maintenance Hyundai Equus 2016 Manual Online

7-71
Maintenance07
8. Pull out the bumper.
9. Remove 4 fasteners on the grilleand the bolt. 10. Remove the front bumper.
11. Be careful not to damage the
clips inside of the front bumper.
12. When replacing the headlamp on the right side, remove the bolts
and the air cleaner.
OVI075181N
OVI075182N
OVI075185N
OVI075183N
OVI075184N

7-72
Maintenance
13. Remove the mounting bolts.
14. Pull the headlamp assembly out from the vehicle.
15. Remove the clips.
16. Disconnect the power connec- tor(s) from the back of the head-
lamp assembly.
Headlight (HID type) bulbreplacement (if equipped)
When the headlamp does not oper-
ate, have the vehicle checked by an
authorized EQUUS dealer.
Your High Intensity Discharge
(HID) headlamp, equipped with
your vehicle, contains mercury.
When scrapping your vehicle, the
HID Headlamp should be properly
disposed of in advance. The
removed HID headlamp should be
recycled, re-used or disposed as
hazardous waste.
NOTICE
OVI075186N
OVI075187N
OVI079110L
- HID Headlamp low beam
(if equipped)
Do not attempt to replace or
inspect the low beam (XENON
bulb) to avoid an electric shock
danger. When the low beam
(XENON bulb) does not operate,
have your vehicle checked by
an authorized EQUUS dealer.
WARNING

7-73
Maintenance07
Information
HID lamps have superior perform-
ance in comparison to halogen bulbs.
HID lamps are estimated to last twice
as long as halogen bulbs, or longer, by
the manufacturer, depending on the
usage hours. HID lamps needs to be
replaced at some point within the
vehicle life. Frequent turning the
headlamps ON and OFF shortens the
HID lamps life. HID lamps do not
blow out in the same manner as halo-
gen incandescent lamps. When a
headlamp blows out after a period of
operation, the lamp light gradually
fades away after being turned ON.
Even when the lamp is turned ON by
turning ON the switch, it needs to be
replaced. The HID lamp components
are more complex than the ones of
conventional halogen bulbs. Thus, the
repairing costs are more expensive.
Headlight (bulb type), front turnsignal, position, side markerand fog light bulbs
When a bulb is out, have the vehicle
checked by an authorized EQUUS
dealer.
Headlamp bulb i
OKH073081N.
- Halogen bulbs
Halogen bulbs contain pres-
surized gas. Thus, if broken, it
produced fragments of glass.
bulbs to avoid scratches and
abrasions. If the bulbs are lit,
avoid contact with liquids.
Never touch the glass with bare hands. Any remaining oil
may cause the bulb to over-
heat and explode upon being
lit.
When a bulb is damaged or cracked, immediately replace
it. Then, carefully dispose of it.
Wear eye protection while replacing a bulb. If hot, cool
down the bulb before han-
dling it.
WARNING

7-74
Maintenance
17. Remove the headlamp cover by turning it in a counterclockwise
direction.
18. Disconnect the headlamp bulb socket connector.
19. Loosen the wire, which holds the headlamp, by depressing the end
and pushing it upward.
20. Remove the bulb from the head- lamp assembly.
21. Install a new headlamp, and fas- ten the headlamp wire by align-
ing it with the groove.
22. Connect the headlamp socket connector.
23. Close the headlamp cover by turning it in a clockwise direction.
24. Connect the power connector(s) to the back of the headlamp
assembly.
25. Reinstall the headlamp assembly to the vehicle.
Information
Always readjust the headlamp angle,
after an accident or the headlamp
installment by an authorized EQUUS
dealer. When the headlamp (Low) does
not operate, have the vehicle
checked by an authorized EQUUS
dealer.
Turn signal light - bulb type
When the light bulb does not oper-
ate, have the vehicle checked by an
authorized EQUUS dealer.
Position light, Front fog light
When the light bulb does not oper-
ate, have the vehicle checked by an
authorized EQUUS dealer.
Side repeater light bulb
replacement (if equipped)
If the light bulb is not operating, have
the vehicle checked by an authorized
EQUUS dealer.
NOTICE
i
OVI075111N
OVI075031N

7-75
Maintenance07
Rear combination light bulb
replacement
(1) Stop, tail light and side marker
(2) Rear turn signal light
(3) Back-up light
Rear back-up light
When the light bulb does not oper-
ate, have the vehicle checked by an
authorized EQUUS dealer.
Turn signal, stop and tail light
When the light bulb does not oper-
ate, have the vehicle checked by an
authorized EQUUS dealer.
A skilled technician should check
or repair the rear combination
light. Otherwise, it may damage
related parts of the vehicle.
High mounted stop light
1. Remove the rear seat
5 Seater
1.Disconnect the negative batterycable.
2.Remove the rear seat cushion.
NOTICE
OVI075032NOVI075035N
OVI075120N

7-76
Maintenance
3.Loosen the mounting bolts, and then remove the rear seat back.
Tightening torque : 34.3~53.9 N.m
3.5~5.5 kgf.m,
25.3~39.8 lb-ft
4.Disconnect the connector. 5. Push the hook, and disconnect the
main connector.
6.Loosen the mounting bolts, and then disconnect the connector.
7.Remove the side seat.
OVI075121N
OVI075123N
OVI075127N
OVI075125N

7-77
Maintenance07
4 Seater
1.Disconnect the negative batterycable.
2.Remove the rear seat cushion.
3. Loosen the mounting bolts, and then remove the rear seat back.
Tightening torque
: 34.3~53.9 N.m 3.5~5.5 kgf.m,
25.3~39.8 lb-ft 4. Disconnect the connectors and
hose.
2. Remove the rear package tray trim
1.Remove the rear door scuff trim.
OVI075127N
OVI075128N
OVI075129N
OVI075130N
Left
Right
OVI075131N

7-78
Maintenance
2.Loosen the mounting screw, and then remove the rear wheel house
trim.
3.Remove the cap, and then loosen the mounting screw.
4.Remove the rear pillar trim.
5.Push the hook, and remove the rear seat belt cover. 6.Remove the rear seat belt lower
anchor.
Tightening torque
: 39.2~53.9 N.m 4.0~5.5 kgf.m
28.9~39.8 lb-ft
7. Loosen the mounting screws, and then remove the package tray
trim.
OVI075132N
OVI075134N
OVI075133N
OVI075135N
OVI075136N

7-79
Maintenance07
3. Replace the high mountedstop light
1.Remove the high mounted stop
lamp after removing screws.
2.Install a new light.
4. Installation
Reinstall it in the reverse order.
License plate lamp replace-
ment
1.Open the trunk.
2.Disconnect the negative battery cable.
3. Using a screwdriver, and open the trunk lid latch cover(1).
4. Using a screwdriver, remove the trunk lid switch(2), and disconnect
the connector.
OVI075137NOVI075039N
OVI075150N

7-80
Maintenance
5.Loosen the clip and fastener(3), and then remove the trunk lid
cover(4).
6.Remove the clips and screws.
7.Remove the trunk lid trim. Be careful not to damage the fas-
teners between the trunk lid trim
and trunk lid.
8.Loosen the nuts and disconnect
the connectors.
NOTICE
OVI075151N
OVI075152N
OVI075153N
OVI075154N
OVI075158N