heating Hyundai Getz 2004 Owner's Guide

1- 72 FEATURES OF YOUR HYUNDAI
HTB033A-D
1
23
4 HTB034
B670A01TB-GAT
HEATING AND VENTILATION
1. Temperature control switch
2. Fan speed control switch
3. Air flow control switch
4. Air conditioning switch
5. Air intake control switch
6. Rear window defroster switch B670B01A-AAT
Fan Speed Control
(Blower Control)
This is used to turn the blower fan on
or off and to select the fan speed.
This blower fan speed, and therefore
the volume of air delivered from the
system, may be controlled manually
by setting the blower control between
the "1" and "4" positions.
B710C01Y-AAT
Side Ventilator
The side vent knobs control the amount
of outside air entering the vehicle
through the side vents. These vents
can also be closed, so no air enters
through the side vents. To change the
direction of the air flow, turn the control
knobs as desired.
56
tbuk-1b.p65
3/23/04, 2:24 PM
72

FEATURES OF YOUR HYUNDAI 1- 73
B670C02A-EAT
Air Intake Control
This is used to select fresh outside air
or recirculation inside air. Fresh
Recirculation
With the " " mode selected, air
enters the vehicle from outside and is
heated or cooled according to the other
functions selected.
With the " " mode selected, air from
within the passenger compartment is
drawn through the heating system and
heated or cooled according to the other
functions selected. HTB036-D
NOTE:
It should be noted that prolonged
operation of the heating system in
" " mode will give rise to misting
of the windscreen and side windows
and the air within the passenger com-
partment will become stale. In addi-
tion prolonged use of the air condi-
tioning with the " " mode selected
may result in the air within the pas-
senger compartment becoming ex-
cessively dry.B670D01TB-EAT
Air Flow Control
This is used to direct the flow of air. Air
can be directed to the floor, dashboard
outlets, or windscreen. Five symbols
are used to represent Face, Bi-Level,
Floor, Floor-Defrost and Defrost air po-
sition. HTB038
tbuk-1b.p65
3/23/04, 2:24 PM
73

FEATURES OF YOUR HYUNDAI 1- 75
B670E01A-AAT
Temperature Control
Cool Warm
Floor-Defrost Level
Air is discharged through the windscreen
defrost nozzle, the floor vents, side
defroster nozzle, side ventilator. Defrost-Level
Air is discharged through the windscreen
defrost nozzle, side defroster nozzle,
side ventilator.
HTB043-D HTB044-D
This is used to turn the heating system
on and off and to select the degree of
heating desired. HTB035
tbuk-1b.p65
3/23/04, 2:24 PM
75

1- 76 FEATURES OF YOUR HYUNDAI
B670B01A-AAT
BI-LEVEL HEATING
Your Hyundai is equipped with bi-level
heating controls. This makes it pos-
sible to have cooler air from the dash-
board vents and warmer air from the
floor outlets at the same time. To use
this feature:
o Set the air intake control to the fresh
air ( ) position.
o Set the air flow control at the bi-level ( ) position.
o Set the temperature control between "Cool" and "Warm".
B690A01A-AAT
HEATING CONTROLS
For normal heating operation, set the
air intake control to the fresh air ( )
position and the air flow control to the
floor ( ) position.
For faster heating, the air intake con-
trol should be set in the recirculate
( ) position.
If the windows fog up, set the air flow
control to the defrost ( ) position and
the air intake control to the fresh air
( ) position.
For maximum heat, move the tem-
perature control to "Warm". B720A01TB-EAT
DEFROSTING/DEFOGGING
HTB045-D
Use the heating/ventilation system to
defrost or defog the windscreen:
To remove interior fog on the
windscreen:
o Set the air intake control to the fresh air ( ) position.
o Set the air flow control to the defrost
( ) position.
o For more rapid action, turn on the air conditioning.
o Set the temperature control to the
desired position.
o Set the fan speed control between
"1" and "4" position.
tbuk-1b.p65 3/23/04, 2:24 PM
76

