lock INFINITI JX 2013 Quick Reference Guide

2
new system features
Remote Engine Start* (if so equipped)
your INfINITI Intelligent Key™ system allows the engine to start from
outside your vehicle. To use the remote start feature, perform the following:

1. Aim the INfINITI Intelligent Key at the vehicle. Operating range
is approximately 197 feet (60 m) from the vehicle.
2. Press the

button
01 to lock all doors.

3. Within 5 seconds press and hold the remote start

button
02
until the turn signal lights illuminate. If the vehicle is not within

view, press and hold the remote start button for about 2 seconds.

The parking lights will turn on and remain on as long as the engine
is running. The doors will be locked and the climate control system
may come on.

Repeat steps 1 - 3 to extend time an additional 10 minutes. A maximum of two remote starts,
or a single start with an extension, are allowed between ignition cycles.


Depress the brake and place the ignition switch in the ON position before driving.

To cancel a remote start, perform one of the following:
•
Aim the Intelligent Key at the vehicle and press and hold the

button until the parking
lights turn off.
•
Turn the hazard warning flashers on.
•
Cycle the ignition switch ON and then OFF.
*Laws in some communities may restrict the use of remote starters. Check local regulations before using this feature.
for more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
INFINITI Connection™ System* (if so equipped)
Infiniti Connection provides various types of information
and services by connecting your vehicle to the Infiniti
Connection Data Center. f or more details on the Infiniti
Connection service, terms and conditions, please refer
to www.Infiniticonnection.com.
Available services include:

Infiniti Personal Assistant – To access Infiniti Personal
Assistant, select “Connect to Voice Menu” from the Infiniti Connection menu or touch the


key (if available on the map screen). At the voice prompt, say “Infiniti Personal Assistant” to
be connected.
• your Infiniti Personal Assistant can send destination information directly to your vehicle.
To access, go to the Infiniti Connection menu and select “Sync All Information f eeds”.
Then go to the feeds menu page and download the desired destination information.

Automatic Collision Notification – In case of air bag deployment, a signal is sent containing
the vehicle location and customer information and notifies the proper authorities.
01
02
*Infiniti Connection™ is only available on vehicles equipped with optional Infiniti Connection™ subscription service.

3


Emergency Call (if so equipped) – This service provides emergency assistance by connecting
subscriber to an Infiniti Connection Specialist.
• In case of an emergency, press the in-vehicle
telematics SOS button

01 .
• A Response Specialist will provide assistance based
on the situation described by the vehicle’s occupant.

Enhanced Roadside Assistance (if so equipped) –
Roadside Assistance can be accessed by touching
the Infiniti Connection key on the Info menu, the

key (if available on the map screen) or by pressing the
SOS button.
• This service allows subscribers to receive assistance for a non-emergency incident such as
towing or a third party response.
• If warranted, Roadside Assistance may also be used in conjunction with the Emergency
Assistance service by pressing the SOS button.

My Schedule – Access your personal online Google Calendar™, hear details read via text-to-
speech** and select locations as a destination via the navigation system.

Report Stolen Vehicle – A Response Specialist will attempt to obtain location information
from a reported stolen vehicle and provide that information to local law enforcement agencies
to assist in the recovery of your stolen vehicle.

Remote Door Lock/Unlock – Remotely access your vehicle via Infiniti Connection Response
Specialist or designated website to remotely lock or unlock your vehicle.

Alarm Notification – This system will notify you when the factory-installed vehicle alarm
system has been activated.

Scheduled Maintenance Notification – Receive scheduled maintenance notifications based
on mileage data provided by your vehicle.

Maintenance Alert – Receive notification of a vehicle system malfunction that triggers
instrument panel warning lights.

Destination Assistance – Receive point-of-interest assistance via guided IVR (Interactive
Voice Response), Response Specialist, or Infiniti Connection web portal.

Destination Send-to Vehicle – find and download point-of interest information from
GoogleMaps™.

Connected Search – Select “Connected Search” from the Destination menu on the vehicle’s
navigation system to conduct a point-of-interest search within a certain distance of the
vehicle’s location.

