Signal light HYUNDAI I20 2023 User Guide

Driver assistance system
7-74
Limitations of Intelligent Speed
Limit Assist
Intelligent Speed Limit Assist may not
operate or may not provide correct
information under the following
circumstances:

[The road sign is contaminated or
indistinguishable
- The road sign is difficult to see due
to bad weather, such as rain, snow,
fog, etc.
- The road sign is not clear or
damaged
- The road sign is partially obscured by
surrounding objects or shadow

[The road signs do not conform to the
standard
- The text or picture on the road sign is
different from the standard
- The road sign is installed between
the main line and the exit road or
between diverging roads
- An conditional road sign is not
installed with a sign located on the
road to enter or exit
- A sign is attached to another vehicle

[The distance between the vehicle and
the road signs is too far

[The vehicle encounters illuminant road
signs

[Intelligent Speed Limit Assist
incorrectly recognises numbers in the
street signals or other signs as the
speed limit

[The minimum speed limit sign is on
the road

[The brightness changes suddenly, for
example when entering or exiting a
tunnel or passing under a bridge

[Headlamps are not used or the
brightness of the headlamps are weak
at night or in the tunnel

[Road signs are difficult to recognise
due to the reflection of sunlight, street
lights, or oncoming vehicles
[The navigation information or GPS
information contain errors.

[The driver does not follow the guide of
the navigation.

[The driver is driving a new road that is
not in the navigation system yet.

[The field of view of the front view
camera is obstructed by sun glare

[Driving on a road that is sharply
curved or continuously curved

[Driving through speed bumps, or
driving up and down or left to right on
steep inclines

[The vehicle is shaking heavily
Information
For more details on the limitations of the
front view camera, refer to “Forward
Collision-Avoidance Assist (FCA)” section
in chapter 7.
WARNING

[Intelligent Speed Limit Assist is a
supplemental function that helps the
driver to comply with the speed limit
on the road, and may not display the
correct speed limit or control the
driving speed properly.

[Always set the vehicle speed to the
speed limit in your country.

8-3
08
OBC3N080001
The hazard warning flasher serves as a
warning to other drivers to exercise
extreme caution when approaching,
overtaking, or passing your vehicle.
It should be used whenever emergency
repairs are being made or when the
vehicle is stopped near the edge of a
roadway.
To turn the hazard warning flasher on
or off, press the hazard warning flasher
button with the ignition switch in any
position. The button is located in the
centre fascia panel. All turn signal lights
will flash simultaneously.

[The hazard warning flasher operates
whether your vehicle is running or not.

[The turn signals do not work when the
hazard flasher is on.
HAZARD WARNING FLASHER

9
Battery ........................................................................................................... 9-29For best battery service .......................................................................................... 9-30
Battery capacity label .............................................................................................. 9-31
Battery recharging ................................................................................................... 9-31
Reset items .............................................................................................................. 9-32
Tyres and wheels ........................................................................................... 9-33Tyre care ................................................................................................................... 9-33
Recommended cold tyre inflation pressures ........................................................ 9-34
Check tyre inflation pressure ................................................................................. 9-34
Tyre rotation ............................................................................................................. 9-35
Wheel alignment and tyre balance ........................................................................ 9-36
Tyre replacement..................................................................................................... 9-36
Wheel replacement ................................................................................................. 9-38
Tyre traction ............................................................................................................. 9-38
Tyre maintenance .................................................................................................... 9-38
Tyre sidewall labelling ............................................................................................. 9-38
Low aspect ratio tyres ..............................................................................................9-41
Fuses .............................................................................................................. 9-42Instrument panel fuse replacement ...................................................................... 9-43
Engine compartment panel fuse replacement ..................................................... 9-44
Fuse/relay panel description .................................................................................. 9-45
Light bulbs .....................................................................................................9-59Headlight, Position Light, Turn signal Light bulb replacement ............................9-60
Headlight and front fog light aiming (For Europe) ................................................ 9-65
Side repeater light replacement ............................................................................ 9-70
Rear combination light bulb replacement ............................................................. 9-71
High mounted stop light replacement .................................................................. 9-78
License plate light bulb replacement .................................................................... 9-78
Interior light bulb replacement .............................................................................. 9-79
Appearance care .......................................................................................... 9-80Exterior care ............................................................................................................9-80
Interior care ............................................................................................................. 9-85
Emission control system.............................................................................. 9-88Crankcase emission control system ......................................................................9-88
Evaporative emission control system ....................................................................9-88
Exhaust emission control system ...........................................................................9-89

9-8
Maintenance
Whilst operating your vehicle:

[Note any changes in the sound of the
exhaust or any smell of exhaust fumes
in the vehicle.

[Check for vibrations in the steering
wheel. Notice if there is any increased
steering effort or looseness in the
steering wheel, or change in its
straight-ahead position.

[Notice if your vehicle constantly turns
slightly or “pulls” to one side when
travelling on smooth, level road.

[When stopping, listen and check for
unusual sounds, pulling to one side,
increased brake pedal travel or “hard-
to-push” brake pedal.

[If any slipping or changes in the
operation of your transmission occurs,
check the transmission fluid level.

[Check the parking brake.

[Check for fluid leaks under your
vehicle (water dripping from the air
conditioning system during or after
use is normal).
At least monthly:

[Check coolant level in the engine
coolant reservoir.

[Check the operation of all exterior
lights, including the stoplights, turn
signals and hazard warning flashers.

