stop start Hyundai Ioniq Hybrid 2017 Quick Reference Guide

Steering wheel
audio controlPage26
12V Battery
Reset SwitchPage07 Instrument
clusterPage18
NavigationPage34-35
Instrument
panel lillumination Page22
Climate
controlPage24-25
HeadlightsPage09
Table of contents
Cruise control/
Smart cruise controlPage42
Wiper and
washerPage10
Dual clutch
transmissionPage37-38
Driver position
memory systemPage05

WARNING!
To reduce the risk of serious injury to yourself and others,
read and understand the important SAFETY INFORMATION
in your Owner’s Manual.
* Some vehicles may not be equipped
with all the listed features.
Use this Quick Reference Guide to learn
about the features that will enhance your
enjoyment of your Hyundai. More detailed
information about these features are
available in your Owner’s Manual.
Driver's main
controlsPage08
GETTING STARTEDDriver position memory system 05
Engine start/stop button 05
Front seat adjustment (manual) 03
Front seat adjustment (power) 03
Headrest adjustment 04
Seat belt adjustment (front seat) 04
Smart key 02FEATURES AND CONTROLS12 volt battery reset switch 07
Automatic climate control 24-25
Child-protector rear door lock 13
Clock adjustment 16
Driver’s main controls 08
Dynamic bending light (DBL) 10
Fuel filler door 06
Headlights 09
High voltage battery cooling duct 16
Homelink wireless control system 14
Hybrid battery SOC(State Of Charge) gauge 21
Instrument cluster 18
Instrument panel illumination 22
Interior lights 12
LCD display control 22
LCD display modes 23
Liftgate opening 12
Power gauge 21
Rear seat folding 13
Rear view camera 16
Seat warmer (front seats) 15
Steering wheel adjustments 06
Sunroof 11
Warning and indicators 18-20
Wireless cellular phone charging system 15
Wiper and washer 10MULTIMEDIAAUX, USB and iPod® port 35
Blue Link Telematics System 31-33
Bluetooth® phone call operational tips 26-27
Bluetooth® phone operation 29-30
Navigation 34-35
Steering wheel audio control 26
Voice recognition tips 28DRIVINGAutonomous emergency braking (AEB) 41
Blind spot detection system (BSD) 40
Cruise control/smart cruise control 42
Dual clutch transmission 37-38
Electronic stability control (ESC) 39
Hybrid driving tips 43
Lane departure warning system (LDWS) 40
Tire pressure monitoring system (TPMS) 36
Virtual engine sound system(VESS) 39

Quick Reference Guide I 05
04 I Quick Reference Guide
IONIQ HYBRID HYUNDAI
GETTING STARTED
Storing
1. Adjust the driver’s seat position,
outside rearview mirror position and
instrument panel illumination intensity.
2.
Press the SET button. The system
will beep once.
3.
Press one of the memory buttons
(1 or 2) within 4 seconds.
The system will beep twice.
NOTE:
The shift lever must be in P (Park).
Recalling
Press the desired memory button (1 or 2).
The system will beep once.
Pull up to raise.Press button and
push down to lower.
With the ignition OFF and foot OFF
of brake pedal, press the Engine
Start / Stop button.• Once for ACC (Accessory) mode.• Twice for ON mode.• Third for OFF.
ENGINE START / STOP BUTTON DRIVER POSITION MEMORY SYSTEM
SEAT BELT ADJUSTMENT (Front seat) HEADREST ADJUSTMENT
To Raise the Headrest:

Pull headrest up.
To Lower the Headrest:

Press lock button while pressing
down on headrest.
To start the vehicle in any mode (including OFF), press the Engine Start / Stop
button while pressing down on the brake pedal.
To turn off the vehicle, place the shift lever in P (Park) and press
the Engine Start / Stop button.NOTE:
If the START/STOP button is not lit and not responding, see the 12V
Battery Reset Switch section in the Owner’s Manual.
Emergency Situations To turn the vehicle off while moving Press the Engine Start / Stop button for more than 2 seconds or 3 times
consecutively within 3 seconds.To restart the vehicle while movingPress the Engine Start / Stop button with the shift lever in N (Neutral).

