeze coolant. The reservoir is
filled at the factory.
Check the antifreeze protection and
coolant level at least once a year, at
the beginning of the winter season,
and before traveling to a colder cli
mate.
•Do not drive with no engine
coolant. It may cause water pump
failure and engine seizure, etc.
•When the engine overheats from
low engine coolant, suddenly
adding engine coolant may cause
cracks in the engine. To prevent
damage, add engine coolant slow
ly in small quantities.
Checking the coolant level
NOTICE
Removing radiator cap
•Never attempt to
remove the radiator cap while
the engine is operating or hot.
Doing so might lead to cooling
system and engine damage and
could result in serious personal
injury from escaping hot coolant
or steam.
(Continued)
WARNING
(Continued)
•Turn the engine off and wait until
it cools down. Use extreme care
when removing the radiator cap.
Wrap a thick towel around it,
and turn it counterclockwise
slowly to the first stop. Step
back while the pressure is
released from the cooling sys
tem. When you are sure all the
pressure has been released,
press down on the cap, using a
thick towel, and continue turning
counterclockwise to remove it.
•Even if the engine is not operat
ing, do not remove the radiator
cap or the drain plug while the
engine and radiator are hot. Hot
coolant and steam may still blow
out under pressure, causing
serious injury.
OGS0750004

7-41
7
Maintenance
AIR ClEANER
Filter replacement
You can clean the filter when inspect
ing the air cleaner element.
Clean the filter by using compressed
air.
1. Loosen the air cleaner cover attaching clips and open the cover. 2. Wipe the inside of the air cleaner.
3. Replace the air cleaner filter.
4. Lock the cover with the cover
attaching clips. Replace the filter according to the
Maintenance Schedule.
If the vehicle is operated in extreme
ly dusty or sandy areas, replace the element more often than the usualrecommended intervals. (Refer to“Maintenance under severe usageconditions” in this chapter.)
•Do not drive with the air cleaner
removed; this will result in exces
sive engine wear.
•When removing the air cleaner fil
ter, be careful that dust or dirt does
not enter the air intake, or damage
may result.
•We recommend that you use parts
for replacement from an authorized
HYUNDAI dealer.
NOTICE
OGS075010
OGS075011

7-43
7
Maintenance
3. Remove the climate control air fil
ter cover while pressing the lock
(1) on the both side of the cover. 4. Replace the climate control air filter.
5. Reassemble in the reverse order
of disassembly.
Information
When replacing the climate control
air filter install it properly. Otherwise,
the system may produce noise and the
effectiveness of the filter may be
reduced.i
OCF073014OGS075014

7-45
7
Maintenance
Front windshield wiper blade
1. Raise the wiper arm and turn thewiper blade assembly to expose
the plastic locking clip.
Do not allow the wiper arm to fall
against the windshield, since it may
chip or crack the windshield. 2. Compress the clip and slide the
blade assembly downward.
3. Lift it off the arm.
4. Install the blade assembly in the reverse order of removal.
Rear window wiper blade
1.Raise the wiper arm and rotate thewiper blade assembly (1).
2.Pull out the wiper blade assembly.
NOTICE
OLMB073020
OLMB073021
OLMB073022
OLMB073023

7-50
Maintenance
Reset items
Items should be reset after the bat
tery has been discharged or the bat
tery has been disconnected.
• Auto up/down window (See chapter 3)
• Climate control system (See chapter 3)
• Audio (See chapter 3)
• Clock (See chapter3)
• Trip computer (See chapter 3)
When recharging the battery,
observe the following precautions:
•Before performing maintenance or
recharging the battery, turn off all
accessories and stop the engine.
•Do not allow cigarettes, sparks, or
flame near the battery.
•Wear eye protection when
checking the battery during
charging.
•The battery must be removed
from the vehicle and placed in
an area with good ventilation.
•Watch the battery during charg
ing, and stop or reduce the
charging rate if the battery cells
begin gassing (boiling) violently
or if the temperature of the elec
trolyte of any cell exceeds 49°C
(120°F).
(Continued)
WARNING (Continued)
•The negative battery cable must
be removed first and installed
last when the battery is discon
nected.
•Disconnect the battery charger in
the following order.
1. Turn off the battery charger
main switch.
2. Unhook the negative clamp
from the negative battery ter
minal.
3. Unhook the positive clamp
from the positive battery ter
minal.

