speed HYUNDAI I10 2021 Workshop Manual
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2021, Model line: I10, Model: HYUNDAI I10 2021Pages: 486, PDF Size: 6.04 MB
Page 341 of 486
6-85
06
i Information
2 $ ,
First, switch the mode to Cruise
Control by pressing the
button
if equipped with the Speed Limit
Control System.
7he mode changes, as below, whenever
the
button is pressed.
System off
Speed Limit ControlCruise Control
2 $ ,
3. 3 X V K W K H W R J J O H V Z L W F K G R Z Q 6 ( 7
and release it. The Set speed on the
LCD display will illuminate.
5 H O H D V H W K H D F F H O H U D W R U S H G D O
i Information
7he vehicle may slow down or speed
up slightly whilst going uphill or down-
hill.
To increase Cruise Control
speed
2 $ ,
Page 342 of 486
6-86
Whilst driving
To decrease Cruise Control
speed
2 $ ,
Page 343 of 486
6-87
06
i Information
Each of the above actions will cancel
Cruise Control operation (the SE 7
indicator light in the instrument clus-
ter will go off), but only pressing the
CR 8ISE/
button will turn the
system off. If you wish to resume
Cruise Control operation, push the
toggle switch up (RES ) located on
your steering wheel.
the system was turned off using the
CR 8ISE/
button.
To resume preset Cruising
speed
2 $ ,
3 X V K W K H W R J J O H V Z L W F K X S 5 ( 6 , I
W K H Y H K L F O H V S H H G L V R Y H U P S K
km/h), the vehicle will resume the
preset speed.
To turn Cruise Control off
2 $ ,
Page 346 of 486
6-90
Whilst driving
Hydroplaning
If the road is wet enough and you are
going fast enough, your vehicle may
have little or no contact with the road
surface and actually ride on the water.
The best advice is SLOW DOWN
when the road is wet.
The risk of hydroplaning increases
as the depth of tyre tread decreas-
es, refer to “Tyre replacement” in
chapter 8.
Driving in flooded areas
Avoid driving through flooded areas
unless you are sure the water is no
higher than the bottom of the wheel
hub. Drive through any water slowly.
Allow adequate stopping distance
because brake performance may be
reduced.
After driving through water, dry the
brakes by gently applying them sev-
eral times whilst the vehicle is moving
slowly.
Highway driving
Tyres
$ G M X V W W K H W \ U H L Q I O D W L R Q D V V S H F L I L H G
Under-inflation may overheat or dam-
age the tyres.
Do not install worn-out or damaged
tyres, which may reduce traction or
fail the braking operation.
i Information
1ever over-inflate your tyres above the
maximum inflation pressure, as speci-
fied on your tyres.
Fuel, engine coolant and engine
oil
Driving at higher speeds on the high-
way consumes more fuel and is less
efficient than driving at a slower, more
P R G H U D W H V S H H G 0 D L Q W D L Q D P R G H U-
ate speed in order to conserve fuel
when driving on the highway.
% H V X U H W R F K H F N E R W K W K H H Q J L Q H
coolant level and the engine oil before
driving.
Drive belt
A loose or damaged drive belt may
overheat the engine.
Page 347 of 486
6-91
06
The severe weather conditions of
winter quickly wear out tyres and
cause other problems. To minimise
winter driving problems, you should
W D N H W K H I R O O R Z L Q J V X J J H V W L R Q V
Snow or icy conditions
You need to keep sufficient distance
between your vehicle and the vehicle
in front of you.
Apply the brakes gently. Speeding,
rapid acceleration, sudden brake
applications, and sharp turns are
potentially very hazardous practices.
During deceleration, use engine brak-
ing to the fullest extent. Sudden brake
applications on snowy or icy roads
may cause the vehicle to skid.
To drive your vehicle in deep snow, it
may be necessary to use snow tyres
or to install tyre chains on your tyres.
Always carry emergency equipment.
Some of the items you may want to
carry include tyre chains, tow straps
or chains, a flashlight, emergency
I O D U H V V D Q G D V K R Y H O M X P S H U F D E O H V
a window scraper, gloves, ground
cloth, coveralls, a blanket, etc.
Snow tyres
WARNING
Snow tyres should be equivalent
in size and type to the vehicle’s
standard tyres. Otherwise, the
safety and handling of your vehi-
cle may be adversely affected.
If you mount snow tyres on your vehi-
cle, make sure to use radial tyres of
the same size and load range as the
R U L J L Q D O W \ U H V 0 R X Q W V Q R Z W \ U H V R Q D O O
four wheels to balance your vehicle’s
handling in all weather conditions.
The traction provided by snow tyres
on dry roads may not be as high as
your vehicle’s original equipment
tyres. Check with the tyre dealer for
maximum speed recommendations.
i Information
'o not install studded tyres without
first checking local and municipal reg-
ulations for possible restrictions
against their use.
WINTER DRIVING
Page 355 of 486
7-3
07
OAC3079001TU
The hazard warning flasher serves as
a warning to other drivers to exercise
extreme caution when approaching,
overtaking, or passing your vehicle.
It should be used whenever emer-
gency repairs are being made or
when the vehicle is stopped near the
edge of a roadway.
To turn the hazard warning flasher on
or off, press the hazard warning flash-
er button with the ignition switch in
any position. The button is located in
the centre fascia panel. All turn signal
lights will flash simultaneously.
‡ The hazard warning flasher oper-
ates whether your vehicle is run-
ning or not.
‡ The turn signals do not work when
the hazard flasher is on
HAZARD WARNING FLASHER IN CASE OF AN EMERGENCY
WHILST DRIVING
, I W K H H Q J L Q H V W D O O V Z K L O V W
G U L Y L Q J
‡ Reduce your speed gradually,
keeping a straight line. Move cau-
tiously off the road to a safe place.
