oil Hyundai H350 2016 Owner's Manual
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2016, Model line: H350, Model: Hyundai H350 2016Pages: 473, PDF Size: 26.4 MB
Page 6 of 473
NOTICE indicates a situation
which, if not avoided, could result
in vehicle damage.
Diesel engine
Diesel fuel
Diesel engine must be operated only
on commercially available diesel fuelthat complies with EN 590 or compa-
rable standard. (EN stands for
"European Norm"). Do not use
marine diesel fuel, heating oils, or
non-approved fuel additives, as this
will increase wear and cause dam-age to the engine and fuel system.
The use of non-approved fuels and /
or fuel additives will result in a limita-
tion of your warranty rights.
Diesel fuel of above cetane 51 is
used in your vehicle. If two types of
diesel fuel are available, use summer
or winter fuel properly according to
the following temperature conditions.
Above -5°C(23°F) ... Summer typediesel fuel.
Below -5°C(23°F) ... Winter type diesel fuel.
Watch the fuel level in the tank very
carefully : If the engine stops through
fuel failure, the circuits must be com-
pletely purged to permit restarting.
NOTICE
F6
Introduction
CAUTION indicates a hazardous
situation which, if not avoided,could result in minor or moder-
ate injury.
CAUTION
•Do not let any gasoline or
water enter the tank. This
would make it necessary to
drain it out and to bleed the
lines to avoid jamming the
injection pump and damaging
the engine.
In winter, in order to cut down incidents due to freezing,
paraffin oil may be added tothe fuel if the temperature
drops to below -10°C (14°F).
Never use more than 20%paraffin oil.
CAUTION
FF UU EELL RR EEQQ UUIIRR EEMM EENN TTSS
Page 7 of 473
Biodiesel
Commercially supplied Diesel blends of no more than 7% biodiesel, com-
monly known as "B7 Diesel" may be
used in your vehicle if Biodiesel
meets EN 14214 or equivalent spec-
ifications. (EN stands for "European
Norm"). The use of biofuels exceed-
ing 7% made from rapeseed methyl
ester (RME), fatty acid methyl ester
(FAME), vegetable oil methyl ester
(VME) etc. or mixing diesel exceed-ing 7% with biodiesel will cause
increased wear or damage to the
engine and fuel system. Repair or
replacement of worn or damagedcomponents due to the use of non
approved fuels will not be covered by
the manufactures warranty.
F7
Introduction
Never use any fuel, whether
diesel, B7 biodiesel or other-
wise, that fails to meet the lat-
est petroleum industry specifi-cation.
Never use any fuel additives or treatments that are not rec-
ommended or approved by the
vehicle manufacturer.
CAUTION
It is recommended to use the regulated automotive diesel
fuel for diesel vehicle equippedwith the DPF system.
If you use diesel fuel including high sulfur (more than 50 ppm
sulfur) and unspecified addi-
tives, it can cause the DPF sys-
tem to be damaged and whitesmoke can be emitted.
CAUTION
Page 19 of 473
1-10
Your vehicle at a glanceE
E NN GGIINN EE CC OO MM PPAA RRTTMM EENN TT
1. Engine coolant reservoir....................7-28
2. Fuse box and positive battery
terminal ......................................7-52/6-4
3. Engine oil dipstick..............................7-22
4. Engine oil filler cap ............................7-23
5. Brake/clutch fluid cap ........................7-27
6. Air cleaner ........................................7-31
7. Negative battery terminal ....................6-4
8. Radiator cap ......................................7-26
9. Windshield washer fluid reservoir......7-29
10. Power steering fluid reservoir ..........7-28
OEU014005
The actual shape may differ from the illustration.
■
■
Bus, Van, Truck (without auxiliary battery)
Page 20 of 473
1-11
Your vehicle at a glance
1
OEU014006
The actual shape may differ from the illustration.