FEATURES OF YOUR HYUNDAI 1- 77
B740A01A-AAT
AIR CONDITIONING SWITCH
(Not all models)
B730A01FC-EAT
Operation Tips
o To keep dust or unpleasant fumes
from entering the car through the
ventilation system, temporarily set
the air intake control at "Recircula-
tion". Be sure to return the control to
"Fresh" when the irritation has
passed to keep fresh air in the ve-
hicle. This will help keep the driver
alert and comfortable.
o Air for the heating/cooling system is
drawn in through the grilles just
ahead of the windscreen. Care should
be taken that these are not blocked
by leaves, snow, ice or other ob-
structions.
o To prevent interior fog on the
windscreen, set the air intake control
to the fresh air ( ) position and
fan speed to the desired position.
To remove the frost or exterior
fog on the windscreen:
o Set the air intake control to the fresh
( ) position.
o Set the air flow control to the defrost ( ) position
o Set the temperature control to warm.
o Set the fan speed control to position
"3" or "4".
NOTE:
When the A/C is operated continu-
ously on the floor-defrost level ( )
or defrost level ( ), it may cause
fog to form on the exterior
windscreen. If this occurs, set the air
flow control to the face level posi-
tion ( ) and fan speed control to
the low position. The air conditioning is turned on by
pushing the A/C button on the heating/
air conditioning control panel.
HTB037-D
tbuk-1b.p65
3/23/04, 2:24 PM
77

1- 78 FEATURES OF YOUR HYUNDAI
B740B02A-AAT
AIR CONDITIONING OPERA-
TION (Cooling)
B740C01A-AAT
De-Humidified Heating
To use the air conditioning to cool the
interior:
o Turn on the fan control switch (2).
o Turn on the air conditioning switch(4) by pushing in on the switch.
The air conditioning indicator light
should come on at the same time.
o Set the air intake control to the
position (5).
o Set the temperature control (1) to "Cool". ("Cool" provides maximum
cooling. The temperature may be
moderated by moving the control
toward "Warm".) HTB046-D
o Adjust the fan control (2) to the
desired speed. For greater cooling,
turn the fan control to one of the
higher speeds or temporarily select
the position on the air intake
control. For dehumidified heating:
o Turn on the fan control switch (2).
o Turn on the air conditioning switch
(4). The air conditioning indicator
light should come on at the same
time.
o Set the air intake control (5) to the fresh air ( ) position.
o Set the air flow control (3) to the face ( ) position.
o Adjust the fan control (2) to the
desired speed.
o For more rapid action, set the fan at one of the higher speeds.
o Adjust the temperature control (1)
to provide the desired amount of
warmth.
(1)
(2)
(3)
(4) (5)
HTB046-D
(1)
(2)
(3)
(4) (5)
tbuk-1b.p65 3/23/04, 2:24 PM
78

FEATURES OF YOUR HYUNDAI 1- 79
!
B760A01Y
The pollen filter is located in front of the
evaporator unit behind the glove box.
It operates to decrease the amount of
pollutants entering the car.
To replace the pollen filter, refer to the
page 6-20.
B760A02TB-EAT
POLLEN FILTER (In Front of
evaporator unit) (Not all models)
B740D01A-AAT
Operation Tips
o If the interior of the car is hot when
you first get in, open the windows for
a few minutes to expel the hot air.
o When you are using the air condi-
tioning system, keep all windows
closed to keep hot air out.
o When moving slowly, as in heavy
traffic, shift to a lower gear. This
increases engine speed, which in
turn increases the speed of the air
conditioning compressor.
o On steep grades, turn the air condi- tioning off to avoid the possibility of
the engine over-heating.
o During winter months or in periods when the air conditioning is not used
regularly, run the air conditioning
once every month for a few min-
utes. This will help circulate the
lubricants and keep your system in
peak operating condition. Inside of
a vehicle
Evaporator core
Filter
BlowerOutside air
Inside air CAUTION:
o Replace the filter every 12,000 miles (20,000 km) or once a year. If
the car is being driven in severe
conditions such as dusty, rough
roads, more frequent pollen filter
inspections and changes are re-
quired.
o When the air flow rate is suddenly decreased, it must be checked at
an authorized dealer.
tbuk-1b.p65 3/23/04, 2:24 PM
79