Quick Reference Guide I 07
06 I Quick Reference Guide
IONIQ HYBRID HYUNDAI
FEATURES AND CONTROLS
1. Pull the lever
1 down.
2. Set the angle 2 and distance
3.
3. Pull the lever
1 up to lock position.
NOTE:
Do not adjust while driving.
STEERING WHEEL ADJUSTMENTS
1
2
3
This vehicle does not have a
replaceable 12V flooded lead acid
battery. The 12V battery is integrated
into the lithium high voltage battery
assembly. Is it automatically protected
against vehicle current draw when a
minimum level of 12.8V 10% SOC level
is reached. The 12V Battery Reset
Switch has to be activated in order to
start the vehicle. This should negate
the need to jump start the car.
1. Press the 12V Battery Reset switch to reconnect the 12V battery.
2. Start the vehicle within 15 seconds of pressing the 12V Battery
Reset switch.
3. After starting vehicle ( indicator on), operate the vehicle safely
outdoors stopped and/or drive it for 30 minutes total to charge the
12V battery fully.
If the reset does not work due to over discharge of the 12V battery, try
to jump-start the vehicle. For more detailed information, please refer to
your Owner’s Manual.
12 VOLT BATTERY RESET SWITCH
1. Push the fuel filler door opener
button.
2. Remove the fuel tank cap.NOTE:Tighten the fuel filler cap until one
click is heard.
FUEL FILLER DOOR
If the vehicle Start/Stop button does not respond (it has no indicator light)
and the dash does not illuminate, the vehicle may be operated after the
12V Battery Reset Switch is activated per the instructions below.

Quick Reference Guide I 15
14 I Quick Reference Guide
IONIQ HYBRID HYUNDAI
Standard Programming To train most devices, follow these instructions:
1. For the first-time programming, press and hold the two outside
buttons, HomeLink
® Channel 1 and Channel 3 buttons, until the
indicator light begins to flash (after 10 seconds). Release both
buttons. Do not hold the buttons for over 20 seconds.
2. Position the end of your hand-held transmitter 1-3in. (2-8cm)
away from the HomeLink
® buttons while keeping the indicator
light in view.
3. Simultaneously press and hold both the HomeLink
® and the
hand-held transmitter button. DO NOT release the buttons until
step 4 has been completed.
4. While continuing to hold the buttons, the red indicator Status LED
will flash slowly and then rapidly after HomeLink
® successfully
trains to the frequency signal from the hand-held transmitter.
Release both buttons.
For more detailed information, please refer to your Owner’s Manual, or
visit www.homelink.com or call (800) 355-3515.
HOMELINK WIRELESS CONTROL SYSTEM
SEAT WARMER (Front seat)
Each time you push the button,
the setting is changed as follows:OFFMIDDLE HIGH
LOW
FEATURES AND CONTROLS
WIRELESS CELLULAR PHONE CHARGING SYSTEM
There is a wireless cellular phone
charging system inside the front
console. The system operates with
all doors closed, and the Engine
Start/Stop button in the ACC/ON/
START position.NOTE:The wireless cellular phone charging
system supports only the Qi-enabled
cellular phones (
).
NOTE:
Do not place any metallic items such as coins, keys on the
charger. Avoid placing credit cards on the charger as they may be
damaged by the magnetic field.
The charging area may be warm while using wireless charging.
If you want to turn it off immediately,
press and hold the button.

Quick Reference Guide I 39
38 I Quick Reference Guide
IONIQ HYBRID HYUNDAI
DRIVING
VIRTUAL ENGINE SOUND SYSTEM(VESS)The Virtual Engine Sound System generates engine sound for
pedestrians to hear vehicle sound because there is limited sound while
motor power is used.
ESC automatically selects the ON
position when the engine is started.To turn off Traction ControlPress the ESC OFF button shortly.To turn off Traction & Stability
ControlPress the ESC OFF button for more
than 3 seconds.The ESC system is an electronic
system designed to help the driver
maintain vehicle control under
adverse conditions.
ELECTRONIC STABILITY CONTROL (ESC)
NOTE:
Dual Clutch Transmission characteristics
The new technology of the Dual Clutch Transmission is different from a
traditional automatic or manual transmission:
• The Dual Clutch Transmission is an automatically shifting manual
transmission.
• Dual Clutch Transmission utilizes two clutches connected to a
computer-controlled manual gearbox. It provides the convenience of
a transmission that shifts automatically, with the efficiency of a manual
transmission.
• When you turn the engine on and off, you may hear clicking sounds as
the system goes through a self test.
This is a normal sound for the Dual Clutch Transmission.
• When you stop on a hill, if you remove your foot from the brake pedal,
the vehicle will remain stationary for approximately two seconds to help
prevent the vehicle from rolling backwards. If you depress the
accelerator pedal during the two second interval, the vehicle will
accelerate.
If you wait more than two seconds, the vehicle will enter creep mode
and may roll backwards if the hill is steep.
Caution• You should always use the foot brake to hold the car on a hill until you
are ready to drive. Using creep mode to hold the car on a hill may
damage the clutch.
• If the clutch becomes overheated by excessive use of the clutch to hold
on a hill, you may notice a shudder feeling and a blinking display on
the instrument cluster. When this occurs, the clutch is disabled until the
clutch cools to normal temperatures. If this occurs, pull over to a safe
location, shift into P (Park) and apply the foot brake for a few minutes.