7-56
Maintenance
Wheel replacement
When replacing the metal wheels for
any reason, make sure the new
wheels are equivalent to the original
factory units in diameter, rim width
and offset.
Replacing tires
To reduce the chance or serious
or fatal injuries from an accident
caused by tire failure or loss of
vehicle control:
•Replace tires that are worn,
show uneven wear, or are dam
aged. Worn tires can cause loss
of braking effectiveness, steer
ing control, and traction.
•Do not drive your vehicle with
too little or too much pressure in
your tires. This can lead to
uneven wear and tire failure.
•When replacing tires, never mix
radial and biasply tires on the
same car. You must replace all
tires (including the spare) if mov
ing from radial to biasply tires.
(Continued)
(Continued)
WARNING •Using tires and wheel other than
the recommended sizes could
cause unusual handling charac
teristics and poor vehicle con
trol, resulting in a serious acci
dent.
•Wheels that do not meet
HYUNDAI's specifications may
fit poorly and result in damage to
the vehicle or unusual handling
and poor vehicle control.
•The ABS works by comparing
the speed of the wheels. Tire
size can affect wheel speed.
When replacing tires, all 4 tires
must use the same size original
ly supplied with the vehicle.
Using tires of a different size can
cause the ABS (Antilock Brake
System) and ESC (Electronic
Stability Control) to work irregu
larly. (if equipped)
A wheel that is not the correct size
may adversely affect wheel and
bearing life, braking and stopping
abilities, handling characteristics,
ground clearance, bodytotire
clearance, snow chain clearance,
speedometer and odometer cali
bration, headlight aim and bumper
height.
WARNING

7-65
7
Maintenance
3. Pull the suspected fuse straight
out. Use the fuse puller provided in
the engine compar tment fusepanel.
4. Check the removed fuse; replace it if it is blown.
5. Push in a new fuse of the same rating, and make sure it fits tightly
in the clips.
If it fits loosely, we recommend that
you consult an authorized HYUNDAI
dealer.
If you do not have a spare, use a fuse of the same rating from a circuityou may not need for operating thevehicle, such as the cigarette lighterfuse.
If the electrical components do not
work and the fuses are OK, check
the fuse panel in the engine com
partment. If a fuse is blown, it must
be replaced. Fuse switch
Always, put the fuse switch at the ON position.
If you move the switch to the OFF
position, some items such as audio
and digital clock must be reset and
transmitter (or smart key and burglar
alarm) may not work properly.
Always place the fuse switch in the
ON position while driving the vehicle.
NOTICE
OGS075064
OGS075018

7-69
7
Maintenance
Inner Compartment Fuse Panel
ITEMNameSymbolFuse RatingCircuit Protected
FUSE
RR HTD30ARear Defogger Relay, Rear Defogger
TURN15ABody Control Module
SPARE20A
DOOR LOCK20ADoor Lock/Unlock Relay, Door Actuator, Tail Gate Unlock Relay, Tail Gate Latch
PDM115ASmart Key Control Module
WASHER15AMulti Function Switch
A/CON10AAir Condition Module(Manual, Auto), Cluster Ionizer, Blower Relay
MODULE 502'8/(
10AElectronic chromic mirror, Head lamp leveling Switch, Head Lamp LH/RH
MODULE 402'8/(
10ASmart key Control Module, Body Control Module
SPARE20A
SPARE20A
PDM 22210ASmart Key Control Module
* G4FC : Gamma 1.6 (Gasoline), D4FC : UII 1.4 (Diesel), D4FB : UII 1.6 (Diesel)

7-70
Maintenance
ITEMNameSymbolFuse RatingCircuit Protected
FUSE
BRAKE
SWITCH10AStop Lamp Switch, Smart Key Control Module
HTD IND10AA/C Control Module (Manual, Auto), G4FC : ECU(MT), PCU(AT)
BLOWER110AAC Control Module (Auto)
REAR WIPER10ARear Wiper Motor, Rear Wiper Relay
SPARE10A
SPARE15A
MEMORY10ADigital Clock, Body Control Module, AC Control Module (Auto, Manual), Cluster,
Outside Mirror Folding , OBD
MULTIMEDIA20AAudio
SPARE10A
C_LIGHTER20ACigar lighter (Export only)
INTERIOR LP 10ARoom Lamp, MAP Lamp, Luggage Lamp
BLOWER SIGNAL210AAC Control Module (Manual)
SPARE20A
* G4FC : Gamma 1.6 (Gasoline), D4FC : UII 1.4 (Diesel), D4FB : UII 1.6 (Diesel)