INFINITI FX35 2005 Service Manual

AV-102
NAVIGATION SYSTEM
Revision: 2005 July 2005 FX
TRIP 1 OR TRIP 2

Elapsed Time, Driving Distance and Average Speed are dis-
played as Trip 1 information or Trip 2 information.

The way to reset is by pushing the “Reset” switch or by keeping
pushing “TRIP” button more than 1.5 seconds.
FUEL ECONOMY

Average Fuel Economy, Distance to Empty, Fuel Economy are
displayed as Fuel Economy information.

The way to reset is by pushing the “Reset” switch or by keeping
pushing “TRIP” button more than 1.5 seconds.
MAINTENANCE

Engine Oil, Tire Rotation and Tire Pressure are displayed as
Maintenance information.
ENGINE OIL OR TIRE ROTATION

Possible to set up interval of engine oil and tire rotation by mov-
ing joystick right and left.
SKIA5990E
SKIA5991E
SKIA5992E
SKIA5993E

NAVIGATION SYSTEM AV-103
C
D E
F
G H
I
J
L
M A
B
AV
Revision: 2005 July 2005 FX
TIRE PRESSURE

Pressure indication in psi on the screen indicates that the
pressure is being measured. After a few driving trips, the pres-
sures for all four tires will be displayed.

The order of tire pressure figures displayed on the screen does
not correspond with the actual order of the tire position.

Tire pressure rises and falls depending on the heat caused by
the vehicle's traveling condition and the temperature.

FLAT TIRE–very low tire air pressure.
NOTE:

In a case of FLAT TIRE pressure, interrupt screen is not shown
on the display.

On the screen of TIRE PRESSURE, “FLAT TIRE”, “Check”, “All tire” is displayed.
WARNING INDICATIONS
Warning signal (door switch signal) is received from BCM through
CAN communication line.
SKIA5994E
SKIA5995E
Warning
indicators Warning lamps in
instrument panel Warning detection and cancel conditions
Cases of
malfunction
DOOR OPEN Door Detection condition
Vehicle is running [approx. 5km/h (3 MPH) or faster]
and door ajar of any of the doors is detected. Door is open.
Cancel condition Vehicle is stopped and all the doors lock.

AV-104
NAVIGATION SYSTEM
Revision: 2005 July 2005 FX
CAN Communication System DescriptionAKS007Z3
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle mul-
tiplex communication line with high data communication speed and excellent error detection ability. Many elec-
tronic control units are equipped onto a vehicle, and each control unit shares information and links with other
control units during operation (not independent). In CAN communication, control units are connected with 2
communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.
CAN Communication UnitAKS007Z0
Refer to LAN-30, "CAN Communication Unit" .
Component Parts Location and Harness Connector LocationAKS007IR
PKIB5033E

NAVIGATION SYSTEM AV-105
C
D E
F
G H
I
J
L
M A
B
AV
Revision: 2005 July 2005 FX
Schematic—NAVI—AKS007IS
TKWM2083E

AV-106
NAVIGATION SYSTEM
Revision: 2005 July 2005 FX
Wiring Diagram —NAVI—AKS007IT
TKWM2084E

NAVIGATION SYSTEM AV-107
C
D E
F
G H
I
J
L
M A
B
AV
Revision: 2005 July 2005 FX
TKWM2085E

AV-108
NAVIGATION SYSTEM
Revision: 2005 July 2005 FX
TKWH0268E

NAVIGATION SYSTEM AV-109
C
D E
F
G H
I
J
L
M A
B
AV
Revision: 2005 July 2005 FX
TKWM0810E

AV-110
NAVIGATION SYSTEM
Revision: 2005 July 2005 FX
TKWM0575E

NAVIGATION SYSTEM AV-111
C
D E
F
G H
I
J
L
M A
B
AV
Revision: 2005 July 2005 FX
TKWM1094E