sensor INFINITI Q50 2019 Quick Reference Guide

7
To use the door handles to lock and unlock
your vehicle, make sure the Intelligent Key is
with you (that is, in your pocket or purse).
• Touch the inside of
the door handle

to unlock the corresponding front door.
• Pushing the request switch while
touching the inside of the door handle
will unlock the rest of the doors.
• To lock the

vehicle, push either door
handle request switch
once.
Locking and Unlocking your Vehicle
via the Door HandleIllumination Controls
INSTRUMENT BRIGHTNESS CONTROLS
• Press

the + or – buttons
to change the brightness of
the vehicle information display and instrument panel.
CENTER DISPLAYS BRIGHTNESS CONTROL
To adjust the brightness of the center displays:
• For models with

Around View
® Monitor, press and hold
the CAMERA
button . Then, use the Infiniti
controller to change the brightness.
• For models without

Around View
® Monitor, press the
button, and use the Infiniti controller to change
the brightness.To change the settings for the door locking and
unlocking system, press the MENU button
, then touch the “Settings” key on the lower display
followed by the “Vehicle” key.
• To unlock all doors b

y touching the inside of the door handle, select
“Selective Door Unlock”.
• To disable unlocking by

touching the inside of the door handle, select “Touch
Sensitive Door Sensor”.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.Please see your Owner’s Manual for important safety information, system
limitations, and additional operating and feature information.

8
To turn the rain sensor function on and off:
1. Press the MENU
button below the lower display.
2. Touch the “Se

ttings” key and then the “Vehicle” key

on the display.
3. Touch the “R

ain Sensor” key
to toggle the
feature ON and OFF.
When the rain-sensing function is disabled, the AUTO
position on the wiper stalk will work in conventional
intermittent mode.
WIPER BLADE REPLACEMENT PROCEDURE
The windshield wipers must be in the service position in order
to replace the wiper blades. To move the wiper blades to the
service position:
• When the ignition switch is in the ON position or within
60 sec

onds of placing the ignition switch in the OFF
position, lift the windshield wiper and washer lever
upwards twice in less than 0.5 seconds. The windshield
wipers will move to the service position automatically, and
the wiper blades can now be replaced.
To move the wiper blades back to the original position:
• Place the wiper arm in the do

wn position and lift the wiper
and washer lever up for more than 1 second, or lower the
lever down to operate at any wiper speed.
Wiper and Washer Switch
Move the lever up or down to one of
the following positions to operate the
windshield wipers:
MIST
One sweep operation
OFF
Wipers are OFF
AUTO
Speed-sensing and
rain-sensing automatic wipe
LO
Continuous wipe,

slow
HI
Continuous wipe,

fast
To adjust the wiper sensitivity for the AUTO
setting, twist the control ring
.
Pull the lever
toward you to operate the
windshield washer.
Please see your Owner’s Manual for important safety information, system limitations, and additional operating and feature information.