■
■
Van, Truck (with auxiliary battery)
1. Engine coolant reservoir....................7-25
2. Fuse box and positive battery
terminal ......................................7-52/6-4
3. Engine oil dipstick..............................7-22
4. Engine oil filler cap ............................7-23
5. Brake/clutch fluid cap ........................7-27
6. Air cleaner ........................................7-31
7. Negative battery terminal ....................6-4
8. Radiator cap ......................................7-26
9. Windshield washer fluid reservoir......7-29
10. Power steering fluid reservoir ..........7-28
11. Auxiliary battery ..............................7-37
Page 34 of 473
2-14
Safety system of your vehicle
(Continued)
Never fasten the shoulder
portion of the seat belt under
your arm or behind your back.
An improperly positioned
shoulder portion of the seat
belt may cause serious
injuries in a crash. The shoul-
der portion of the seat belt
should be positioned midway
over your shoulder across
your collarbone.
Never fasten a seat belt over
fragile objects. When there is
a sudden stop or impact, the
seat belt may be damaged.
Be careful not to twist seat
belts. A twisted seat belt can-
not properly protect the pas-
senger. In a collision, it may
even cut into you. Make surethe belt webbing is straightand untwisted.
Be careful not to damage the
seat belt webbing or hard-
ware. When the seat belt web-
bing or hardware is damaged,
immediately replace it.
Seat belts are designed to be
fastened upon the bony struc-
ture of the body, and should be
worn low across the front
pelvis, chest or shoulders, as
applicable; wearing the lap por-
tion of the seat belt across the
abdominal area must be avoid-ed. Seat belts should be adjusted
as firmly as possible, consis-
tent with comfort, to provide the
protection for which they aredesigned.
A slack seat belt greatly reduce
the protection afforded to the
passengers. Be careful not to contaminate
the webbing with polishes, oils
and chemicals, and particularly
battery acid.
Carefully clean it with mild soap
and water.(Continued)
WARNING (Continued) The seat belt should be
replaced, when the webbing
becomes frayed, contaminated,
or damaged. It is essential to
replace the entire assembly
after a severe impact even if
damage to the assembly is not
obvious. Seat belts should notbe fastened with straps twisted.
Each belt assembly must be
fastened over only one occu-
pant; it is dangerous to fasten a
seat belt over a child, who sitson an adult's laps.
Page 84 of 473
3-22
After cleaning the step should be
allowed to dry. When dry, a day or
two later perhaps, apply silicons
spray to help lubricate the movement
of the step.
Do not use grease. Avoid use of oil, it
will simply wash away.
If the conditions are particularly bad
daily cleaning may be required.
Failure to clean the step regularly or
to service the steps may result in the
failure of the step in service. This will
not be covered under warranty.
We recommend that mud flaps are
fitted to your vehicle.
Convenient features of your vehicle
RR
EEAA RR DD OO OORR (( IIFF EE QQ UUIIPP PPEEDD ))
If you open a rear door, you could:
endanger other people or road
users
be caught by oncoming traffic.
This is particularly the case if
you open the rear door more
than 90°. There is a risk of an
accident and injury.
Only open the rear doors when traffic conditions permit.
Always make sure that the rear
door is properly locked.
WARNING
The rear lights will be covered if
you open the rear doors to the90° detent position.
The vehicle will then be unsafe as its rear lights will not be vis-
ible for approaching traffic.
Other road users may not real-
ize until too late that it is an
obstruction. This could lead toan accident.
You should ensure that the
vehicle is visible from the rear
in accordance with the relevant
national regulations, by using
the warning triangle for
instance.
WARNING
Make sure that there is suffi-
cient clearance when opening
the rear doors. You could other-
wise damage the vehicle and
objects in close range of the
rear doors.
CAUTION
Page 114 of 473
3-52
Convenient features of your vehicle
Main menuSub menu
Type AType B
Set
DoorAutomatic door lock (Enable on speed)
Automatic door unlock (On Key Out (power off), Drive door unlock)
Light
Head Lamp delay
Welcome Light
Auto Triple Turn
External Lamp Check*
SoundSound Settings (Level1~3, OFF)
Cluster
Shift Indicator (ON/OFF)
Unit Settings (Time-12hour or 24 hour, Temperature unit-°C or °F)
AFC Settings (Auto reset, Manual reset)
Language Settings (English, Deutsch, etc.)
