ATF Hyundai Terracan 2006 Owner's Manual
[x] Cancel search | Manufacturer: HYUNDAI, Model Year: 2006, Model line: Terracan, Model: Hyundai Terracan 2006Pages: 539, PDF Size: 18.11 MB
Page 33 of 539

1
FEATURES OF YOUR HYUNDAI
19
This will release the seat on its track so you can move it forward or rearwardto the desired position. When you find the position you want, release the lever and slide the seat forward orrearward on its track until it locks into the desired position and cannot be moved further.
!WARNING:
To ensure the seat is locked se- curely, attempt to move the seatforward or rearward without using the lock release lever.!
B080C01A-AAT Adjusting Seatback Angle To recline the seatback, lean forward to take your weight off it, then pull up onthe recliner control lever at the outside edge of the seat. Now lean back until the desired seatback angle is achieved.To lock the seatback into position, release the recliner control lever.
WARNING:
To minimize risk of severe injury inthe event of a collision or a sudden stop, both the driver and passen-ger seatbacks should always be in an upright position while the ve- hicle is in motion. The protectionprovided by the seat belts and airbags in a frontal collision may be reduced significantly when theseatbacks are reclined. There is greater risk that the driver and pas- senger will slide under the seat beltwhich may result in serious injury if a crash occurs when the seatbacks are reclined.The seat belt cannot provide full protection to an occupant if the seat back is reclined.
HHP2027
B080D02JM-GAT Adjustable Headrests
Lock knobB080D01HP
Headrests are designed to help reduce the risk of neck injuries. To raise the headrest, pull it up. Tolower it, push it down while pressing the lock knob. To remove the head- rest, raise it as far as it can go thenpress the lock knob while pulling up- ward.
Page 291 of 539

9
VEHICLE SPECIFICATIONS
5
J080A10HP-GAT Item
Transmission FluidTransfer Case OilFront Axle Gear Oil Rear Axle Gear Oil Coolant Power Steering OilBrakes and Clutch Fluid Oil & Grease Standard
HYUNDAI GENUINE PARTS MTF 75W/85 (API GL-4)MOBIL DEXRON-IIATF DEXRON-IIIHYPOID GEAR OIL API GL-5 or HIGHER,SAE 80W[BELOW -30°C(-22°F)]/90W[ABOVE -30°C(-22°F)]MITSUBISHI GENUINE GEAR OIL PART NO. 8149630EX orCASTROL HYPOY LS(2.5 TCI)MOBIL INFILREX 33 (2.9 CRDi or 3.5 V6)HYPOID GEAR OIL API GL-5 or HIGHER,SAE 80W[BELOW -30°C(-22°F)]/90W[ABOVE -30°C(-22°F)]Ethylene glycol base for aluminum radiatorPSF-3 TYPE FLUIDDOT 3, DOT 4 or Equivalent
Q'ty (liter)
2.5 (2.5 TCI), 3.2 (2.9 CRDi or 3.5 V6) 8.2 (2.5 TCI), 11.8 (2.9 CRDi ), 10.5 (3.5 V6)1.42Part-time 4WD : 1.8Full-time 4WD : 1.3 NO.7 : 2.6, NO.7.5 : 2.88(2.5 TCI), 9(2.9 CRDi), 11(3.5 V6) 1.3As required
Manual Automatic
With LSD Without LSD
Page 324 of 539

1CONTROLS AND EQUIPMENT
16
!WARNING:
Front seat adjustments must not be undertaken whilst the vehicle is in motion. Loss of control of the ve-hicle may result if seat adjustments are made whilst the vehicle is in motion. ZB060A8-E Front Seat Fore/Aft Adjustment
SEATS
SB070A1-E FRONT SEAT ADJUSTMENT
HHP2026-E
!WARNING:
o Seat adjustment should not be made whilst the vehicle is in mo- tion since loss of control of the vehicle may occur.
o To ensure the seat is locked se- curely, attempt to move the seatforward or rearward without usingthe lock release lever.
Front seat fore/aft adjustment is facili-tated by turning the lever located on the front centre of the seat base and sliding the seat forwards or backwards as re-quired. When the seat is at the desired posi- tion, release the lever and ensure thatthe locking mechanism is engaged by rocking the seat to and fro.
Page 507 of 539

