brake light INFINITI Q50 2016 Quick Reference Guide
[x] Cancel search | Manufacturer: INFINITI, Model Year: 2016, Model line: Q50, Model: INFINITI Q50 2016Pages: 36, PDF Size: 2.92 MB
Page 5 of 36

3
Idle Start/Stop (ISS) (if so equipped)
    The ISS activates to prevent unnecessary fuel 
consumption, exhaust emissions and noise. 
    When the brake pedal is depressed and the vehicle 
is stopped, the engine will stop automatically.
    When you release your foot from the brake pedal, 
the engine will restart automatically.
    The ISS indicator light  1 will inform you of the  
ISS status.
    The system can be temporarily deactivated by 
pushing the Idle Stop OFF AUTOOFF switch  2.
    There are certain conditions in which the ISS will 
not activate, including:
 
 
•
    
When the brake pedal is not firmly depressed.
 
 
•
    
When the steering wheel is operated or wheels 
are not pointed straight ahead.
 
 
•
    
When the engine is warming up.
 
 
•
    
When the cabin temperature is below 68°F (20°C) or above 86° \
F (30°C).
 
 
•
    
When the front/rear defroster is on or fan speed is at maximum.
    Please refer to the “Starting and driving (section 5)” of your O\
wner’s Manu al for the 
additional conditions in which the ISS will not activate.
For more information, refer to the “Instruments and controls (section 2)” and the “Starting and driving (section 5)” of your 
Owner’s Manual.
2
1
User Registration
     Driving positions, navigation, climate controls, etc., 
can be memorized for each user.
    To register a new user:
 
 
1. 
  
Press the 
 MENU button. The menu screen  
will appear.
 
 
2. 
  
Touch the right arrow key  until “Edit User” is 
displayed. Then touch the “Edit User” key.
 
 
3. Touch the “User List” key.
 
 
4. Touch the “Add New” key. From here, you can edit Name and Icon.\
 
 
5. Select the “OK” key when finished.
For more information, refer to the “Information and settings (section 8)” of your InTouch Owner’s Manual.
1967179_16b_Q50_US_QRG_012916.indd   31/29/16   1:51 PM  
Page 6 of 36

4
Tire Pressure Monitoring System (TPMS) with Tire Inflation Indicator
    A Flat Tire Visit Dealer  or Tire Pressure Low —  
Add Air warning message will appear in the vehicle 
information display 
 1 and the low tire pressure 
warning light  2 will illuminate when one or more 
tires are low in pressure and air is needed.
 
 
• 
 
The tire pressures should be checked when 
  
the tires are cold. The tires are considered cold 
after the vehicle has been parked for 3 hours  
or more or driven less than 1 mi (1.6 km) at 
moderate speeds.
    When adding air to an under-inflated tire, the TPMS 
with Tire Inflation Indicator provides visual and 
audible signals to help you inflate the tire to the recommended COLD tir\
e pressure.
To use the Tire Inflation Indicator:
 1. 
 
Move the shift lever to the 
 P (PARK) position and apply the parking brake.
 2. 
 
Place the ignition switch in the ON position. Do not start the engine.
 3. 
   
Add air to the under-inflated tire, and within a few seconds, the hazard\
 warning lights will 
start flashing.
 4. 
   
When the designated tire pressure is reached, the horn will beep once an\
d the hazard 
warning flashers will stop flashing.
 5. 
 
Repeat this procedure for any additional under-inflated tires.
    After tire pressures are adjusted, drive the vehicle at speeds above 16 \
mph (25 km/h). The 
Flat Tire Visit Dealer  or Tire Pressure Low — Add Air warning message and low tire pressure 
warning light 
 2 will extinguish.
    When the low tire pressure warning light  2 flashes for 1 minute and then remains on, the 
TPMS is not functioning properly. Have the system checked. It is recomme\
nded you visit 
an INFINITI retailer.
    Tire pressure rises and falls depending on the heat caused by the vehicl\
e’s  operation and 
the outside temperature. Low outside temperature can lower the temperatu\
re of the air 
inside the tire, which can cause a lower tire inflation pressure. This m\
ay cause the low tire 
pressure warning light 
 2 to illuminate. If the warning light illuminates, check the tire 
pressure in your tires.
 
