ignition INFINITI Q60 COUPE 2015 Quick Reference Guide

10
111213
15
16
17
18
19
20
212122
1
3456
2
*See your Owner’s Manual for information.
1 INSTRUMENT BRIGHTNESS CONTROL*
2 TRIP COMPUTER SWITCHES
3 HEADLIGHT AND TURN SIGNAL CONTROL
4 LOW TIRE PRESSURE WARNING LIGHT
5 VEHICLE INFORMATION DISPLAY
6 WINDSHIELD WIPER AND WASHER SWITCH
7 TRIP A/B RESET BUTTON*
8 STEERING WHEEL SWITCHES FOR
AUDIO*/BLUETOOTH®
9 CRUISE CONTROL
10 PUSH BUTTON IGNITION SWITCH
11 VEHICLE DYNAMIC CONTROL (VDC) OFF SWITCH*
12 TRUNK RELEASE SWITCH
13 REAR SONAR SYSTEM SWITCH*
14 TILT AND TELESCOPIC STEERING COLUMN*
15 INTELLIGENT KEY PORT
16 HOOD RELEASE*
17 CONTROL PANEL DISPLAY
18 AUDIO SYSTEM
19 AUTOMATIC CLIMATE CONTROLS
20 FRONT PASSENGER AIR BAG STATUS LIGHT*
21 CLIMATE CONTROLLED SEAT SWITCHES*
22 HARD TOP OPEN/CLOSE SWITCH
(CONVERTIBLE MODELS)
Behind
steering wheel Behind
steering wheel
Behind
steering wheel
89
7
Behind
steering wheel14
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 39/15/14 1:25 PM

6
INFINITI Intelligent Key System
The INFINITI Intelligent Key system allows you to lock or
unlock the vehicle, open the trunk and start the engine.
It is important to make sure the Intelligent Key is
with you (that is, in your pocket or purse).
The operating range of the Intelligent Key is within
31.5 in (80 cm) from each request switch.
To lock the vehicle, push either door handle request
switch
1 once or press the button 2 on the key fob.
To unlock the vehicle, perform one of the following procedures:



•

Push either door handle request switch

1 once; the
corresponding door will unlock. Push the door handle
request switch
1 again within 1 minute; all other doors
will unlock, or



•


Press the button 3 on the key fob to unlock the driver’s

side door. Press the
button again; all other doors will unlock.
To release the trunk lid, press the HOLD button 4 for more than
1 second. Lift the trunk lid to access the trunk.
To retract the hard top (Convertible models), push and hold the
door handle request switch

1 until the hard top is fully open.
The Intelligent Key can also be used to activate the panic alarm by pres\
sing and holding
the
button 5 for more than 1 second. Once activated, the panic alarm and headlights
will stay on for a period of time.
INFINITI INTELLIGENT KEY BATTERY DISCHARGE
If the battery in the Intelligent Key is almost
discharged, the guide light
6 of the Intelligent
Key port blinks and the Intelligent Key battery
discharge indicator
7 is displayed in the vehicle
information display.
To start the engine under these circumstances,
insert the Intelligent Key into the key port with the
buttons facing upward and the key ring end toward
you until it latches into place. Then push the
ignition switch to start the engine.
To remove the Intelligent Key from the port, push
the ignition switch to turn the engine off and then
pull the Intelligent Key out of the port.
The Intelligent Key port does not charge the Intelligent Key battery. If\
you see the low
battery indicator

7, replace the battery in the Intelligent Key.
Do not insert the mechanical key or any other objects into the key port \
because it will
damage the key port.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”, the “Starting and driving (section 5)” and
the “Maintenance and do-it-yourself (section 8)” of your Owner’s Manual.
1
first drive features
2
3
4
5
6
7
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 69/15/14 1:26 PM

8
first drive features
Seat Belt Guide (Convertible models)
Unsnap the seat belt guide 1 to allow rear seat



passengers easier access.
Before fastening the seat belt, make sure the seat
belt is inserted into the seat belt guide and the
snaps are securely fastened.
When using the seat belt guide, do not allow the
seat belt to twist so that it will retract correctly.
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)”\
of your
Owner’s Manual.
Automatic Drive Positioner (if so equipped)
Two positions for the driver’s seat, steering column and outside mirr\
ors can be stored in the
automatic drive positioner memory.
Follow this procedure to set the memory positions:



•

Confirm the shift lever is in the
P (PARK) position
(automatic transmission) or the parking brake is
applied (manual transmission).
•


Push the ignition switch to the
ON position.



•

Adjust the driver’s seat, steering column and outside mirrors to the \
desired positions using
the adjusting switches for each feature.