Drive Zone – Monitor the movement of your vehicle within a specified region. Set up boundaries
in the Monitoring section of the Infiniti Connection web portal.

Max Speed Alert – Set up a maximum speed on the Infiniti Connection web portal. you will
receive notifications if your vehicle exceeds the max speed setting.
01
**Laws in some communities may restrict the use of text-to-speech. Check local regulations before using this feature.

essential information
Loose Fuel Cap
A LOOSE FUEL CAP warning message will appear
in the vehicle information display

01 when the
fuel-filler cap is not tightened correctly.

To tighten, turn the cap clockwise until a single click
is heard.

The warning message will disappear when the vehicle
detects the fuel-filler cap is properly tightened and the
reset button

02 is pressed for about 1 second.

If the cap is not properly tightened, the Malfunction
Indicator Light

may illuminate.
f
or more information, refer to the “Instruments and controls (section 2)”
and the “Pre-driving checks and adjustments (section 3)” of your
Owner’s Manual.
Tire Pressure Monitoring System (TPMS) with Tire Inflation Indicator
A Tire Pressure Low - Add Air warning message will
appear in the vehicle information display

01 and the

low tire pressure warning light
02 will illuminate when

one or more tires are low on pressure and air is needed.
• The tire pressures should be checked when the
tires are cold. The tires are considered cold after
the vehicle has been parked for 3 hours or more or
driven less than 1 mile (1.6km) at moderate speeds.

When adding air to an under-inflated tire, the TPMS
with Tire Inflation Indicator provides visual and
audible signals to help you inflate the tires to the
recommended COLD tire pressure.
To use the tire inflation indicator:
1. Move the shift lever to the P (PARK) position and apply the parking brake.
2. Place the ignition switch in the ON position. Do not start the engine.
3. Add air to the under-inflated tire and within a few seconds, the hazard warning lights will start
flashing.
4. When the designated tire pressure is reached, the horn will beep once and the hazard warning
flashers will stop flashing.
5. Repeat this procedure for any additional under-inflated tires.

After tire pressures are adjusted, drive the vehicle at speeds above 16 MPH (25km/h). The
Tire Pressure Low - Add Air warning message and low tire pressure warning light will disappear.

When the low tire pressure warning light flashes for approximately 1 minute and then remains
on, the TPMS is not functioning properly. Have the system checked by an INfINITI retailer.
01
01
02
7
02

9
INFINITI Intelligent Key™ System
The INfINITI Intelligent Key™ system allows you to lock or unlock your
vehicle, open your liftgate and remotely start the engine.
NOTE: It is important to make sure the Intelligent Key is with you (that is,
in your pocket or purse).
REMOTE ENGINE START (if so equipped)

The remote engine start operating range is approximately 197 feet
(60 m) from the vehicle.

To use the remote start feature to start the engine:
1. Aim the Intelligent Key at the vehicle.
2. Press the

button
01 to lock all doors.

3. Within 5 seconds press and hold the remote start

button
02 until the turn signal lights

illuminate. If the vehicle is not within view, press and hold the remote start button for about
2 seconds.
LOCKING AND UNLOCKING THE VEHICLE

The lock and unlock operating range of the Intelligent
Key is within 31.5 in (80 cm) from each request switch.

To lock the vehicle, push either door handle request
switch

03 once or press the
button
01 on the keyfob.

To unlock the vehicle, perform one of the following
procedures:
• Push either door handle request switch

03 once; the corresponding door will unlock. Push

the door handle request switch
again within 30 seconds; all
other doors will unlock, or
• Press the

button
04 on the keyfob to unlock the driver’s side door. Press the
button

again; all other doors will unlock.
LIf TGATE RELEASE

To open the rear liftgate, press the
button
05 for longer than 0.5 seconds.


To close the rear liftgate, press the
button
05 again for longer than 0.5 seconds.