[Check the inflation pressures of all
tyres including the spare for tyres that
are worn, show uneven wear, or are
damaged.

[Check for loose wheel lug nuts.
At least twice a year:
(i.e., every Spring and Autumn)

[Check radiator, heater and air
conditioning hoses for leaks or
damage.

[Check windscreen washer spray and
wiper operation. Clean wiper blades
with a clean cloth dampened with
washer fluid.

[Check headlight alignment.

[Check muffler, exhaust pipes, shields
and clamps.

[Check the seat belts for wear and
function.
At least once a year:

[Clean body and door drain holes.

[Lubricate door hinges and bonnet
hinges.

[Lubricate door and bonnet locks and
latches.

[Lubricate door rubber weather strips.

[Lubricate door checker

[Check the air conditioning system.

[Inspect and lubricate automatic
transmission linkage and controls.

[Clean the battery and terminals.

[Check the brake fluid level.

9-60
Maintenance
Headlight, Position Light,
Turn signal Light bulb
replacement
Type A
OBC3N090030
(1) Headlight (Low/High)
(2) Turn signal light
(3) Position light (if equipped)
(4) Daytime running light/
D.R.L & Position
Type B -N line
OBC3TN091003
(1) Headlight (Low/High)
(2) Turn signal light
(3) Daytime running light & Position light
Type C - CUV
OBC3V091001
(1) Headlight(Low/High)
(2) Turn signal light
(3) Daytime running light & Position light
*1 : MFR (Multi Focus Reflector) Headlight

9-63
09
OBC3090039
OBC3TN091006
„CUV
7XUQVLJQDOOLJKW
1. Open the bonnet.
2. Remove the turn signal light or low
beam assist-static light bulb cover by
turning it counterclockwise.
3. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on the
assembly.
4. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
5. Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly.
Push the socket into the assembly and
turn the socket clockwise.
6. Install the turn signal light or low
beam assist-static light bulb cover by
turning it clockwise.
3RVLWLRQOLJKW'D\WLPHUXQQLQJOLJKW
LIHTXLSSHG
If the LED lamp does not operate,
we recommend that the system be
inspected by a HYUNDAI authorised
repairer.
The LED lamps cannot be replaced as
a single unit because it is an integrated
unit. The LED lamp has to be replaced
with the unit. Unless a skilled technician
checks or repairs the LED lamp, it may
damage related parts of the vehicle.

9-64
Maintenance
Type D (LED)
OBC3090037
Type E (LED)-N line
OBC3TN091001
(1) headlight (Low)
(2) headlight (High)
(3) Static Bending Light
(4) Turn signal light
(5) Daytime running light & Position light
(6) Front fog light
Type F (LED)-CUV
OBC3V091005
(1) Headlight (Low)
(2) Headlight (High)
(3) Static Bending Light
(4) Daytime running light & Position &
Turn signal light
+HDGOLJKW3RVLWLRQOLJKW7XUQVLJQDO
OLJKW'D\WLPHUXQQLQJOLJKW/RZ
EHDPDVVLVWVWDWLFOLJKWEXOEUHSODFH
PHQW
If the LED lamp does not operate,
we recommend that the system be
inspected by a HYUNDAI authorised
repairer. The LED lamps cannot be
replaced as a single unit because it is an
integrated unit. The LED lamp has to be
replaced with the unit.
Unless a skilled technician checks or
repairs the LED lamp, it may damage
related parts of the vehicle.

9-71
09
Rear combination light bulb
replacement
Type A
OBC3090045
„Type A
(1) Turn signal light
(2) Tail/Stop light
(3) Tail light
(4) Back-up light /Rear reflection light
(5) Rear fog light /Rear reflection light
OIB074037
OIB074038A
1. Open the tailgate
2. Loosen the light assembly retaining
screws with a cross-tip screwdriver.
3. Remove the rear combination light
assembly from the body of the
vehicle.

9-72
Maintenance
OBC3090047
[1] : Turn Signal Light, [2] : Tail/Stop Light,
[3] : Tail light
7XUQVLJQDOOLJKW7DLOVWRSOLJKW
4. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on the
assembly.
5. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on the
bulb align with the slots in the socket.
Pull the bulb out of the socket.
6. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
7. Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly. Push the
socket into the assembly and turn the
socket clockwise.
8. Reinstall the light assembly to the
body of the vehicle.
7DLOOLJKW
1. Open the tailgate and remove the
tailgate trim.
2. Loosen the retaining screw of the
tailgate lid cover and then remove the
cover.
3. Disconnect the connector and then
remove the nuts by turning the nuts
counter clockwise.
4. Take the light assembly out.
OBC3090049R
[1] : Rear Fog Light, [2] : Back-up Light
5HDUIRJOLJKW%DFNXS/LJKW
1. Remove the rear tire and wheel cover.
2. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on the
assembly.
3. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on the
bulb align with the slots in the socket.
Pull the bulb out of the socket.
4. Insert a new bulb in the socket.
5. Reinstall the light assembly to the
body of the vehicle.

9-73
09
Type B
OBC3090046
(1) Tail light
(2) Stop light
(3) Turn signal lamp
(4) Tail light
(5) Rear fog light /Rear reflection light
(6) Back-up light
OIB074037
OIB074038A
1. Open the tailgate
2. Loosen the light assembly retaining
screws with a cross-tip screwdriver.
3. Remove the rear combination light
assembly from the body of the
vehicle.