Current Time (00:00)
Alarm (Alarm time, Idle RPM, Break Time-ON/OFF)
Equipment Cycle (Maintenance)Engine Oil (OFF, ON, Distance setting)
Fuel Filter(OFF, ON, Distance setting)
User Menu (OFF, ON, Distance setting)
* It monitors all external lights, except the back-up lights.
Page 119 of 473
3-57
Convenient features of your vehicle
3
AFC setting
It can be automatically or manually
reset to the default. ❇AFC : Average Fuel Consumption
Language setting
A preferred language can be chosen
on the LCD display.
Current time
The time can be adjusted.
Alarm
The alarm, idle-rpm time, break time can be set in.
Equipment cycle(Maintenance)
Engine oil, fuel filter
The maintenance alarm can be
turned ON or OFF. Also, the driving
distance for an oil/filter maintenance
alarm can be set in.
User Menu
The maintenance alarm message
displays on the LCD display, as arbi-
trarily set in.
Warning Messages
In below cases, the warning mes-
sage displays for 10 seconds. Some
messages will be saved in the infor-
mation group after few seconds dis-
playing for future reference.
Page 135 of 473
3-73
Convenient features of your vehicle
3
Auto stop indicator(if equipped)
This indicator will illuminate when the engine enters the Idle Stop mode ofthe ISG (Idle Stop and Go) system.
When the automatic starting occurs, the auto stop indicator on the cluster
will blink for few seconds.
For more details, refer to the ISG (Idle Stop and Go) system in thechapter 5.
Information
When the engine automatically starts
by the ISG system, some warning
lights (ABS/EBD/VDC/VDC OFF)
may turn on for a few seconds.
This happens because of the low bat-
tery voltage. It does not mean the sys-
tem is malfunctioning.
Engine Oil Pressure Warning Light
This warning light illuminates:
Once you set the ignition switch to the ON position.
- It remains on until the engine isstarted.
When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the engine oil level (For more details,
refer to “Engine Oil” in chapter 7) .
If the level is low, add oil as required.
If the warning light remains on
after adding oil or if oil is not avail-
able, we recommend that you
have the vehicle inspected by an
authorized HYUNDAI dealer as
soon as possible.
Malfunction indicator
lamp (MIL)
(check engine light)
This indicator light is part of theEngine Control System which moni-
tors various emission control system
components. If this light illuminates
while driving, it indicates that a
potential problem has been detected
somewhere in the emission controlsystem. This light will also illuminate when
the ignition switch is turned to the
ON position, and will go out in a few
seconds after the engine is started. If
it illuminates while driving, or does
not illuminate when the ignition key is
turned to the ON position, we recom-
mend that the system be checked by
an authorized HYUNDAI dealer.
Generally, your vehicle will continue
to be drivable, but we recommend
that the system be checked by an
authorized HYUNDAI dealer.
i
Page 140 of 473
3-78
Convenient features of your vehicle
Urea system warninglamp
When the vehicle has critical prob- lems such as incorrect urea replen-
ishment, urea consumption devia-
tion, urea dosing interruption or
EGR(exhaust gas recirculation) sys-tem malfunction, the urea system
warning lamp will start blink with lim-
ited engine torque or vehicle speed.
Engine oil level warn-ing light (if equipped)
The engine oil level warning light illu-
minates when the engine oil level
should be checked.
If the warning light comes on, check
the engine oil level as soon as possi-
ble and add engine oil as required.
Slowly pour the recommended oil lit-
tle by little into a funnel. Use only the specified engine oil.
(Refer to "Recommended lubricantsand capacities" in section 8.)
Do not overfill the engine oil to
ensure the oil level is not above F
mark on the dipstick. Information
If you travel approximately 50~100 km after the engine warms up, after
adding the engine oil, the warning
light will go off.
Cycle the ignition from OFF to ON 3 times within 10 seconds, the warn-
ing light will go off immediately.
However, when you turn off the
warning light without adding the
engine oil, the light will come on
again after traveling approximately
50~100 km after the engine warms
up.
If the light comes on continuously
after adding the engine oil and
traveling approximately 50~100
km after the engine warms up, werecommend that the system be
checked by an authorized
HYUNDAI dealer. Even if this light doesn't come on
after the engine has started, the
engine oil should be checked and
supplied periodically.
NOTICE
i