brake INFINITI Q50 2020 Quick Reference Guide

8
Starting/Stopping the
EngineHomeLink® Universal Transceiver
(if so equipped)
HomeLink
It is important to make sure
the INFINITI Intelligent Key
is with you (that is, in your
pocket or purse).
1.


Depr
ess the brake pedal.
2.


Push the ignition swit
ch
START/STOP button to
the ON position.
TURNING THE ENGINE OFF
1.


M
ove the shift lever to the P (PARK) position
and apply the parking brake.
2.


Push the ignition swit
ch START/STOP button
to turn the engine off.
Please see your Owner’s Manual for important safety information,
system limitations, and additional operating and feature information.
To program the HomeLink® Universal Transceiver: 1.

P
osition the handheld transceiver 1-3 in (26-76 mm) away from the HomeLink
surface, keeping the HomeLink indicator light in view.
2.



Pr

ess and hold the desired HomeLink button and the handheld transmitter button
simultaneously until the HomeLink indicator light flashes slowly and then rapidly.
3

.

Bo

th buttons may be released when the indicator light flashes rapidly.
4.



Pr

ess and hold the programed HomeLink button and observe the indicator light.
A solid, continuous light indicates the programing is complete. If the indicator light
rapidly blinks for two seconds and then turns to a solid, continuous light, continue
with steps for a rolling code device.
5.



A

t the receiver located on the garage door opener motor, locate the “learn” or
“smart” button. If there is difficulty locating the button, reference the garage door
opener’s manual. Once the button is pressed, you have approximately 30 seconds to
initiate the next step.
6.



Pr

ess and hold the programed HomeLink button for two seconds and release. Repeat
the sequence up to three times to complete the programing process. HomeLink should
now activate your rolling code equipped device.
Please see your Owner’s Manual for important safety information, system limitations, and additional operating and
feature information.

21
SETTING A CRUISING SPEED
•

Push the cruise c
ontrol ON-OFF switch
to turn
on the system.
•


With the

vehicle at the desired speed, push down the
control switch
to SET to enable cruise control.
•


The cruising speed c

an be adjusted to a higher or lower
speed by toggling the control switch
up or down.
CANCELING THE PRESET SPEED
•


Push the CANCEL switch
or tap the brake pedal.
Please see your Owner’s Manual for important safety information, system
limitations, and additional operating and feature information.
Cruise Control (if so equipped)
The ICC system is designed to maintain a
selected distance from the vehicle in front
of you and reduce the speed to match a
slower vehicle ahead.
VEHICLE-TO-VEHICLE
DISTANCE CONTROL MODE
•


T
o turn on the vehicle-to-vehicle (ICC)
cruise control mode, quickly push and
release the MAIN switch
.
•


T

o increase the distance to the
vehicle ahead to be maintained by
the ICC system, push the distance
switch
until the display shows the
desired set distance, which is shown
by the number of lines on the set
distance indicator
.
•


When a

vehicle is detected
ahead, a vehicle ahead detection
indicator
will illuminate and your
vehicle will reduce the speed to match the slower vehicle.
CONVENTIONAL (FIXED SPEED) CRUISE CONTROL MODE
•


T

o turn on the conventional (fixed speed) cruise control mode, push and hold
the MAIN switch
for longer than about 1.5 seconds.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.
Intelligent Cruise Control
(if so equipped)