rail Hyundai Getz 2008 Owner's Guide

5- 6 VEHICLE MAINTENANCE REQUIREMENTS
MAINTENANCE UNDER SEVERE USAGE CONDITIONS
The following items must be serviced more frequently on cars normally used under severe driving conditions. Refer to the chart below for the appropriate maintenance intervals. R : REPLACE I : INSPECT AND, AFTER INSPECTION, CLEAN, ADJUST, REPAIRER OR REPLACE IF NECESSARY
F040A02TB-EAT
ENGINE OIL AND FILTER AIR CLEANER FILTERSPARK PLUGSTIMING BELTBRAKE PADSREAR BRAKE LININGS AND CYLINDERSSUSPENSION AND STEERING SYSTEM MANUAL TRANSAXLE OIL AUTOMATIC TRANSAXLE FLUIDPOLLEN FILTER(FOR EVAPORATOR AND BLOWER UNIT) EVERY 6,000 MILESMORE FREQUENTLY
MORE FREQUENTLY EVERY 37,000 MILES OR 48 MONTHSMORE FREQUENTLYMORE FREQUENTLY MORE FREQUENTLY EVERY 60,000 MILESEVERY 27,000 MILES
MORE FREQUENTLY
MAINTENANCE OPERATIONMAINTENANCE ITEM
R RR RI II
RR R A, B, C, D, E, F, G, H, I, K C, EB, I D, E, F, G, I C, D, G, HC, D, G, HC, D, E, F C, D, E, G, H, I, J E, F, G, H, I C,E
MAINTENANCE INTERVALS
DRIVING
CONDITION
SEVERE DRIVING CONDITIONS
A - Repeatly driving short distance of less than 5miles(8km) in normal temperature or less than 10miles(16km) in freezing temperature
B - Extensive engine idling or low speed driving for long distances
C - Driving on rough, dusty, muddy, unpaved, graveled or salt- spread roads
D - Driving in areas using salt or other corrosive materials or in very cold weather E - Driving in sandy areas
F - Driving in heavy traffic area over 90°F(32°C) G - Driving on uphill, downhill, or mountain roadH - Towing a Trailer, or using a camper, or roof rack
I - Driving as a patrol car, taxi, other commercial use or vehicle towing
J - Driving over 100 MPH(170 Km/h)K - Frequently driving in stop-and-go conditions

VEHICLE MAINTENANCE REQUIREMENTS 5- 7
!
6ZF060A1-A
EXPLANATION OF SCHEDULED MAINTENANCE ITEMS
F060M01A-AAT
o Engine oil and filter
The engine oil and filter should be changed at the intervals specified inthe maintenance schedule. If the car is being driven in severe conditions, more frequent oil and filter changesare required. F060B01A-AAT
o Drive belts
Inspect all drive belts for evidence of cuts, cracks, excessive wear or oilsaturation and replace if necessary. Drive belts should be checked peri- odically for proper tension and ad-justed as necessary. F060C01A-GAT
o Fuel filter
A clogged filter can limit the speed at
which the vehicle may be driven, dam- age the emission system and cause hard starting. If an excessive amountof foreign matter accumulates in the fuel tank, the filter may require re- placement more frequently.
After installing a new filter, run the
engine for several minutes, and checkfor leaks at the connections.
F060D01TB-EAT
o Fuel lines, fuel hoses and con- nections
Check the fuel lines, fuel hoses and
connections for leakage and damage. Replace any damaged or leaking parts immediately. WARNING (Diesel only):
Never work on injection systemwith engine running or within 30 seconds after shutting off engine.High pressure pump, rail, injectors and high pressure pipes are sub- jected to high pressure even afterthe engine has been switched off. The fuel jet produced by fuel leaks may cause serious injury, if it con-tacts with the body. People using pacemakers should not move closer than 30cm to the ECU orwiring harness within the engine room with the engine running, since the high currents in the CommonRail system produce considerable magnetic fields.