PANIC ALARM

The Intelligent Key can also be used to activate the panic alarm by pressing and holding the

button
06 for more than 1 second. Once activated, the panic alarm and headlights will
stay on for 25 seconds.
first drive features
02
01
04
05
06
03

10
first drive features
INTELLIGENT KEy BATTERy DISCHARGE

If the battery of the Intelligent Key is discharged, or
environmental conditions interfere with the Intelligent
Key operation, start the engine according to the
following procedure:
1. Move the shift lever to the P (P ARK) position.
2. firmly apply the foot brake.
3. Touch the ignition switch with the Intelligent Key
and a chime will sound.
4. Within 10 seconds after the chime sounds, push the ignition switch while depressing the
brake pedal and the engine will start.
for more information, refer to the “Pre-driving checks and adjustments (section 3)”, the “Starting and driving (section 5)” and the
“Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
Power Liftgate
When the liftgate is closed and locked, the liftgate will
open automatically by:
• Pushing the power liftgate switch

01 on the
instrument panel.
• Pushing the liftgate request switch

02.
• Pressing the

button
03 on the INfINITI
Intelligent Key™ for more than 0.5 seconds.

To open the liftgate with the liftgate opener switch

04, the liftgate must be unlocked.

The power liftgate operation can be turned on or off
by the power liftgate main switch

05 on the instrument
panel.

When the power liftgate main switch
is pushed to the OFF position, power
operation is not available using the
power liftgate switch on the liftgate


06 or the liftgate opener switch 04.
f
or more information, refer to the “Pre-driving checks
and adjustments (section 3)” of your Owner’s Manual.
0501
0204
0603

11
Front Seat Adjustments
To slide the seat forward or backward, push the control
switch

01 forward or backward .


To recline the seatback, push the switch
02
forward or backward.
SEAT LIf TER

To raise or lower the front portion or height of the seat,
push the front or back end of the switch

01
up or down.

POWER LUMBAR SUPPORT (if so equipped for driver’s seat)

To adjust the seat lumbar support, push the front or back end of the switch
03 .
f
or more information, refer to the “Safety —— seats, seat belts and supplemental restraint system (section 1)” of your
Owner’s Manual.
2ND Row Seats
To slide the seat forward or backward, pull the center
of the bar

01 up and hold it while you slide the seat
forward or backward to the desired position. Release
the bar to lock the seat in position.

To recline the seatback, pull up on the seatback release
lever

02 and lean back. To bring the seatback forward,
pull the lever up and lean your body forward. Release
the lever to lock the seatback in position.
MULTI-MODE/CHILD SEAT ACCESS fUNCTION

If a child safety seat is installed on the passenger’s side of the 2nd row seat, the 3rd row can be
accessed without removing the child safety seat.

To access the 3rd row from outside the vehicle, lift up on the seatback release lever
03 .

EZ ENTRy MODE

To enter the 3rd row from outside the vehicle, lift up on the seatback lever
03 . This will release

the back of the seat and fold up the seat cushion.

Slide the entire seat forward for access to the rear seat.

To return the seat to a locked position, push the upper seatback rearward until the seatback and
track are locked. Push the seat cushion down.
for more information, refer to the “Safety —— seats, seat belts and supplemental restraint system (section 1)” of your Owner’s Manual.
010203
0102
03

21
Fuel-Filler Door
The fuel-filler door is located on the driver’s side of the vehicle.

The fuel-filler door automatically locks/unlocks when
the driver’s door is locked/unlocked.

To open the fuel-filler door, push the right side of the
fuel-filler door and release.
for more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
Power Outlets (if so equipped)
12V OUTLETS

The power outlets are for powering electrical
accessories such as cellular telephones. They are
rated at 12 volt, 120W (10A) maximum.

To use a power outlet, open the cap.

The power outlet on the instrument panel
01 ,
inside the center console
02 , on the back of the
center console
03 and in the cargo area
04
are powered only when the ignition switch
is in the ACC or ON position.
120V OUTLET (if so equipped)

The 120V outlet
05 is located on the back of the
center console.

To use the outlets for devices that require 120V power,
place your vehicle in the P (PARK) position with the
ignition in the ON position and push the power
inverter switch

06 .


The switch will illuminate when enabled.
for more information, refer to the “Instruments and controls (section 2)”
of your Owner’s Manual.
01
04
05
03
06
02