6
OWNER MAINTENANCE
29
The power steering fluid level should be checked regularly. To check the power steering fluid level, be sure the ignition is "OFF", then check to make certain that the powersteering fluid level is between the "MAX" and "MIN" level markings on the fluid reservoir. NOTE: Do not check whilst the engine is running. Do not start the engine when power steering fluid reservoir is empty. Fluid Recommendation Only automatic transmission fluid meeting the specification of PSF-3 orATF DEXRON 2 should be used in the power steering system.POWER STEERING FLUID LEVEL
G230A03A-EAT
Petrol Engine
G230A01HP-E
HHP5014-E
Diesel Engine
!WARNING:
The cooling fan is controlled by
engine coolant temperature and may sometimes operate even when the engine is not running. Do not touchthe radiator fan until it is completely stopped and the battery has been disconnected. As the coolant temperature de-
creases the fan will automaticallyshut off. This is a normal condi- tion.
Checking Engine Cooling Fan The engine cooling fan should auto- matically come on if the engine cool- ant temperature is high.
Checking Condenser Cooling Fan The condenser cooling fan (in front of the condenser) should come on auto- matically whenever the air conditioner is in operation.
CHECKING ELECTRIC COOLING FANS
YG210A1-E
Page 533 of 539

9 VEHICLE SPECIFICATIONS
4
Q'ty (lmp.qts)(litre)
Drain and refill (With oil filter) : 3.78 (4.3) Drain and refill (With oil filter) : 2WD : 6.64WD : 6.0 MAX. 1L /1,000 miles (1,500 Km) MAX. 1L /620 miles (1,000 Km) 2.82 (3.2) Petrol : 9.24(10.5), Diesel : 10.38 (11.8) 1.25(1.42)Part-time 4WD : 1.58(1.8) Full-time 4WD : 1.14(1.3) NO.7 : 2.29(2.6) NO.7.5 : 2.46(2.8) Petrol : 9.68 (11), Diesel : 7.92(9) 1.14 (1.3) As required
Item
Engine Oil Engine oil consumption Transmission Fluid Transfer case oil Front axle gear oil Rear axle gear oil Coolant Power steering oil Brakes and clutch fluid Oil & Grease Standard
API SJ, SL or ABOVE, SAE 5W-20, 5W-30
ILSAC GF-3 or ABOVE SAE 10W-30 (ABOVE 0°F) SAE 15W-40 (ABOVE 10°F)SAE 20W-50 (ABOVE 20°F)
API CF-4 or ABOVE, SAE 15W-40 (ABOVE 5°F)
ACEA B4 or ABOVE SAE 10W-30 (-4°F ~ 104°F)
SAE 5W-30 (-13°F ~ 104°F) SAE 0W-30 (BELOW 50°F) *1
*1. Restricted by driving condition and dealing areaNormal driving conditionSevere driving condition HYUNDAI GENUINE PARTS MTF 75W/85 (API GL-4) MOBILE DEXRON-IIATF DEXRON-III HYPOID GEAR OIL API GL-5 or HIGHER, SAE 80W[BELOW -22°F (-30°C)]/90W[ABOVE -22°F (-30°C)] INFILREX33 or MOBILUBE LS 85W-90 HYPOID GEAR OIL API GL-5 or HIGHER, SAE 80W[BELOW -22°F (-30°C)]/90W[ABOVE-22°F (-30°C)] Ethylene glycol base for aluminium PSF-3 or ATF Dexron 2DOT 3, DOT 4 or EquivalentLUBRICATION CHART
J080A12HP-EAT
Petrol Diesel
Manual
Auto
With LSD Without LSD