6- 16 DO-IT-YOURSELF MAINTENANCE
fuel leaks may cause serious injury, if it touch the body. People using pacemakers should not move than30cm closer to the ECU or wiring harness within the engine room while engine is running, since the highcurrents in the Common Rail system produce considerable magnetic fields.
!
CAUTION:
The automatic transaxle unit is a precision engineered assembly andcorrect operation is dependant upon the exclusion of dirt and lint from the unit. Therefore, it is imperative thatonly lint free cloth (eg nylon) is used for wiping the dipstick and that the area around the dipstick is thor-oughly clean prior to level checking or adding fluid. Fluid Capacity The total fluid capacity of the transaxle unit is 6.1 litres.
!
!
C090A03FC
Fluid level should be within "HOT" range
3. Confirm that the fluid level is in “HOT” range on the level gauge. If the fluid level is lower, add the specified fluid from the fill hole. If the fluid level is higher, drain the fluid from the drainhole.
4. If the fluid level is checked in cold
condition (fluid temperature 20~30°C(68~86°F)) add the fluid to “COLD” line and then recheck the fluid level according to the above step 2. WARNING:
The cooling fan is controlled by en-gine coolant temperature and maysometimes operate even when the engine is not running. Use extreme caution when working near theblades of the cooling fan so that you are not injured by a rotating fan blade. As the engine coolant tem-perature decreases, the fan will auto- matically shut off. This is a normal condition.
WARNING (DIESEL
ONLY): Never work on injection system with engine running or within 30 seconds after shutting off engine. High pres- sure pump, rail, injectors and highpressure pipes are subject to high pressure even after the engine stopped. The fuel jet produced by

INDEX 10- 5
SEAT BELT PRECAUTIONS ......................................1-20
SEAT BELTS ............................................................. 1-22
SEAT POCKET .......................................................... 1-79
SEAT WARMER ......................................................... 1-19
SERVICE HISTORY .................................................... 5-2
SMOOTH CORNERING .............................................. 2-17
SNOW TYRES ............................................................. 8-4
SPARE TYRE .............................................................. 3-5
SPARE TYRE AND TOOLS ........................................ 8-6 SPARE WHEEL ........................................................... 3-6
SPECTACLE CASE .................................................... 1-71
SPEEDOMETER ........................................................ 1-53
SUPPLEMENTAL RESTRAINT (AIRBAG) SYSTEM ................................................................ 1-34
STARTING THE ENGINE ............................................ 2-5
STEERING WHEEL LOCK .......................................... 2-4STEERING WHEEL TILT LEVER ............................... 1-83
STEREO SOUND SYSTEM ....................................... 1-94
SUN-VISOR ................................................................ 1-82
SUNROOF .................................................................. 1-67
TTACHOMETER ........................................................... 1-54
TOWING ATTACHMENTS .......................................... 2-19
TRAILER AND CARAVAN TOWING ........................... 2-19TRIP ODOMETER
...................................................... 1-54
TRIP COMPUTER ...................................................... 1-55
TYPE PRESSURES .................................................... 8-3
TYRE BALANCING ...................................................... 8-5
TYRE CHAINS ............................................................. 8-4
TYRE REPLACEMENT ............................................... 8-5
TYRE ROTATION ........................................................ 8-4
UUNDERBODY COATINGS ........................................... 4-2
V VALETING ................................................................... 4-3
VEHICLE IDENTIFICATION NUMBER ........................ 8-2
VEHICLE SPECIFICATION ............ ............................. 9-2
VEHICLE TOWING OR RECOVERY .......................... 3-11
VENTILATION ............................................................ 1-85
W WHEEL REPLACEMENT ............................................ 8-6
WINDSCREEN WASHER RESERVOIR REPLENISHMENT ................................................. 6-13
WINDSCREEN WIPER BLADES ................................ 6-12
WINDSHIELD WIPER/WASHER SWITCH ..................1-59
WINTER MOTORING ................................................. 2-17