 
• 
 
Check the tire pressure (including the spare tire) often and always pr\
ior to long  
distance trips.
    The Tire and Loading Information label contains valuable information. Pl\
ea se refer to 
the “Technical and consumer information (section 10)” of your Ow\
ner’s Manual for the 
location of the Tire and Loading Information label.
For more information, refer to the “Instruments and controls (section 2)”, the “Starting and driving (section 5)” and the 
“Maintenance and Do-it-yourself (section 8)” of your Owner’s Manual.
essential information
 1
 2
1967179_16b_Q50_US_QRG_012916.indd   41/29/16   1:51 PM  
Page 13 of 36

11
REMOTE ENGINE START* (if so equipped) 
    The remote engine start system must be enabled in the vehicle settings w\
ithin the 
 
lower display.
    The remote engine start operating range is approximately 197 ft (60 m)\
 from the vehicle. 
The effective operating range may be shorter due to environmental condit\
ions or obstacles 
between you and the vehicle.
    For the remote engine start to function, the vehicle must be in the  P (PARK) position with 
the ignition off and all the doors closed and locked.
  To start your vehicle remotely:
 
 
1.
  
Press the  button 4.
 
 
2.
   
Within 5 seconds, press and hold the remote engine start  button 8  
for at least 2 seconds.
    The engine will start, and the parking lights will turn on.
    The automatic climate control system will automatically adjust the passe\
nger compartment 
to the appropriate set temperature when the Remote Engine Start feature \
is used.
    The engine will run for 10 minutes and then turn off.
    Repeat steps 1 and 2 to extend the time for an additional 10-minute peri\
od.
 
 
• 
  
After two remote starts, the ignition switch must be cycled before the r\
emote start can be 
used again.
  To start driving, depress the brake pedal and press the ignition switch \
 START/STOP button.
INFINITI INTELLIGENT KEY BATTERY DISCHARGE
    If the battery of the Intelligent Key is discharged 
(expected life is about 2 years under normal use) 
or environmental conditions interfere with the 
Intelligent Key operation, start the engine according 
to the following procedure:
 
 
1. 
  
Move the shift lever to the 
 P (PARK) position. 
 
 
2. 
  
Firmly apply the foot brake.
  
 
 
3. 
   
Touch the ignition switch with the Intelligent Key, 
and a chime will sound.
 
 
4. 
   
Within 10 seconds after the chime sounds, press the i
 gnition switch START/STOP 
button while depressing the brake pedal and the engine will start.
For more information, refer to the “Instruments and controls (section 2)”, the “Pre-driving checks and adjustments (section 
3)”, the “Starting and driving (section 5)” and the “Maintenance and Do-it-yourself (section 8)” of your Owner’s Manual.
*Laws in some communities may restrict the use of remote starters. Check\
 local regulations before using this feature.
1967179_16b_Q50_US_QRG_012916.indd   111/29/16   1:52 PM  
Page 24 of 36

22
Conventional (Fixed Speed) Cruise Control (if so equipped)
    The cruise control system enables you to set a constant cruising speed o\
nce the vehicle 
has reached 25 mph (40 km/h).
    The system will automatically maintain the set speed until you tap the b\
rake pedal, 
accelerate, cancel or turn the system off. 
    To activate the cruise control, push the  ON/OFF switch on the steering wheel. The CRUISE 
indicator light in the instrument panel will illuminate.
    To set a cruising speed, accelerate the vehicle to the desired speed, pu\
sh  the SET – switch 
on the steering wheel and release. The CRUISE SET indicator light in the instrument panel 
will illuminate. Take your foot off the accelerator pedal. Your vehicle \
will maintain the  
set speed.
    To reset at a faster cruising speed, push and hold the  RES + switch on the steering wheel. 
When the vehicle attains the desired speed, release the switch.
    To reset at a slower cruising speed, push and hold the  SET – switch on the steering wheel. 
Release the switch when the vehicle slows to the desired speed.
    To cancel the preset speed, tap the brake pedal or push the  CANCEL switch on the  
steering wheel.
    To turn off cruise control, push the  ON/OFF switch on the steering wheel. The CRUISE 
indicator light and the CRUISE SET indicator light in the instrument panel will extinguish.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
USB (Universal Serial Bus) Connection Port/iPod® Interface
    The USB port  1 is located in the center console 
under the armrest.
    When a compatible USB memory device or iPod® is 
plugged into the USB port:
 
 
• 
 
A confirmation message appears. Select “Yes” 
if you prefer to use the device with Voice 
Recognition in which song titles and artist names are registered in the \
system.
 
 
• 
 
Compatible audio files stored on the device can be played through the ve\
hicle’s audio 
system and front display.
    If two USB devices are plugged in at the same time, you are able to use \
Voice Recognition 
to choose which one should play. Just press the 
 button on the steering wheel to activate 
Voice Recognition and follow the voice prompts.
     This vehicle is equipped with audio and video RCA inputs  2. This will allow you to play 
audio and video through your vehicle from an external source.
For more information, refer to the “Getting Started (section 2)”, the “Audio system (section 4)” and the “Voice recognition  
(section 10)” of your InTouch Owner’s Manual. 
 1 2
first drive features
1967179_16b_Q50_US_QRG_012916.indd   221/29/16   1:54 PM