‡ Turn on your hazard warning flash-
er.
‡ Try to start the engine again. If your
vehicle will not start, we recom-
mend that you contact a HYUNDAI
authorised repairer.
, I W K H H Q J L Q H V W D O O V D W D F U R V V-
U R D G R U F U R V V L Q J
If the engine stalls at a crossroads or
crossing, if safe to do so, move the
shift lever to the N (Neutral) position
and then push the vehicle to a safe
location.
Page 356 of 486
7-4
Emergency situations
, I \ R X K D Y H D I O D W W \ U H Z K L O V W
G U L Y L Q J
If a tyre goes flat whilst you are driv-
ing:
‡ Take your foot off the accelerator
pedal and let the vehicle slow down
whilst driving straight ahead. Do not
apply the brakes immediately or
attempt to pull off the road as this
may cause loss of vehicle control
resulting in an accident. When the
vehicle has slowed to such a speed
that it is safe to do so, brake care-
fully and pull off the road. Drive off
the road as far as possible and park
on firm, level ground. If you are on
a divided highway, do not park in
the median area between the two
traffic lanes.
Page 366 of 486
7-14
Emergency situations
/ R Z W \ U H S U H V V X U H
W H O O W D O H
/ R Z W \ U H S U H V V X U H S R V L W L R Q W H O O-
W D O H D Q G W \ U H S U H V V X U H W H O O W D O H
OAC3079037R
When the tyre pressure monitoring
system warning indicators are illumi-
nated and warning message dis-
played on the cluster LCD display,
one or more of your tyres is signifi-
cantly under-inflated. The Low Tyre
Pressure Position Telltale will indi-
cate which tyre is significantly
under-inflated.If either telltale illuminates, immedi-
ately reduce your speed, avoid hard
cornering and anticipate increased
stopping distances. You should stop
and check your tyres as soon as pos-
sible. Inflate the tyres to the proper
pressure as indicated on the vehicle’s
placard or tyre inflation pressure label
located on the driver’s side centre pil-
lar outer panel. Then, reset TPMS
according TPMS reset procedure.
If you cannot reach a service station
or if the tyre cannot hold the newly
added air, replace the low pressure
tyre with the spare tyre.
The Low Tyre Pressure Telltale will
remain on and the TPMS Malfunction
Indicator may blink for one minute
and then remain illuminated until you
have the low pressure tyre repaired
and replaced on the vehicle.
Page 377 of 486
7-25
07
OAC3079010TU
For safe operation, carefully read and
follow the instructions in this manual
before use.
(1) Compressor
(2) Sealant bottle
The Tyre Mobility Kit is a temporary
fix to the tyre and we recommend that
the system be inspected by a
HYUNDAI authorised repairer.
CAUTION
: K H Q W Z R R U P R U H W \ U H V D U H I O D W G R
Q R W X V H W K H W \ U H P R E L O L W \ N L W
E H F D X V H W K H V X S S R U W H G R Q H V H D O-
D Q W R I 7 \ U H 0 R E L O L W \ . L W L V R Q O \ X V H G
I R U R Q H I O D W W \ U H
WARNING
' R Q R W X V H W K H 7 \ U H 0 R E L O L W \ . L W W R
U H S D L U S X Q F W X U H V L Q W K H W \ U H Z D O O V
7 K L V F D Q U H V X O W L Q D Q D F F L G H Q W G X H
W R W \ U H I D L O X U H
WARNING
+ D Y H \ R X U W \ U H U H S D L U H G D V V R R Q D V
S R V V L E O H 7 K H W \ U H P D \ O R V H D L U
S U H V V X U H D W D Q \ W L P H D I W H U L Q I O D W L Q J
Z L W K W K H 7 \ U H 0 R E L O L W \ . L W
, Q W U R G X F W L R Q
With the Tyre Mobility Kit you stay
mobile even after experiencing a tyre
puncture.
The system of compressor and seal-
ing compound effectively and com-
fortably seals most punctures in a
passenger car tyre caused by nails or
similar objects and reinflates the tyre.
After you ensured that the tyre is
properly sealed you can drive cau-
tiously on the tyre (distance up to 120
miles (200 km)) at a max. speed 50
mph (80 km/h) in order to reach a ser-
vice station or tyre dealer to have the
tyre replaced.
It is possible that some tyres, espe-
cially with larger punctures or dam-
age to the sidewall, cannot be sealed
completely.
Air pressure loss in the tyre may
adversely affect tyre performance.
For this reason, you should avoid
abrupt steering or other driving
manoeuvres, especially if the vehicle
is heavily loaded or if a trailer is in
use.
The Tyre Mobility Kit is not designed
or intended as a permanent tyre
repair method and is to be used for
one tyre only. This instruction shows
you step by step how to temporarily
seal the puncture simply and reliably.
Read the section “Notes on the safe
use of the Tyre Mobility Kit”.
IF YOU HAVE A FLAT TYRE ãWITH TYRE MOBILITY KIT
IF EQUIPPEDä
Page 379 of 486
7-27
07
& R P S R Q H Q W V R I W K H 7 \ U H 0 R E L O L W \ . L W
1. Speed-restriction label
2. Sealant bottle and label with speed
restriction
3. Filling hose from sealant bottle to
wheel
4. Connectors and cable for the
power outlet direct connection
5. Holder for the sealant bottle
6. Compressor
7. ON/OFF switch8. Pressure gauge for displaying the
tyre inflation pressure
9. Button for reducing the tyre infla-
tion pressure
Connectors, cable and connection
hose are stored in the compressor
housing.
Strictly follow the specified sequence,
otherwise the sealant may escape
under high pressure.
ODE067044