2- 2 DRIVING YOUR HYUNDAI
!
SC020A1-E
WARNING: ENGINE EXHAUST CAN BE DANGEROUS!
Engine exhaust gases are potentially lethal. If at any time engine exhaust gas is detected within the passenger compartment, move the vehicle to an open area and open all windows. o Never inhale exhaust gas. Exhaust gases contain Carbon Monoxide which is colourless and odourless. Carbon Monoxide is poisonous and can cause unconsciousness and death by asphyxiation. o Exhaust System Maintenance. Ensure that the exhaust system is maintained in good condition and is free from excessive corrosion and damage which may result in leakage. If the vehicle is driven over an object which strikes the exhaust system,ensure that the exhaust system is inspected at the first available opportunity to ensure that no leakage exists. o Confined Areas. Do not run the engine in confined spaces, allowing the engine to idle in a garage, even when the doors are open is dangerous practice. Only start the engine immediately prior to moving the vehicle out of the garage. o Prolonged Idling. If it is necessary to allow the vehicle to idle for prolonged periods, ensure that the heating system air intake control is set to the "Fresh" position, the blower is set to high speed operation and that the vehicle is standing in an open area. o Load Carrying. If it is necessary to carry long objects which do not permit the boot lid to be fully closed, the side windows must remain closed and the heating air intake control set to the "Fresh" position with the blower running at the highest speed setting. To ensure correct operation of the heater system, the air intake grilles at the base of the windscreen must not be obstructed by snow leaves etc..
tbuk-2.p65 3/23/04, 4:55 PM
2

2- 6 DRIVING YOUR HYUNDAI
C050B01HP
NOTE: If the engine were not started 10 seconds after the preheating is com- pleted, turn the ignition key oncemore to the "LOCK" position, andthen to the "ON" position, in orderto preheat again.
C051A01O-EAT STARTING THE DIESEL ENGINE ENGINE COLD
o Turn the ignition key to position
"ON" and wait for the pre-heat indi-cator light to go out.
o Operate the starter until the engine runs.
ENGINE WARMOperate the starter. If the engine doesnot respond on the first attempt, waitseveral seconds and try again using the pre-heat. C050B02S-GAT NORMAL CONDITIONS The Starting Procedure:
1. Insert key, and fasten the seat belt.
2. Depress the clutch pedal fully and
place the gearshift lever (manualtransaxle) in neutral or the selector lever (automatic transaxle) in "P" (park) position.
3. After turning the ignition key to the
"ON" position, make certain all warn-ing lights and gauges are function-ing properly before starting the en- gine.
4. On vehicles equipped with the die-
sel preheat indicator light, turn the ignition key to the "ON" position.The diesel pre-heat indicator lightwill first illuminate in amber, and then after a short time, the amber illumination will go off, indicatingthat preheating is completed.
tbuk-2.p65 3/23/04, 4:55 PM
6

2- 8 DRIVING YOUR HYUNDAI
HTB206 CAUTION:
o Do not attempt to engage reverse gear when the car is in motion.
o To avoid damaging the selector mechanism, do not use the gear shift lever as a hand rest. Releasethe lever immediately the shift iscompleted.
o To avoid premature clutch wear,
do not use the clutch pedal as afoot rest, and do not hold thevehicle on a gradient using theclutch.
o Ensure that the engine is not over-revved by upshifting beforethe tachometer needle enters thered zone.
o Do not coast with the shift lever at the neutral position.
o When descending long gradi- ents, make use of the engine brak-ing to assist the footbrake toavoid brake fade or over-heating.
o When slippery conditions are en- countered, increased cautionshould be exercised when gear changing, braking or accelerat-
SC090A03-EMANUAL TRANSAXLE The five speed fully synchronized transaxle is controlled by a floor mounted shift lever upon which theshift pattern is indicated. It is importantthat when changing gear, the clutchpedal is fully depressed to avoidtransaxle damage. ing. Abrupt changes in speedmay cause a loss of traction orcontrol of the vehicle.
o During cold weather, shifting may be difficult until the transaxle lu-bricant has warmed up. This isnormal and not harmful to thetransaxle.
o If you 've come to a complete
stop and it's hard to shift into 1st or R(Reverse), put the shift lever in N(Neutral) position and releasethe clutch. Press the clutch pedalback down, and then shift into1st or R(Reverse) gear position.
o Do not use the shift lever as a handrest during driving, as thiscan result in premature wear ofthe transaxle shift forks.
o Always ensure that the periodic
maintenance services are performedby a Hyundai dealer at the time and/or mileage intervals specified.
o Use the air conditioning only when necessary.
!
tbuk-2.p65 3/23/04, 4:55 PM
8