light Hyundai Creta 2016 Owner's Manual
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2016, Model line: Creta, Model: Hyundai Creta 2016Pages: 512, PDF Size: 11.54 MB
Page 403 of 512

7-9
7
Maintenance
At least monthly:
• Check the coolant level in theengine coolant reservoir.
• Check the operation of all exterior lights, including the stoplights, turn
signals and hazard warning flash
ers.
• Check the inflation pressures of all tires including the spare.
At least twice a year
(i.e., every Spring and Fall):
• Check the radiator, heater and airconditioning hoses for leaks or
damage.
• Check the windshield washer spray and wiper operation. Clean
wiper blades with clean cloth
dampened with washer fluid.
• Check the headlight alignment.
• Check the muffler, exhaust pipes, shields and clamps.
• Check the lap/shoulder belts for wear and function.
• Check for worn tires and loose wheel lug nuts.
At least once a year:
• Clean the body and door drainholes.
• Lubricate the door hinges and checks, and hood hinges.
• Lubricate the door and hood locks and latches.
• Lubricate the door rubber weather strips.
• Check the air conditioning system.
• Inspect and lubricate automatic transaxle linkage and controls.
• Clean the battery and terminals.
• Check the brake/clutch fluid level.
Page 434 of 512

7-40
Maintenance
FuEl FIlTER (FOR dIESEl)
Draining water from fuel filter
The fuel filter for diesel engine plays
an important role of separating water
from fuel and accumulating the water
in its bottom.
If water accumulates in the fuel filter,
the warning light comes on when the
ignition switch is in the ON position.If this warning light turned
on, we recommend that the
system be serviced by an
authorized HYUNDAI dealer.
If the water accumulated in the fuel
filter is not drained at proper times,
damages to the major parts such as
the fuel system can be caused by
water permeation in the fuel filter.
Extracting air from the fuel filter
If you drive until you have no fuel left
or if you replace the fuel filter, be
sure to extract air from the fuel sys
tem as it makes it difficult to start the
engine.
1. Pump up and down(1) approxi mately 50 times until the pump is
hard.
2. Extract air from the fuel filter by removing the bolt(2) with a cross
tip screw driver and reinstall thebolt(2).
3. Pump up and down(1) approxi mately 15 times. 4. Extract air from the fuel filter by
removing the bolt(2) with a cross
tip screw driver and reinstall thebolt(2).
5. Pump up and down(1) approxi mately 5 times.
Information
• Use cloths when you extract air so that the fuel is not sprayed around.
• Clean the fuel around the fuel filter or the injection pump before start
ing the engine to prevent fire.
• Finally, check each part if the fuel is leaking.i
NOTICE
OGS075009
Page 440 of 512

7-46
Maintenance
3.Install the new blade assembly by
inserting the center part into the
slot in the wiper arm until it clicks
into place.
4.Make sure the blade assembly is installed firmly by trying to pull it
slightly.
To prevent damage to the wiper arms
or other components, we recom
mend that the wiper blade be
replaced by an authorized HYUNDAI
dealer.
OLMB073024