•

Push the
SET switch and within 5 seconds, push the memory switch (1 or 2) for at least 1 second.



•

The indicator light on the memory switch you select will illuminate for \
approximately 5 seconds.




•

The driver’s seat, steering column and outside mirror positions are n\
ow set to your preference.
These memorized positions can also be linked to your INFINITI Intelligen\
t Key. To link a
memorized position to your INFINITI Intelligent Key, press the UNLOCK button on the key fob
after completing the previous step.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Passenger Rear Seat Entry/Exit
For ease in entering and exiting the rear passenger
areas of the vehicle, perform the following steps:



1.

Release the front seat belt guide and seat belt

(Convertible models).



2.

Pull the seatback lever 1 upward to fold the
front seatback forward. Make sure that the front
seatback is completely folded.



3.


To slide the front seat forward, firmly push

the seatback button
2. The front seat will
move forward.Coupe
Convertible
1
12
21
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 89/15/14 1:26 PM

9
Outside Mirror Control Switch
To select the right or left side mirror, turn the control
switch
1 right or left.
To adjust the mirror angle, move the control switch

1 up, down, right or left.
To prevent accidentally moving the mirror, turn and
set the switch to the middle (neutral) position.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Starting/Stopping the Engine
AUTOMATIC TRANSMISSION (if so equipped)
It is important to make sure the INFINITI Intelligent
Key is with you (that is, in your pocket or purse).
Depress the brake pedal.



•

If the brake pedal is not depressed, pushing the

ignition switch once enters the ACC mode.



•

If the ignition switch is pushed a second time, the

vehicle will enter the ON mode.
Press the ignition switch
START/STOP button to start the engine.
MANUAL TRANSMISSION (if so equipped)
Depress the brake pedal.



•

If the brake pedal is not depressed, pushing the ignition switch once en\
ters the
ACC mode.



•

If the ignition switch is pushed a second time, the vehicle will enter t\
he
ON mode.
Depress the clutch pedal to the floor.
Move the shift lever to the N (NEUTRAL) position.
Press the ignition switch
START/STOP button.
TURNING THE ENGINE OFF
For an automatic transmission, move the shift lever to the P (PARK) position, apply the
parking brake and push the ignition switch.
For a manual transmission, depress the clutch pedal and the foot brake, \
place the vehicle in
1st gear, apply the parking brake and push the ignition switch.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
1
To stop the front seat from sliding, press the seatback button 2 again. To return the front seat to its original position:



1.

Push or pull the seatback backward until it locks in place.



2.

Press the seatback button 2 to slide the front seat backward.
For more information, refer to the “Safety — Seats, seat belts and supplemental restraint system (sectio\
n 1) ” of your
Owner’s Manual.
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 99/15/14 1:26 PM

10
first drive features
Headlight Control Switch
HEADLIGHT CONTROL
Turn the headlight control switch to the
position
1 to turn on the front parking, side
marker, tail, license plate and instrument panel
lights. Turn the switch to the position
2 to turn on
the headlights.
AUTOLIGHT SYSTEM
The autolight system will automatically turn the headlights on when it i\
s dark and off when
it is light. The system will keep the headlights on for a period of time\
after you turn the
ignition off and all the doors are closed.
To activate the autolight system, turn the headlight control switch to t\
he AUTO
position 3
then push the ignition switch to ON. To deactivate the autolight system, turn the headlight
control switch to the OFF,
position 1 or
position 2.
HIGH BEAM SELECT
Push the headlight control switch forward 4 to
select the high beam function. The blue indicator
light
illuminates in the instrument panel. Pull
the headlight switch back to the original position to
select the low beam. The blue indicator light
will extinguish.
Pull and release the headlight control switch 5 to
flash the headlight high beams on and off.
FOG LIGHT SWITCH
The headlights must be in the auto position or the
low beams
selected for the fog lights to operate.
Turn the switch (inside collar) to the
position 6
to turn the fog lights on.
Turn the switch (inside collar) to the
OFF position to turn the fog lights off.
LANE CHANGE SIGNAL
Move the lever up or down until the turn signal begins to flash but the \
lever does not latch
to signal a lane change. Hold the lever until the lane change is complet\
ed.
Move the lever up or down until the turn signal begins to flash but the \
leve r does not latch
and release the lever. The turn signal will automatically flash 3 times.\

Choose the appropriate method to signal a lane change based on the road and
traffic conditions.
For more information, refer to the “Instruments and controls (sectio\
n 2)” of your Owner’s Manual.
3
1
2
6
5
4
1811810_15b_Q60_G_Coupe_Convert_QRG_091514.indd 109/15/14 1:26 PM